2-3
2
●Always use proper procedures if you stall or roll
backwards when climbing a hill. To avoid stall-
ing, maintain a steady speed when climbing a
hill. If you stall or roll backwards, follow the spe-
cial procedure for braking described in this man-
ual. Dismount on the uphill side or to a side if
pointed straight uphill. Turn the ATV around and
remount, following the procedure described in
this manual.●Always check for obstacles before operating in a
new area.●Never attempt to operate over large obstacles,
such as large rocks or fallen trees. Always follow
proper procedures when operating over obsta-
cles as described in this manual.●Always be careful when skidding or sliding.
Learn to safely control skidding or sliding by
practicing at low speeds and on level, smooth
terrain. On extremely slippery surfaces, such as
ice, go slowly and be very cautious in order to re-
duce the chance of skidding or sliding out of con-
trol.●Never operate an ATV in fast flowing water or in
water deeper than that recommended in this
manual. Remember that wet brakes may havereduced stopping ability. Test your brakes after
leaving water. If necessary, apply them several
times to let friction dry out the linings.
●Always be sure there are no obstacles or people
behind you when you operate in reverse. When
it is safe to proceed in reverse, go slowly.●Always use the size and type of tires specified in
this manual.●Always maintain proper tire pressure as de-
scribed in this manual.●Never exceed the stated load capacity for an
ATV. Cargo should be properly distributed and
securely attached. Reduce speed and follow in-
structions in this manual for carrying cargo. Al-
low greater distance for braking.●Do not operate your ATV during darkness un-
less it is equipped with a properly functioning
headlight. Off-road riding is inherently danger-
ous and additionally, off-road trails do not have
streetlights to guide you.●Never maintain an ATV without proper knowl-
edge. Contact an authorized ATV dealer to in-
form you on basic ATV maintenance. Certain
maintenance can only be carried out by certified
staff.
U1PY61E0.book Page 3 Wednesday, March 14, 2012 5:22 PM
10-3
10
Reverse gear:49/14 × 49/15 × 40/17 (26.902)Chassis:Frame type:
Steel tube frame
Caster angle: 6.0 °
Trail: 15.0 mm (0.59 in)Front tire:Type:Tubeless
Size: AT20 x 7-8
Manufacturer/model:
DURO/DI-K635ARear tire:Type:Tubeless
Size:
AT22 x 10-8
Manufacturer/model: DURO/DI-K735ALoading:Maximum loading limit:
105.0 kg (231 lb)
(Total weight of rider, cargo, accessories, and tongue)Tire air pressure (measured on cold tires):Recommended:Front:
20.0 kPa (0.200 kgf/cm², 2.9 psi) Rear:
25.0 kPa (0.250 kgf/cm², 3.6 psi)
Minimum: Front: 17.0 kPa (0.170 kgf/cm², 2.5 psi)
Rear: 22.0 kPa (0.220 kgf/cm², 3.2 psi)
Front wheel:Wheel type:Panel wheel
Rim size: 8 x 5.5ATRear wheel:Wheel type:Panel wheel
Rim size: 8 x 8.0ATFront brake:Type:Drum brake
Operation: Right hand operationRear brake:Type:Drum brake
Operation: Left hand operationFront suspension:Type:Swing axle
U1PY61E0.book Page 3 Wednesday, March 14, 2012 5:22 PM
