2013 TOYOTA PRIUS PLUS Owners Manual

537 6-1. Specifications
6
Vehicle specifications
PRIUS +_OM_OM47841E_(EE)
Electric motor (Traction motor)
Hybrid battery (traction battery)
Lubrication system
*: The engine oil capacity is a reference quantity to be used when changing the
engine oil. Warm up the engine and turn off the hybrid system, wait more
than 5 minutes, and check the oil level on the dipstick.
Ty p ePermanent magnet motor
Maximum output 60 kW
Maximum torque 207 N•m (21.1 kgf•m, 153 ft•lbf)
Ty p eLithium-ion battery
Voltage 3.6 V/cell
Capacity 5 Ah
Quantity 56 cells
Overall voltage 201.6
Oil capacity
(Drain and refill 
reference
*)
With filter
Without filter
4.2 L (4.4 qt., 3.7 Imp.qt.)
3.9 L (4.1 qt., 3.4 Imp.qt.)

538 6-1. Specifications
PRIUS +_OM_OM47841E_(EE)Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Toyota
recommends the use of approved “Toyota Genuine Motor Oil”.
Another motor oil of matching quality can also be used.
Oil grade:
0W-20, 5W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil

539 6-1. Specifications
6
Vehicle specifications
PRIUS +_OM_OM47841E_(EE)Recommended viscosity (SAE):
SAE 0W-20 is filled into your
Toyota vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used.
However, it should be replaced
with SAE 0W-20 at the next oil
change.
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 0W-20, 5W-20 or
5W-30 engine oil is recom-
mended.
Temperature range anticipated before
next oil change
Preferred

540 6-1. Specifications
PRIUS +_OM_OM47841E_(EE)
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when
the oil is at high temperature. An oil with a higher viscosity (one with a
higher value) may be better suited if the vehicle is operated at high
speeds, or under extreme load conditions.
How to read oil container labels:
Either or both API registered marks are added to some oil containers
to help you select the proper oil you should use.
API Service Symbol
Top portion: “API SERVICE SN”
means the oil quality designation
by American Petroleum Institute
(API).
Center portion: “SAE 0W-20”
means the SAE viscosity grade.
Lower portion: “Resource-Con-
serving” means that the oil has
fuel-saving and environmental
protection capabilities.
ILSAC Certification Mark
The International Lubricant Speci-
fication Advisory Committee
(ILSAC) Certification Mark is dis-
played on the front of the con-
tainer.

541 6-1. Specifications
6
Vehicle specifications
PRIUS +_OM_OM47841E_(EE)
Cooling system
Ignition system
Capacity
Gasoline
engine
Without an exhaust heat recovery system
6.5 L (6.9 qt., 5.7 Imp.qt.)
With an exhaust heat recovery system
6.9 L (7.3 qt., 6.1 Imp.qt.)
Power
control
unit2.7 L (2.9 qt., 2.4 Imp.qt.)
Coolant typeUse either of the following:
• “Toyota Super Long Life Coolant”
• Similar high-quality ethylene glycol-based non-
silicate, non-amine, non-nitrite, and non-borate
coolant with long-life hybrid organic acid technol-
ogy
Do not use plain water alone.
Spark plug
Make DENSO SC20HR11
Gap 1.1 mm (0.043 in.)
NOTICE
Iridium-tipped spark plugs
Use only iridium-tipped spark plugs. Do not adjust the spark plug gap.

542 6-1. Specifications
PRIUS +_OM_OM47841E_(EE)
Electrical system
*1: Voltage is checked 30 seconds after the hybrid system and all lights are
turned off.
Transmission
*2: The fluid capacity is the quantity of reference.
If replacement is necessary, contact any authorized Toyota dealer or
repairer, or another duly qualified and equipped professional.
12-volt battery
Open voltage
*1
at 20C (68F):
Fully charged12.5 V or over
Half charged 11.0  12.5 V
Discharged Under 11.0 V
Charging rates
Vehicles without alarm
and a navigation system4 A max.
Vehicles with alarm or a
navigation system5 A max.
Fluid capacity*23.4 L (3.6 qt., 3.0 Imp.qt.)
Fluid type Toyota Genuine ATF WS
NOTICE
Transmission fluid type
Using transmission fluid other than “Toyota Genuine ATF WS” may cause
deterioration in shift quality, locking up of your transmission accompanied by
vibration, and ultimately damage the transmission of your vehicle.

543 6-1. Specifications
6
Vehicle specifications
PRIUS +_OM_OM47841E_(EE)
Brakes
*1: Minimum pedal clearance when depressed with a force of 196 N (20.0 kgf,
44.1 lbf) while the hybrid system is operating.
*2: Parking brake pedal travel when depressed with a force of 300 N (30.6 kgf,
67.5 lbf).
Steering
Pedal clearance*1
Left-hand drive vehicles
75 mm (2.95 in.)
Right-hand drive vehicles
79 mm (3.11 in.)
Pedal free play 1.0  6.0 mm (0.04  0.24 in.)
Parking brake pedal travel*28 11 clicks
Fluid type SAE J1703 or FMVSS No. 116 DOT 3
Free playLess than 30 mm (1.2 in.)

544 6-1. Specifications
PRIUS +_OM_OM47841E_(EE)
Tires and wheels
Ty p e A
Ty p e B
Compact spare tire (if equipped)
Tire size205/60R16 92V
Tire inflation pressure
(Recommended cold tire infla-
tion pressure)Except eco package
Front tire
240 kPa (2.4 kgf/cm
2 or bar, 35 psi)
Rear tire
230 kPa (2.3 kgf/cm
2 or bar, 33psi)
Eco package
Front tire
250 kPa (2.5 kgf/cm
2 or bar, 36 psi)
Rear tire
240 kPa (2.4 kgf/cm
2 or bar, 35 psi)
Wheel size 16  6 1/2J
Wheel nut torque 103 N•m (10.5 kgf•m, 76 ft•lbf)
Tire size215/50R17 91V
Tire inflation pressure
(Recommended cold tire
inflation pressure)230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Wheel size 17  7J
Wheel nut torque 103 N•m (10.5 kgf•m, 76 ft•lbf)
Tire sizeT135/70D17 102M
Spare tire inflation pressure
(Recommended cold tire infla-
tion pressure)420 kPa (4.2 kgf/cm2 or bar, 60 psi)
Wheel size 17  4T
Wheel nut torque 103 N•m (10.5 kgf•m, 76 ft•lbf)