2013 SSANGYONG KORANDO ignition

Seat belt reminder operation
A
BIf the seat belt is fastened after the seat belt reminder is activated, the output of the reminder is
turned OFF immediately. The reminder will be operated again whenever the seat belt is
unbuckled.
CWhen the seat belt reminder is activated initially with the seat belt unbuckled, the internal buzzer
(chime) is turned ON for 0.02 seconds and then turned OFF for 1.18 seconds (this cycle
continues for 5 minutes) and the driver seat belt warning lamp on the instrument cluster remains
on.
DWhen the seat belt reminder is activated with the seat belt unbuckled, the internal buzzer (chime)
is turned ON for 0.02 seconds and then turned OFF for 1.18 seconds (this cycle continues for 5
minutes) and the passenger seat belt warning lamp on the instrument cluster remains on, after
detecting that the passenger seat is occupied through the input value of the passenger seat
occupancy sensor.
EWhen the vehicle speed is changed while the seat belt reminder is turned on, the internal buzzer
(chime) is operated as follows:
FPriority of internal buzzer (chime) operation
(Seat belt reminder > ignition key reminder > sunroof warning > tail lamp warning > hazard
warning flasher on > turn signal indicator)GEN
The seat belt reminder is operated when the
vehicle is driven at 25 km/h or more with IGN
ON and alternator in High status (engine
running), and driver seat belt is not fastened. If
the vehicle speed is decreased to less than 25
km/h within 5 minutes after the seat belt
reminder is activated, the internal buzzer
(chime) is turned off. If the vehicle speed is
increased to 25 km/h or more, the buzzer
signal is output for 5 minutes. Only EU If the driver and passenger seat belts are not
fastened with the ignition switch ON, engine
running, vehicle speed above 10 km/h and
any passenger occupied, the seat belt
reminder is activated. In addition, even though
the vehicle speed reduces to below 10 km/h
after the reminder is activated at speed of 10
km/h or higher, it will remain activated.
Vehicle speedFunction
Remarks
Interior buzzerInstrument
cluster
25 Km/h to 49 Km/h
(10km/h~49km/h)0.02 sec. ON / 1.18 sec. OFF Remains on (Only EU)
50 Km/h to 99 Km/h 0.02 sec. ON / 0.98 sec. OFF Remains on
100 km/h or more 0.02 sec. ON / 0.78 sec. OFF Remains on

The driver door is opened with the sunroof open and IGN OFF and ACC ON (ignition key
removed).
The internal buzzer (chime) sounds for 10 seconds (T1). A.
B. Operation 1.
The driver door and sunroof is closed while the internal buzzer (chime) is activated.
The internal buzzer (chime) is deactivated.
(The internal (chime) buzzer is not activated again after the operation 1, and it is activated again when
the operation 1 is performed after the ignition is turned ON) C.
D. Operation 2.
9. SUNROOF WARNING LAMP CONTROL
The sunroof open warning (T2) overrides the tail lamp ON warning (T3). E. Operation 3.

8710-01
Operating process
- IGN OFF (ignition key removed)

Door is opened with IGN OFF.
The key hole lamp comes on.
The key hole lamp comes on for 10 seconds (T1) when the door is closed. A.
B.
C. Operation 1.
The ignition is turned ON with the key hole lamp ON.
The key hole lamp goes out. D.
E. Operation 2.
10. KEY HOLE LAMP CONTROL
The key hole lamp goes out when the REKES LOCK signal is received (in theft deterrent
mode).
When the key hole lamp and immobilizer signals are received simultaneously, the immobilizer signal
overrides the key hole lamp signal.
When the immobilizer confirmation is failed, regardless of the key hole lamp operation condition, it
flashes for 11 seconds at intervals of 0.5 sec. ON/0.5 sec. OFF.
When the ignition is turned ON in virgin status, the key hole lamp flashes for 8 seconds at intervals
of 0.5 sec. ON/0.5 sec. OFF. -
-
-
-

Front defogger (heated wire) timer control
The front defogger (heated wire) switch is turned ON.
The front defogger (heated wire) is activated for 12 minutes (T1). A.
B. Operation 1.
Turning on the front defogger (heated wire) switch again when the defogger is activated turns off the
fog lamp output. C. Operation 2.
Within 10 minutes (T2) after the output of the front defogger (heated wire) for 12 minutes (T1).
When the front defogger (heated wire) switch is turned ON, the front defogger is activated for only 6
minutes (T3).
(This operation is not available when the front defogger is turned off by turning off engine, IGN OFF, or
front defogger (heated wire) switch). D.
E. Operation 3.
If the engine is running at low speed with IGN OFF or IGN ON, the front defogger (heated wire) is
deactivated. F. Operation 4.
The front defogger is turned OFF when the ignition is turned OFF or engine is not running.
11. DEFOGGER (HEATED WIRE) TIMER CONTROL

8710-01
Rear defogger (heated wire) timer control
The rear defogger (heated wire) switch is turned ON.
The rear defogger (heated wire) is activated for 12 minutes (T1). A.
B. Operation 1.
Turning on the rear defogger (heated wire) switch again when the defogger is activated turns off the
fog lamp output. C. Operation 2.
Within 10 minutes (T2) after the output of the rear defogger (heated wire) for 12 minutes (T1).
When the rear defogger (heated wire) switch is turned ON, the front defogger is activated for only 6
minutes (T3).
(This operation is not available when the rear defogger is turned off by turning off engine, IGN OFF, or
front defogger (heated wire) switch) D.
E. Operation 3.
If the engine is running at low speed with IGN OFF or IGN ON, the rear defogger (heated wire) is
deactivated. F. Operation 4.
The rear defogger is turned OFF when the ignition is turned OFF or engine is not running.

Door coupled room lamp control
When all doors are closed with IGN ON, the room lamp goes out immediately. A. Operation 1.
All doors are closed with IGN OFF.
The room lamp stays on for 2 seconds (T1) and then fades out over 3 seconds (T2) and goes off.
- When the ignition is turned ON while the room lamp is fading out, the lamp goes out immediately. B.
C. Operation 2.
When UNLOCK signal by the smart key (REKES key) is received with IGN OFF (ignition key
removed) and all doors closed, the room lamp remains ON for 30 seconds (T3).
When UNLOCK signal is received again while the room lamp is ON, the lamp stays on for 30
seconds more. The room lamp lighting is extended when UNLOCK signal by the REKES key is
received. D.
E. Operation 3.
The room lamp stays on when a door is opened during fading out.
The lamp goes out or fades out when the door is closed. F. Operation 4.
12. ROOM LAMP CONTROL
When the room lamp switch is in the door coupled position and the driver/passenger/rear door is
opened, the room lamp comes on.
The room lamp goes out automatically after 10 minutes of illumination when the ignition is turned OFF
(ignition key is removed) and a door is open.
The sleep mode is deactivated when the door status is changed or UNLOCK signal is received after
automatic switching off. -
-
-
When the open driver/passenger/rear door is closed, the room lamp fades out. When the system
enters the theft deterrent mode, the room lamp goes out immediately.
In puddle lamp coupled room lamp mode, the room lamp comes on when the puddle lamp
operation signal is received. -
-

Room lamp cut off control
The lamp is turned off when entering sleep mode or in alarming status. A. Operation 1.
When the ignition is turned OFF (ignition key removed) with the room lamp switch ON, the room
lamp comes on for 10 minutes and then goes out automatically.
When the room lamp is turned off automatically, the room lamp automatic switching off signal is sent
to the instrument cluster before entering sleep mode. B.
C. Operation 2. (preventing battery discharge)
When the ACC is turned ON or ignition is turned ON with the ignition key inserted, the room lamp is
activated. D. Operation 3.
When the room lamp cut off operation is activated, the BCM sends cut off operation signal to the
instrument cluster through B-CAN to prevent the battery discharge. -