2013 SSANGYONG KORANDO roof

Hazard warning lamp switch control
The hazard warning lamp switch is turned ON with IGN ON or OFF.
The hazard warning lamp flashes 75 times per minute (T1), and the internal buzzer sounds at
intervals of 0.4 sec. ON/0.4 sec. OFF.
The hazard warning lamp and internal buzzer are deactivated when the hazard warning lamp switch
is turned OFF. A.
B.
C. Operation 1.
Operation 1. Abnormal current (less than 3 A or more than 7 A) detection signal is input while the
lamp is ON.
The hazard warning lamp flashes 100 times per minute (T2), and the internal buzzer sounds at
intervals of 0.3 sec. ON/0.3 sec. OFF. D.
E. Operation 2.
Hazard warning lamp functions at B+ or more.
The allowed time difference between the LH and RH turn signal lamp operations is within 0.1
seconds.
The hazard warning lamp overrides the turn signal lamp.
Priority of internal buzzer (chime) operation while the hazard warning lamp is ON
(Seat belt reminder > Ignition key reminder > Sunroof open > Tail lamp ON > Hazard warning lamp
> Turn signal lamp) -
-
-
-

Pin No.Message
Operating condition
Domestic Export
Cruise control This message comes on when the ECO cruise mode
is deactivated.
EMSThis message comes on when the engine is faulty.
LampThis message comes on when the tail lamps are ON
with the ignition in the "OFF" or "ACC" position.
SUNROOF
SYSTEMFor the vehicle with SKM, this message comes on
when the sunroof is open with the ignition in the "OFF"
or "ACC" position. For the vehicle without SKM, this
comes on when the sunroof is open with the ignition in
the "OFF" position and the key removed.
Low fuel level This message comes on when the remaining fuel is
insufficient.
ESP checkThis message comes on when the ESP system is
faulty.
ABS check This message comes on when the ABS system is
faulty.
Engine oil level
checkLCD display shows this message when the engine oil
level is low. Have the system checked at Ssangyong
Authorized Service Center.Pin No. Message Operating condition
Auto cruiseLCD display shows this message when turning on the
cruise control switch with ignition ON or engine
running. This message disappears when activating the
cruise control lever.

8510-00
Overhead console switch
6. OVERHEAD CONSOLE SWITCH
The front room lamp is controlled by the BCM.
The front room lamp comes on when opening the driver or passenger door. (door coupled operation
switch ON)
When closing the driver or passenger door, the front room lamp comes on for 2 seconds and then
dims down for 3 seconds. (door coupled operation switch ON)
The front room lamp turns on/off depending on the operation of the front room lamp ON/OFF switch
(spot switch). -
-
-
-
Front room lamp switch
Door coupled operation switch
Sunroof switch
Front room lamp connector
Sunroof connector

Front room lamp switch
The driver/passenger room lamps turns on
when pressing in these switches.Door coupled operation switch
The front room lamp and center room
lamp come on when opening a door with
this switch pressed in.
Sunroof switch
Push up the switch briefly: 2-step auto sliding open
Push up and hold the switch: manual sliding open
When pushing up the switch briefly, the sunroof is automatically opened. Opening is carried out
in 2 steps. In first step, the area 5 cm behind the sunroof is not opened. Push up the switch once
again in order to open the sunroof completely. The sunroof operation stops if you operate the
switch during its operation.
The sunroof is opened as long as pushing up the switch.
Pull down the switch briefly: auto sliding close
Pull down and hold the switch: manual sliding close
When pulling down the switch briefly, the sunroof is automatically closed. To stop the closing
sunroof, operate the switch to either direction.
The sunroof is closed as long as pulling down the switch.

Sunroof warning control
When removing the ignition key with the sunroof open (without SKM) or when opening the driver door
with IGN OFF or ACC and sunroof open (with SKM), the indoor buzzer sounds for 10 seconds with
the interval of 0.02s ON/1.58s OFF.
When opening and closing the driver door or closing the sunroof during indoor buzzer operation, the
buzzer stops its operation immediately.
When closing the driver door or sunroof and opening again during warning operation, the sunroof
warning does not work. If the condition is met after the ignition switch is turned to "ON" position again,
the indoor buzzer sounds for 10 seconds with the interval of 0.02s ON/1.58s OFF.
The sunroof warning has a priority over the tail lamp ON warning. 1.
2.
3.
4.

(2) Side air bag system deployment
The side air bag system is activated in the event of a left side or right side collision. The seat side air bags
are installed to the driver and passenger seat (one on each seat) and the curtain air bags are installed in
the end of the roof located on the upper sides of both doors. The side air bags and the curtain air bags are
operated by the same signal. The air bags of the driver seat and passenger seat are operated separately
according to the impact position (left side, right side).
ItemImpact to (side)
LH RH
Side air bag - Driver side Ignite Not ignite
Side air bag - Passenger side Not ignite Ignite
Curtain air bag - Driver side Ignite Not ignite
Curtain air bag - Passenger side Not ignite Ignite
Seat belt pretensioner - Driver side Not ignite Not ignite
Seat belt pretensioner - Passenger side Not ignite Not ignite
(3) Component change after deployment
Side air bag deployed
Deployed side air bag, air bag unit and its wirings (including connectors), side impact sensor, other
damaged trim, seat components
Curtain air bag deployed
Deployed curtain air bag, air bag unit and its wirings (including connectors), side impact sensor,
damaged trim, seat and roof headlining

7340-01
1. SPECIFICATIONS
2. CAUTIONS
Operating voltage 9 ~ 16V
Operating current (open & close) Max. 6 A
At no load Approx. 3 A
Leakage current Max. 1 mA or less
Roof motor operating speed
(at opening and closing)
Motor overload stop conditionsCurrent for 25 A or higher and torque (load) for 7.5
Nm or above
2-step opening amount
Vertical/horizontal tolerance for sunroof glass
panel
Cautions during work
Wear a clean work clothes and gloves.
Any unauthorized modification or operational test is not allowed since the sunroof motor and
control unit are preset at the factory.
Take care not to drop or stack vertically when removing the sunroof. This may cause the moving
parts to be damaged. -
-
-

OPEN
Sunroof switch
1. SYSTEM LAYOUT
Sunroof assembly
TILT
Sunroof motor &
control unit