2013 Peugeot 508 open bonnet

.
.
Contents
Child seats 153
ISOFIX child seats 160
Child lock 164
Child safety
Direction indicators 165
Emergency or assistance call 166
Horn 166
Tyre under-infl ation detection 167
ESC system 168
Seat belts 171
Airbags 174
Safety
Te m p o r a ry puncture repair kit 178
Changing a wheel 184
Changing a bulb 191
Changing a fuse 200
12 V battery 204
Energy economy mode 207
Changing a wiper blade 208
To w i ng the vehicle 209
To w i ng a trailer 211
Fitting roof bars 213
Accessories 214
Practical information
Opening the bonnet 217
Running out of fuel (Diesel) 218
Petrol engines 219
Diesel engines 220
Checking levels 222
Checks 225
Checks
Petrol engines 227
Petrol weights 228
Diesel engines 230
Diesel weights 233
Dimensions 236
Identifi cation markings 237
Technical data
Emergency or assistance 239
JBL equipment 241
Peugeot Connect Navigation (RT6) 243
Audio system 297
Audio equipment and telematics
Alphabetical index
Visual search

2
53
Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:





Alarm


- Exterior perimeter

The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...




- Interior volumetric

The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
- Tilt
The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.


Self-protection function
The system checks for the putting out of ser vice of its components. The alarm is triggered if the battery, thecentral control unit or the wires of thesiren are put out of service or damaged.
For all work on the alarm system, contact a PEUGEOT dealer or aqualified workshop.
Locking the vehicle with full
alarm system
Activation
FSwitch off the ignition and get out of the vehicle.
F
Press the locking button on the
remote control or lock the vehicle
using the Keyless Entry and Starting system. The monitorin
g system is active: the indicator
lamp on the button flashes once per second.

After the locking button on the remote control is pressed or the vehicle locked using the
Ke
yless Entry and Starting system, the exterior
perimeter monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring
after 45 seconds and anti-tilt monitoring after 90 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds.
F Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entryand Star ting system.

Deactivation of the volumetric monitoring

The volumetric protection system is
deactivated: the indicator lamp in the
button goes off.

204
Practical information











12 V battery
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery.

After refitting the battery, the Stop & Start system will only be active after several hours depending on the climaticconditions and the state of charge of the battery (up to about 8 hours).
The battery is located under the bonnet.
To gain access to it:
F
open the bonnet using the interior releaselever, then the exterior safety catch, F
remove the plastic cover to gain access to
the two terminals,F unclip the fusebox to remove the battery, if necessary.



Access to the battery
F
Raise the locking tab Dfully to release the cable terminal clamp E.



Disconnecting the (+) cable

Reconnectin
g the (+) cable
F
Position the open clamp Eof the cable on
the positive post (+) of the battery.
F Press ver tically on the clamp E
to position
it correctly on the battery. F Lock the clamp by spreading the positioning lug and then lowering the tab D.

Do not apply excessive force on the
tab as locking will not be possible if the clamp is not positioned correctly; star tthe procedure again.

9
217
Checks
Opening the bonnet
Opening
FFrom inside: pull the release lever, located
on the left below the dashboard, towards you.
Before doing anything under the bonnet,switch off the Stop & Start system toavoid any risk of injury resulting from anautomatic change to STA R T m o d e .

Closing
F
Lower the bonnet and release it at the endof its travel. F
Check that it is latched correctly.


FFrom the outside: lift the safety catch and
raise the bonnet.
A bonnet strut opens the bonnet and holds itopen.

218
Checks
On vehicle fitted with HDi engines, the fuelsystem must be primed if you run out of fuel; refer to the corresponding engine compar tment
view.











Running out of fuel (Diesel)


If the tank on your vehicle is fitted witha misfuel prevention device, refer to the "Misfuel prevention (Diesel)" section.
F
Fill the fuel tank with at least five litres of diesel. F
Open the bonnet.F
If necessary, unclip the styling cover for
access to the priming pump. F Squeeze and release the priming pump
repeatedly until resistance is felt (there may
be resistance at the first press). F Operate the star ter until the engine starts(if the engine does not star t at the first
attempt, wait around 15 seconds before
trying again).
F If the engine does not star t after a few
attempts, operate the priming pump again
then start the engine. F Clip the styling cover back in place. F
Close the bonnet.



1.6 litre HDi engine
F
Fill the fuel tank with at least five litres of
Diesel.F Open the bonnet. F
If necessary, unclip the style cover for access to the priming pump. F
Squeeze and release the priming pump repeatedly until fuel appears in the
transparent pipe. F Operate the star ter until the engine star ts (if the engine does not star t at the first attempt, wait around 15 seconds before
trying again).
F If the engine does not star t after a few attempts, operate the priming pump again
then start the engine. F Put the style cover back in position and clip it in place.F
Close the bonnet.
2 litre and 2.2 litre HDi
engines


If the engine does not star t first time, don't keep trying. Star t the procedureagain from the beginning.

334
Visual search
Instruments and controls
Quad-zone rear air conditioning 96-97
Opening the bonnet 217
Peugeot Connect USB 79
Door mirrors 74-75 Electric windows, deactivating 55-56

Courtesy lamps 151 Seat belt / passenger's front airbag warning lamps display 172, 175 Rear view mirror 76 Sunroof 61-62 SW panoramic sunroof 63
Fuses behind the glove box 200 -201
Manual parking brake 110
Heating, ventilation 86 - 87 Manual air conditioning 88-89 Dual-zone air conditioning 90-92 Quad-zone frontair conditioning 93-95 Demisting / defrosting 98

Peugeot Connect Navigation (RT6) 243-296 Setting the date/time 42


Audio system 297-325 Setting the date/time 41
Electric parking brake 103 -109
5/6 -speed manual ge a r b o x 111 Gear efficiency indicator 112 Automatic gearbox 113-116 Electronic gear controlgearbox 117-120 Stop & Star t 121-123 Hill start assist 124, 108
Dashboard fuses 202

336
Visual search
Maintenance - Technical data
Identification markings 237 Dimensions 236

Running out of fuel, Diesel 218
Checking levels 222-224 - oil - brake fluid - power steering fluid- coolant - screenwash/headlamp wash fluid Checking components 225 -226 - air filter - passenger compartment filter - oil filter - electric parking brake- brake pads / discs

Changing bulbs 191-199 - front - rear


12V bat tery 204-206 Load reduction, economy mode 206, 207 Engine compar tment fuses 200, 203


Opening the bonnet 217
Under the bonnet, petrol 219
Under the bonnet, Diesel 220-221
Petrol engines 227
Diesel engines 230-232
Petrol weights 228-229 Diesel weights 233-235