OuTSIDe MIrrOr CONTrOL SwIT CH
The outside mirror control switch is located on the
left side of the instrument panel.
To select the left or right mirror, move the switch
01 .
Adjust each mirror to the desired position using
the switch
02 .
To prevent accidentally moving the mirror, move this
switch
01 to the center “neutral” position.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
6
first drive features
FOLDING DOWN THE REAR BENcH SEAT
To fold the seats flat, secure the seat belts on
the seat belt hooks on the side wall. Release the
connector tongue of the rear center seat belt from
the buckle, then store the connector and seat belt
tongues on the seat belt hook.
Before folding down the seatback, tuck the seat belt
buckles into the seat cushion poc
kets.
Fold the seatback down by pulling the adjusting strap 01 .
To raise the seatback, lift up each seatback and push it to the upright position until it is latched.
After raising the seatback, pull the seat belt buc
kles out of the seat cushion pockets until they
are fully extended before using the seat belts.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
01
02
01
STarTING/STOPPING THe eNGINe
CONTINuOuSLY VarIaB Le TraN SMISSION
(NISS
aN Intelligent K
ey® models only - if so equipped)
Depress the brake pedal.
Move the shift lever to the P (ParK) position.
Push the ignition switch to start the engine.
NOTE: It is important to make sure the Intelligent
key is
with you (that is, in your poc
ket or purse).
TURNING THE ENGINE OFF
Move the shift lever to the P (ParK) position, apply
the parking brake and push the ignition switch.
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
1221378_13a_Cube_QRG_092112.indd 1010/2/12 9:26 AM
HeaDLIGHT CONTrOL SwITCH
HEADLIGHT
cONTR
OL
Turn the headlight control switch to the
position
01 to turn on the front parking, side marker, tail, license plate and instrument panel lights. Turn the switc
h to the
position
02 to turn on the headlights.
A UTOLIGHT SYSTEM (if so equipped)
The autolight system will automatically turn the headlights on when it is\
dark and off when it is
light. The system will keep the headlights on for a period of time after you tur\
n the ignition off
and all doors are closed.
To activate the autolight system, turn the headlight control switch to the auTO position
03
th
en push the ignition switch to ON. To deactivate the autolight system, turn the headlight
control switch to the
OFF,
01 or
position
02 .
HIGH BEAM SELE
cT
Push the headlight control switch forward
04 to
select the high beam function. The blue indicator
light
illuminates in the instrument panel. Pull the
headlight switch back to the original position to select
the low beam. The blue indicator light goes off.
Pull and release the headlight control switch 05 to flash the headlight high beams on and off.
7
MaNuaL TraNSMISSION (if so equipped)
Depress the brake pedal.
Move the shift lever to the N (Neutral) position .
Depress the clutch pedal to the floor.
Turn the ignition switch to start the engine.
T
URNING THE ENGINE OFF
Apply the foot brake and place the vehicle in first gear,
then apply the parking brake and turn the ignition
switch to
OFF.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
03
01
02
04
05
1221378_13a_Cube_QRG_092112.indd 1110/2/12 9:26 AM
