2013 MAZDA MODEL CX-5 engine

4
Read me first
Switching on and off
Your Navigation Device switches on when your car starts and switches off automatically when
you turn off your car's engine.
Until a connection has been established between the Audio control unit and the Navigation
Device, the screen shows audio-related information and the Nav button on the main display is
inactive. In the case of restart of the navigation device, press the Nav button. A Mazda/
TomTom screen is shown and it may take up to 30 seconds for the main screen to appear.
Under extreme temperature conditions, the navigation device may not star t. When the
temperature is within the normal range again, the device should star t, if the device fails to
star t automatically in this situation, stop your car engine and star t the car engine again.
Setting up
Important: Take care to select the correct language as the language you choose will be used
for all text on the screen.
When you first switch on your device, you have to answer a few questions to set up the
device. Answer the questions by tapping the screen.
GPS reception
When you first star t your Navigation Device navigation device, the device may need a few
minutes to determine your GPS position and show your current position on the map. In future,
your position will be found much faster, usually within a few seconds.
In areas where GPS reception is not possible, such as tunnels, your location may not be
accurate.
Important: The GPS antenna is located in the dashboard so do not put objects on the
dashboard.
Note: In some situations, your navigation system may restart when turning your key in the
ignition from ACC-ON to the engine start position. If this happens, it may take up to 30
seconds for the main screen to appear on the navigation system.

5
Device not starting
In rare cases, your TomTom navigation module may not star t correctly or may stop
responding to your taps. For example, if the device temperature is too high or too low, the
system shuts down.
In rare circumstances, you may need to reset your navigation device. To reset your device,
switch off the car engine and then remove the MAP SD card. Re-insert the MAP SD card and
switch the car engine on again.
Take care of your device
It is important to take care of your device as follows:
Your device is not designed for use in extreme temperatures and any such exposure may
cause permanent damage.
Do not open the casing of your device under any circumstances. Doing so may be dangerous
and will invalidate the warranty.
Important: If you sell your car, you should remove all personal information from your
navigation device first. To remove your personal information, tap Settings and then tap Reset
factory settings.
Reference
Refer to online manual for full operations.
URL :http://download.tomtom.com/open/manuals/Mazda_Navigation_System_NB1/
manual.htm
Depending on the region in which the system is used, there may be differences in the
functions/displayed specifications which can be used.

42
Updating your device with the new application
After the new application version has been put onto the MAP SD-card, you need to update
your navigation device. Do the following:
1. Insert the SD-card into the navigation device and close the door.
2. Turn the ignition key to the accessory setting.
The radio comes on but the engine is not star ted.
3. After approximately 10 seconds, press the NAVI button to see the navigation screen.
The following screen should be shown:

After about 1 minute the screen changes to the following screen. After the given time the
update star ts automatically.
Tip: Do not use force to inser t the SD-card. Make sure that the SD-card label is visible
when inserting the card.