2013 Lancia Flavia hood open

 UCONNECT™ PHONE . . . . . . . . . . . . . . . . . . . . . .67 COMPATIBLE PHONES . . . . . . . . . . . . . . . . . . .68
 OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . .68
 PHONE CALL FEATURES . . . . . . . . . . . . . . . . .73
 UCONNECT™ PHONE FEATURES . . . . . . . . . . .74
 ADVANCED PHONE CONNECTIVITY . . . . . . . . .77
 Things You Should Know About YourUconnect™ Phone . . . . . . . . . . . . . . . . . . . . . . .78
 VOICE COMMAND . . . . . . . . . . . . . . . . . . . . . . . . .85
 VOICE COMMAND SYSTEM OPERATION . . . . .85
 COMMANDS . . . . . . . . . . . . . . . . . . . . . . . . . . . .86
 VOICE TRAINING . . . . . . . . . . . . . . . . . . . . . . .88
 SEATS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .88
 POWER SEATS . . . . . . . . . . . . . . . . . . . . . . . . .88
 HEATED SEATS . . . . . . . . . . . . . . . . . . . . . . . . .89
 RECLINER ADJUSTMENT . . . . . . . . . . . . . . . .90
 LUMBAR SUPPORT . . . . . . . . . . . . . . . . . . . . . .90
 EASY ENTRY SYSTEM . . . . . . . . . . . . . . . . . . .91
 HEAD RESTRAINTS . . . . . . . . . . . . . . . . . . . . .91
 TO OPEN AND CLOSE THE HOOD . . . . . . . . . . . .93
 LIGHTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .94
 MULTIFUNCTION LEVER . . . . . . . . . . . . . . . . .94
 HEADLIGHTS AND PARKING LIGHTS . . . . . . .94
 LIGHTS-ON REMINDER . . . . . . . . . . . . . . . . . .94
 AUTOMATIC HEADLIGHTS . . . . . . . . . . . . . . .94
 HEADLIGHTS WITH WIPERS (AVAILABLEWITH AUTOMATIC HEADLIGHTS ONLY) . . . . .94
52

TO OPEN AND CLOSE
THE HOOD
Two latches must be released to open
the hood.
1. Pull the hood release lever located
under the left side of the instrument
panel.
2. Move to the outside of the vehicle
and locate the hood safety catch at the
center front edge of the hood.3. Lift the secondary latch under-
neath the center front edge of the
hood and raise the hood.
4. Use the hood prop rod to secure
the hood in the open position. Place
the upper end of the prop rod in the
hole on the underside of the hood.
Before closing the hood, make sure to
stow the prop rod in its proper location.CAUTION!
To prevent possible damage, do not
slam the hood to close it. Use a firm
downward push at the center of the
hood to ensure that both latches
engage.WARNING!
Be sure the hood is fully latched
before driving your vehicle. If the
hood is not fully latched, it could
open when the vehicle is in motion
and block your vision. Failure to
follow this warning could result in
serious injury or death.
Hood Release Lever
Hood Safety Catch Location
Secondary Latch
Hood Prop Rod Hole Location
93

 Door Ajar (with vehicle graphicshowing which door is open. A
single chime sounds if the vehicle is
in motion).
 Doors Ajar (with vehicle graphic showing which doors are open. A
single chime sounds if the vehicle is
in motion).
 Trunk Open (with vehicle graphic showing and open trunk and A
single chime )
 Lights On
 Key In Ignition
 Remote start aborted — Door ajar
 Remote start aborted — Hood ajar
 Remote start aborted — Trunk ajar
 Remote start aborted — Fuel low
 Remote start disabled — System fault  Convertible Top Not Secured (with
a single chime)
 Convertible Top Complete (with a single chime)
 Secure Cargo Shield (with a single chime)
 Speed Too High (with a single chime)
 Convertible Top Malfunction (with a single chime)
 Oil Change Required (with a single chime)
 Low Tire (with a graphic of the car showing which tire(s) is/are low -
with a single chime). Refer to "Tire
Pressure Monitoring System" in
"Starting and Operating".
 Check TPM System (with a single chime) Refer to "Tire Pressure
Monitoring System" in "Starting
and Operating". OIL CHANGE REQUIRED
Your vehicle is equipped with an en-
gine oil change indicator system. The
“Oil Change Required” message will
flash in the EVIC display for approxi-
mately five seconds after a single
chime has sounded to indicate the
next scheduled oil change interval.
The engine oil change indicator sys-
tem is duty cycle based, which means
the engine oil change interval may
fluctuate dependent upon your per-
sonal driving style.
Unless reset, this message will con-
tinue to display each time you cycle
the ignition to the ON/RUN position.
121

HAZARD WARNING
FLASHERS
The Hazard Warning flasher switch is
located on the instrument panel, be-
low the radio.Press the switch to turn on the
Hazard Warning flasher.
When the switch is activated, all di-
rectional turn signals will flash on and
off to warn oncoming traffic of an
emergency. Press the switch a second
time to turn off the Hazard Warning
flashers.
This is an emergency warning system
and it should not be used when the
vehicle is in motion. Use it when your
vehicle is disabled and it is creating a
safety hazard for other motorists.
When you must leave the vehicle to
seek assistance, the Hazard Warning
flashers will continue to operate even
though the ignition is placed in the
OFF position.
NOTE: With extended use the
Hazard Warning flashers may
wear down your battery. IF YOUR ENGINE
OVERHEATS
In any of the following situations, you
can reduce the potential for overheat-
ing by taking the appropriate action.
 On the highways — Slow down.
 In city traffic — While stopped, put
transaxle in NEUTRAL, but do not
increase engine idle speed.
CAUTION!
Driving with a hot cooling system
could damage your vehicle. If tem-
perature gauge reads “H”, pull over
and stop the vehicle with the engine
at idle, when safe. Turn the air con-
ditioner off and wait until the
pointer drops back into the normal
range. After appropriate action has
been taken, if the pointer remains
on the “H”, turn the engine off im-
mediately, and call for service. NOTE: There are steps that you
can take to slow down an impend-
ing overheat condition:
 If your air conditioner (A/C) is
on, turn it off. The A/C system
adds heat to the engine cooling
system and turning the A/C off
can help remove this heat.
 You can also turn the tempera- ture control to maximum heat,
the mode control to floor and the
blower control to high. This al-
lows the heater core to act as a
supplement to the radiator and
aids in removing heat from the
engine cooling system.
WARNING!
You or others can be badly burned
by hot engine coolant (antifreeze)
or steam from your radiator. If you
see or hear steam coming from un-
der the hood, do not open the hood
until the radiator has had time to
cool. Never try to open a cooling
system pressure cap when the ra-
diator or coolant bottle is hot.
172

PREPARATIONS FOR
JUMP-START
The battery in your vehicle is located
between the left front headlight as-
sembly and the left front wheel splash
shield. To allow jump-starting there
are remote battery posts located on
the left side of the engine compart-
ment.
WARNING!
 Take care to avoid the radiatorcooling fan whenever the hood is
raised. It can start anytime the
ignition switch is ON. You can be
injured by moving fan blades.
 Remove any metal jewelry such
as watch bands or bracelets that
might make an inadvertent elec-
trical contact. You could be seri-
ously injured.
 Batteries contain sulfuric acid that can burn your skin or eyes
and generate hydrogen gas which
is flammable and explosive. Keep
open flames or sparks away from
the battery.
1. Set the parking brake, shift the
automatic transmission into PARK
and turn the ignition to LOCK.
2. Turn off the heater, radio, and all
unnecessary electrical accessories. 3. Remove the protective cover over
the remote positive
(+)battery post.
To remove the cover, press the locking
tab and pull upward on the cover.
4. If using another vehicle to jump-
start the battery, park the vehicle
within the jumper cables reach, set
the parking brake and make sure the
ignition is OFF.
WARNING!
Do not allow vehicles to touch each
other as this could establish a
ground connection and personal in-
jury could result.
Remote Battery Posts
1 — Remote Positive (+)Post
(covered with protective cap)
2 — Remote Negative (-)Post
Locking Tab
180

COOLING SYSTEMWARNING!
 When working near the radiatorcooling fan, disconnect the fan
motor lead or turn the ignition
switch to the LOCK position. The
fan is temperature controlled and
can start at anytime the ignition
switch is in the ON position.
 You or others can be badly
burned by hot engine coolant
(antifreeze) or steam from your
radiator. If you see or hear steam
coming from under the hood, do
not open the hood until the radia-
tor has had time to cool. Never try
to open a cooling system pressure
cap when the radiator is hot.CAUTION!
Car maintenance should be done at
a LANCIA Dealership. For routine
and minor maintenance operations
you wish to carry out yourself, we
do recommend you have the proper
equipment, genuine LANCIA spare
(Continued)
CAUTION!(Continued)
parts and the necessary fluids; do
not however carry out these opera-
tions if you have no experience.
Coolant Checks
Check engine coolant (antifreeze)
protection every 12 months (before
the onset of freezing weather, where
applicable). If the engine coolant (an-
tifreeze) is dirty or rusty in appear-
ance, the system should be drained,
flushed, and refilled with fresh engine
coolant (antifreeze). Check the front
of the A/C condenser for any accumu-
lation of bugs, leaves, etc. If dirty,
clean by gently spraying water from a
garden hose vertically down the face
of the condenser.
Check the coolant recovery bottle
tubing for brittle rubber, cracking,
tears, cuts, and tightness of the con-
nection at the bottle and radiator. In-
spect the entire system for leaks. Cooling System – Drain, Flush,
And Refill
If the engine coolant (antifreeze) is
dirty or contains a considerable
amount of sediment, clean and flush
with a reliable cooling system cleaner.
Follow with a thorough rinsing to re-
move all deposits and chemicals.
Properly dispose of old engine coolant
(antifreeze).
Refer to the “Maintenance Schedule”
for the proper maintenance intervals.
Selection Of Coolant
Use the manufacturer’s recommended
coolant or a quality-equivalent prod-
uct. Refer to “Fluids, Lubricants, and
Genuine Parts” in “Maintaining Your
Vehicle” for further information.
198

LIGHT BULBS –
ExteriorBulb No.
Bi-Halogen Headlamp . . . HIR2
Front Turn Signal
Lamp . . . . . . . . . . . . 3157NAK
Front Park Lamp . . . . . . . LED (Serviced at Authorized Dealer)
Side Repeater Lamp . . . WY5W
Front Fog Lamp . . . . . . . . H11
Center High Mounted
Stop (CHMSL) Lamp . . . . LED (Serviced at Authorized Dealer)
Rear Tail/Stop Lamp . . . . . LED (Serviced at Authorized Dealer)
Rear Turn Signal
Lamp . . . . . . . . . . . . . . . W16W
Rear Fog Lamp . . . . . . . . . LED (Serviced at Authorized Dealer)
Backup Lamp . . . . . . . . W16W
License Lamp . . . . . . . . . W5W BULB REPLACEMENT
HEADLAMP
CAUTION!
Where possible, it is advisable to
have bulbs changed at a LANCIA
Dealership. Proper operation and
orientation of the external lights are
essential for driving safety and
complying with the law.
1. Raise and prop open the hood.
Locate the connector behind the
headlamp.
NOTE: It may be necessary to re-
move the air cleaner filter housing
and position the totally integrated
power module aside prior to re-
placing the low beam headlamp on
the driver's side of the vehicle.
2. Reach into engine compartment
and from behind the lamp assembly
and grasp the connector. 3. Rotate bulb and connector one-
quarter turn and pull outward from
assembly.
CAUTION!
Do not touch the new bulb with
your fingers. Oil contamination will
severely shorten bulb life.
213

4. Pull the bulb out of the socket and
replace the bulb.
5. If the bulb comes in contact with
any oily surface, clean the bulb with
rubbing alcohol.
6. Reinsert the bulb and socket as-
sembly and rotate clockwise one-
quarter turn to secure.
FRONT TURN SIGNAL
1. Raise and prop open the hood.
2.
Rotate the bulb's electrical connec-
tor one-quarter turn counterclockwise
and remove it from the headlamp hous-
ing.
3. Remove the bulb from the connec-
tor socket and install the replacement
bulb.
4. Install the bulb and connector as-
sembly into the headlamp housing
and rotate the connector one-quarter
turn clockwise to lock it in place.
FRONT FOG LAMP
NOTE:
Access to the lamps through
the lower fascia cutout is limited. We
recommend you access the lamps by
turning the steering wheel to allow
access and remove the inner fender
shield.
1. Rotate the bulb's electrical con-
nector one-quarter turn counter-
clockwise and remove it from the fog
lamp housing.
2. Remove the bulb from the connec-
tor socket and install the replacement
bulb.
CAUTION!
Do not touch the new bulb with
your fingers. Oil contamination will
severely shorten bulb life. If the
bulb comes in contact with an oily
surface, clean the bulb with rub-
bing alcohol.
3. Install the bulb and connector as-
sembly into the fog lamp housing and
rotate the connector one-quarter turn
clockwise to lock it in place.
REAR TURN SIGNAL
LAMPS
1. Open the trunk and gently pull
back the trunk liner behind the tail
lamp (requires removal of a push pin
holding the trunk trim in place near
the tail lamp).
2. Remove the two plastic wing nuts
from the tail lamp housing.
214