2013 JEEP WRANGLER UNLIMITED lock

WARNING! (Continued)the driver to lose control of the vehicle. Be sure the
steering column is locked before driving your ve-
hicle. Failure to follow this warning may result in
serious injury or death.
ELECTRONIC SPEED CONTROL — IF EQUIPPED
When engaged, the Electronic Speed Control takes over
accelerator operations at speeds greater than 25 mph
(40 km/h).
The Electronic Speed Control buttons are located on the
right side of the steering wheel. Electronic Speed Control Buttons1 — ON/OFF 2 — RES +
4 — CANCEL 3 — SET -178 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

STORAGE
Glovebox Storage
The lockable glovebox storage compartment is located on
the passenger side of the lower instrument panel. Pull
outward on the handle/latch to open the compartment.
Console Storage Compartment
To lock or unlock the storage compartment, insert the
ignition key and turn. To open the storage compartment,
press the latch and lift the cover. Center Console
3 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 189

4. Install the soft top with the pivot bracket above the
sport bar bracket, lower the pivot bracket onto the
sport bar bracket mounting tab in a downward motion
to lock into tab (another person may be needed to help
with this operation). 5. Screw the pivot screws back into place using a #T30
Torx  head driver. Secure them until they are snug,
being careful not to cross-thread the screws or over-
tighten.200 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

CAUTION! (Continued)• The hard top assembly must be positioned prop-
erly to ensure sealing. Improper installation can
cause water to leak into the vehicles interior.
• Careless handling and storage of the removable
roof panels may damage the seals, causing water to
leak into the vehicles interior.
• The front panel(s) must be positioned properly to
ensure sealing. Improper installation can cause
water to leak into the vehicles interior.
Front Panel(s) Removal
NOTE: Left panel must be removed before removing
right panel.
1. Fold down the sun visor, and move it to the side. 2. Turn the rear fasteners (knobs) (located on the over-
head speaker bar assembly) counterclockwise until
they can be removed.
3 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 203

3. Turn the center L-shaped locks (two) from the center
of the roof panel. 4. Turn the rear L-shaped lock (located above the shoul-
der belt anchorage).204 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Front Panel(s) Installation With Rear Hard Top
Removed
1. Turn the left and right panels over and move the
spacer block (located on the rear of the panel) upward
90 degrees. NOTE: The front panel(s) must be positioned properly
to ensure sealing. Set the panels on the windshield frame
so that there is no overhang. Also, make sure that the
panels are sitting flush with the body.
2. Install the right panel first, then the left panel.
3. Reinstall the panel(s) using the same steps for removal
in reverse order.
Rear Hard Top Removal
1. Remove both front panels. Refer to “Front Panel(s)
Removal” in this section.
2. Open both doors.
3. Remove the two Torx  head screws that secure the
hard top at the B-pillar (near the top of the door) using
a #40 Torx  head driver (Four–Door Only).210 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

7. Release the red locking tab by pulling outward to the
right. 8. To remove the wiring harness press the tab and pull
downward to disconnect.
Red Locking Tab Press Tab To Disconnect212 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

5. Insert the slider feature of the knuckles into the door
frame tracks and slide the top forward. 6. Ensure that the top locks into the Sunrider  locking
mechanisms that are located above the front of the rear
doors.272 UNDERSTANDING THE FEATURES OF YOUR VEHICLE