9
INFINITI Intelligent Key™ System
The INfINITI Intelligent Key™ system allows you to lock or unlock your
vehicle, open your liftgate and remotely start the engine.
NOTE: It is important to make sure the Intelligent Key is with you (that is,
in your pocket or purse).
REMOTE ENGINE START (if so equipped)
The remote engine start operating range is approximately 197 feet
(60 m) from the vehicle.
To use the remote start feature to start the engine:
1. Aim the Intelligent Key at the vehicle.
2. Press the
button
01 to lock all doors.
3. Within 5 seconds press and hold the remote start
button
02 until the turn signal lights
illuminate. If the vehicle is not within view, press and hold the remote start button for about
2 seconds.
LOCKING AND UNLOCKING THE VEHICLE
The lock and unlock operating range of the Intelligent
Key is within 31.5 in (80 cm) from each request switch.
To lock the vehicle, push either door handle request
switch
03 once or press the
button
01 on the keyfob.
To unlock the vehicle, perform one of the following
procedures:
• Push either door handle request switch
03 once; the corresponding door will unlock. Push
the door handle request switch
again within 30 seconds; all
other doors will unlock, or
• Press the
button
04 on the keyfob to unlock the driver’s side door. Press the
button
again; all other doors will unlock.
LIf TGATE RELEASE
To open the rear liftgate, press the
button
05 for longer than 0.5 seconds.
To close the rear liftgate, press the
button
05 again for longer than 0.5 seconds.
PANIC ALARM
The Intelligent Key can also be used to activate the panic alarm by pressing and holding the
button
06 for more than 1 second. Once activated, the panic alarm and headlights will
stay on for 25 seconds.
first drive features
02
01
04
05
06
03
14
first drive features
Headlight Control Switch
HEADLIGHT CONTROL
Turn the headlight control switch to the position
01 to turn on the front parking, tail, license plate and
instrument panel lights. Turn the switch to the
position
02 to turn on the headlights.
AUTOLIGHT S ySTEM
The autolight system will automatically turn the headlights on when it is dark and off when it is
light. The system will keep the headlights on for a period of time after you turn the ignition off
and all doors are closed.
To activate the autolight system, turn the headlight control switch to the AUTO position
03
then push the ignition switch to ON. To deactivate the autolight system, turn the headlight
control switch to the OFF,
01 or
position
02 .
HIGH BEAM SELECT
Push the headlight control switch forward
04 to
select the high beam function. The blue indicator light
illuminates in the instrument panel. Pull the
headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
Pull and release the headlight control switch
05 to
flash the headlight high beams on and off.
fOG LIGHT SWITCH
NOTE: The headlights must be on and the low beams
selected for the fog lights to operate.
Turn the switch (inside collar) to the position
06
to turn the fog lights on.
Turn the switch (inside collar)
to the OFF position to
turn the fog lights off.
for more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
03
04
06
01
05
02
