2013 FORD MUSTANG buttons

CREATING A MYKEY
Use the information display control to create a MyKey
1. Insert the key you want to program into the ignition or, if the vehicle
is equipped with push button start, put the intelligent access key in
the backup slot; refer toStarting and Stopping the Enginechapter.
2. Turn the ignition on.
3. Access the main menu on the information display controls and select
Settings, then MyKey by pressing OK or the > button.
4. Press OK to select Create.
5. When prompted hold the OK button until you see a message
informing you to label this key as a MyKey. The key will be restricted
at the next start.
The key is successfully programmed. Make sure you label it so you can
distinguish it from the admin keys.
To program optional settings for the key(s), refer to
Programming/Changing optional settings.If your vehicle is equipped
with remote start, refer toUsing MyKey with remote start systems.
Programming/Changing Optional Settings
Note:All programmed keys can be cleared within the same key cycle in
which a key was programmed, otherwise an admin key is required to
clear the keys. To clear all keys, refer toClearing all MyKeys.
You can access the optional settings through the information display control.
1. Turn the ignition on using an admin key.
2. Access the main menu and select Settings, then MyKey.
3. Use the arrow buttons to get to an optional feature.
4. Press OK or > to scroll through settings.
5. Press OK or > to make a selection.
CLEARING ALL MYKEYS
Note:All programmed MyKeys can be cleared within the same key cycle
in which a MyKey was created, otherwise an admin key is required to
clear the keys.
To clear all MyKeys as admin keys, use the information display control to
do the following:
1. Access the main menu and select Settings, then MyKey .
2. Scroll to Clear All and press the OK button.
3. Hold the OK button until ALL MYKEYS CLEARED is displayed.
58MyKey
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

LOCKING AND UNLOCKING
You can use the power door lock control or the remote control to lock
and unlock the vehicle.
Power Door Locks
A. Unlock
B. Lock
Remote Control
The remote control can be used any time the vehicle is not running.
Unlocking the Doors (Two-Stage Unlock)
Press the button to unlock the driver’s door.
Press the button again within three seconds to unlock all doors.
The turn signals will flash.
To disable or enable two-stage unlocking, press and hold both the lock
and unlock buttons on the remote control for four seconds . Disabling
two-stage unlocking allows all vehicle doors to unlock with one press of
the button. The turn signals will flash twice to indicate the unlocking
mode was changed.
Locking the Doors
Press the button to lock all the doors. The turn signals will
illuminate.
Press the button again within three seconds to confirm that all
the doors are closed. The doors will lock again, the horn will chirp and
the turn signal will illuminate if all the doors and the liftgate are closed.
Note:If any door or the trunk is not closed, or if the hood is not closed
on vehicles equipped with an anti-theft alarm or remote start, the horn
will chirp twice and the lamps will not flash.
A
B
Locks63
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

AUDIO CONTROL (IF EQUIPPED)
A. Media
B. Volume down
C. Volume up
D. Seek up or next
E. Seek down or previous
Press the media button repeatedly to scroll through available audio
modes.
Press the seek buttons to select the next or previous stored preset or
track. Press and hold to select the next or previous frequency or seek
through a track.
VOICE CONTROL (IF EQUIPPED)
A. Voice recognition
B. Phone mode
Refer to theSYNCorNavigation Systemchapter.
CRUISE CONTROL
Refer to theCruise Control
chapter.
-+
ABC
ED
-+
OK
A
B
-+SET CNCL
RSMON
OFF
74Steering Wheel
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

Information Display Controls (Type 2)
•Press the up and down arrow
buttons to scroll through and
highlight the options within a
menu.
•Press the right arrow button to
enter a sub-menu.
•Press the left arrow button to
exit a menu.
•Press the OK button to choose
and confirm a setting/messages.
Main menu
You can access the menus using the information display control.
•Gauge Mode
•Trip A/B
•Fuel Economy
•Track Apps (Track use only)
•Settings
•Information
102Information Displays
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

Settings
Units English or Metric
System Reset Hold OK to Reset System to Factory Default
†The instrument cluster gauges are backlit white when the headlamps
are off. When the headlamps are on, you can select one of the preset
colors or MyColor 1, 2, 3 for the nighttime gauge backlighting. A gauge
in a warning condition will be backlit red when the headlamps are on.
*Track Application features and messages in the information display are
only available in English.
Information
MyKey Admin Keys (Number of admin keys)
MyKeys (Number of MyKeys programmed)
MyKey Miles (km) (Distance traveled using a
programmed MyKey)
System Check Some items will only display during a system check
if a problem has been detected. If an issue exists on
one of the monitored systems, the number of
warnings that need immediate attention will display
in red and the number of informational warnings will
display in amber. Use the up/down arrow buttons to
scroll through the list; press the right arrow button
to display specific information on the highlighted
warning
TRIP COMPUTER (Trip A and B)
Resetting or pausing the trip computer
•Press OK to pause the Trip A or B screen/press again to un-pause.
•Press and hold OK to reset the currently displayed trip information.
Trip time
Registers the time of individual journeys.
Trip distance
Registers the mileage of individual journeys.
Fuel used
Shows the amount of fuel used for a given trip.
Information Displays107
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

Compass Zone Adjustment
When something affects the compass readings, typically the compass
corrects itself after a few days of operating your vehicle in normal
conditions. If the compass still appears to be inaccurate, a manual
calibration may be necessary.
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Press and hold the 7 and 9 radio
preset buttons together for
approximately five seconds until
ZONE XX appears in the CID.
4. Press and release the 7 and 9
radio preset buttons together,
repeatedly until ZONE XX
changes to the correct zone
(1–15) in the CID.
5. The direction displays after the buttons are released. The zone is now
updated.
Compass Calibration Adjustment
Most geographic areas (zones) have a magnetic north compass point that
varies slightly from the northerly direction on maps. This variation is four
degrees between adjacent zones and becomes noticeable as the vehicle
crosses multiple zones. A correct zone setting eliminates this error.
Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all the
vehicle’s doors are shut.
1. Start the vehicle.
2. Press and hold the 7 and 9 radio preset buttons together for
approximately 10 seconds until CAL appears. Release the buttons.
3. Drive the vehicle in a circle slowly (under than 3 mph [5 km/h]); it
may take up to five circles to complete calibration.
4. When the CAL display changes to the direction value (N, S, E, W,
etc.), the compass is calibrated.
1 2 3
4
5
6 7 8 9 101112 13 14 15
11 6Information Displays
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

When you select: You can:
A. Memory presets Store your favorite stations for later access.
When tuned to any station, press and hold a
preset button until sound returns and
PRESET # SAVED appears in the display.
Save presets automatically by using the
autoset feature. Press MENU repeatedly until
AUTO PRESET ON/OFF appears in the
display. Use the SEEK buttons to turn AUTO
PRESET to ON, and either wait five seconds
for the search to initiate or press OK to
immediately start the search. If you press
another control within those five seconds, the
search does not start. The 10 strongest
stations will be filled and the station stored in
preset 1 begins playing. If there are fewer
than 10 strong stations, the system stores the
last one in the remaining presets.
Note:Autoset does not delete your original
preset stations.
Note:In order to re-run the autoset features,
you must first turn it off before turning it
back on.
B. MENU Access different audio features:
Compressioncan be turned on or off. When
compression is on, the soft and loud CD
passages are brought together for a more
consistent listening level.
Shufflecan be turned on or off. Turning
shuffle on plays the current CD tracks in
random order.
RDS Radioallows you to search
RDS-equipped stations for a certain category
of music format: CLASSIC, COUNTRY,
JAZZ/RB, ROCK, etc.
In SIRIUS mode,access different satellite
radio options and follow the prompts.
C. CLOCK Set the time. Use the memory presets buttons
to enter the time, then press OK.
120Audio System
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

When you select: You can:
D. PHONE Access the phone features of the SYNC
system. Refer to theSYNCchapter for more
information.
If your vehicle is not equipped with SYNC,
the display will read NO PHONE.
E. SOUND Allows you to adjust the sound settings using
the SEEK buttons:
Basslevels can be increased or decreased.
Can also be adjusted by turning the TUNE
control.
Treblelevels can be increased or decreased.
Can also be adjusted by turning the TUNE
control.
Balanceadjust the sound between left and
right speakers. Can also be adjusted by
turning the TUNE control.
Fadeadjust the sound between the front and
back speakers. Can also be adjusted by
turning the TUNE control.
Speed Compensated Volumeadjusts the
volume to compensate for speed and wind
noise. You can set the system between off and
+7.
All Seat Mode/Driver Seat Mode/Top
Down Mode (if equipped)optimizes sound
quality for the chosen seating position.
DSP Mode (if equipped)allows you to
choose between STEREO SURROUND mode
and STEREO mode.
F. Eject Eject the CD.
G. CD slot Insert a CD.
Audio System121
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)