Instrument Panel Cover.....................622
Instrument Panel Lens Cleaning...............624
Integrated Power Module (Fuses)..............626
Interior Appearance Care....................622
Interior Lights...........................225
Intermittent Wipers (Delay Wipers).............230
Introduction..............................4
Jack Location............................562
Jack Operation...........................561
Jump Starting............................579
Key-In Reminder..........................15
Keyless Entry System.......................20
Key, Programming.........................17
Key, Replacement..........................16
Keys...................................12
Key, Sentry (Immobilizer)....................15Lane Change Assist........................228
Lap/Shoulder Belts.........................60
Latches................................121
Hood................................220
Lead Free Gasoline........................528
Leaks, Fluid.............................121
Life of Tires.............................515
Liftgate.................................52
Light Bulbs..............................120
Lights.................................120
Airbag................................82
Alarm...............................320
Anti-Lock.............................314
Automatic Headlights....................222
Back-Up..............................636
Battery Saver..........................228
Brake Assist Warning....................491
Brake Warning.........................320
Bulb Replacement.......................634
670 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
