214
Visibility
Wiper controls
Programming
Your vehicle may also include some functions
that can be configured:
- automatic rain sensitive windscreen wipers,
- rear w
iping on engaging reverse gear.
Manual controls
Windscreen wipers
Fast wipe (heavy rain).
Normal wipe
(moderate rain).
Intermittent wipe
(proportional to the
speed of the vehicle).
P
ark.
Automatic wipin
g (press down,
then release).
Single wipe (pull the stalk brieflytowards you). The wipers are controlled directly by the driver.
Wiping speed control stalk: raise or lower the
stalk to the desired position.
Model without AUTO wiping
Model with AUTO wiping
Single wipe (press downwards or pull
the stalk briefly towards you, thenrelease).
or
In wintry conditions, remove snow, iceor frost present on the windscreen, around the wiper arms and blades andthe windscreen seal, before operatingthe wipers.
Do not operate the wipers on a dry windscreen. Under extremely hot or
cold conditions, ensure that the wiper blades are not stuck to the windscreen,before operating the wipers.
The front wiper system includes asafety device which can temporarilyinhibit operation if it detects obstacles such as ice or snow.
218
Visibility
Special position of the
w
indscreen wipers
To maintain the effectiveness of the "flat-blade" type of wiper blades, it is advisable to:
- handle them with care,
- clean them regularly using soapywater,
- avoid using them to retain cardboard on the windscreen,
- replace them at the first signs of wear.
This position permits release o
f the windscreen
wiper blades.
It is used for cleaning or replacement of the blades. It can also be useful, in winter, todetach the blades from the windscreen.
Do not cover the rain sensor, linked with the sunshine sensor and located in the centre of the windscreen behind the rear view mirror.
Switch off the automatic rain sensitivewipers when using an automatic car wash.
In winter, it is advisable to wait until thewindscreen is completely clear of ice before activating the automatic rain sensitive wipers.
Operating fault
If a fault occurs with the automatic rain sensitive wipers, the wipers will operate in
intermittent mode.
Have it checked by CITROËN dealer or a
qualified workshop.
On switching off the ignition: )
any action on the wiper stalk in the minute
after switching off the ignition places the
blades vertically on the screen.
When the system is no longer powered - at least
one minute after switching off the ignition - it is
possible to move the arms manually. ) To park the blades again, switch on the
ignition and operate the wiper stalk.
Replacement of the arms must only be done by a CITRO