2013 Citroen C4 PICASSO RHD fuse box

10
Familiarisation
Interior
1.
Bonnet release lever.2.
Fusebox.3.
Steering wheel adjustment controls. 4.
Door mirror controls.Electric window controls.5.
Side adjustable air vents.Side window demisting vents.
6.Quar ter light demisting windows.
7
. Driver's airbag.
Horn. 8.Courtesy lamp and map reading lamps. 9. Panoramic glass roof panel blind control. 10.CITROËN Localised Emergency Call - CITROËN Localised Assistance Call(depending on country of sale).11.
Windscreen demisting/defrosting vent.12.Scented air freshener.13.Central adjustable air vents.14.Passenger's airbag. 15.
Glove box.16.
Central storage.
Audio sockets, 12V accessory socket (120 W max), 230V socket (120 W max).17.Storage below steering wheel (handbookpack). 18.Gear lever (manual gearbox). 19. Console (fixed/removable).
20.
Storage or rear multi-media.
Rear 12 V accessory socket (120 W max.).

50
Monitoring
Under-inflationfixed.The pressure in one or more wheelsis too low. Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
You must reinitialise the system after the adjustment
of one or more tyre pressures and after changing one or more wheels.

+
flashing then fixed, accompanied by the Service warning lamp.The s
ystem has fault: the tyrepressures are no longer monitored.Check the tyre pressures as soon as possible.
Have the system checked by a CITROËN dealer or a
qualified workshop.
Warning / indicator lampStateCauseAction / Observations
Foot on thebrake pedal*fixed. The brake pedal is not pressed. With an electronic gearbox, press the brake pedal to start the engine (lever in position N ).
If you wish to release the parking brake withoutpressing the brake pedal, this warning lamp will
remain on.
With an automatic gearbox, press the brake pedal to move the gear selector out of position P.P
flashing. With an electronic gearbox, if you hold the vehicle on an incline using
the accelerator for too long, the clutch overheats. Use the brake pedal and/or the parkin
g brake.
Foot on theclutch*fixed. In the STOP mode of Stop & Start,changing to START mode is refused
because the clutch pedal is not fully down.You must declutch full
y to allow the change to engineSTA R T m o d e .
*
Only with the type 1 instrument panel

288
Practical information
Before changing a fuse: )
the cause of the failure must be identified
and rectified,)
all electrical consumers must b switched off,)
the vehicle must be immobilised with the
ignition off, ) identify the failed fuse using the tables and layout drawings in the following pages.


Changing a fuse
GoodFailed

The replacement of a fuse not shown inthe tables below may cause a seriousmalfunction of your vehicle. Contact a CITROËN dealer or a qualifiedworkshop.
Tweezer





















Changing a fuse
The extraction tweezer is located in the
dashboard fusebox compartment.
F
or access to it: )unclip the cover by pulling at the top right,
then left, )disengage the cover completely, bycarefully pulling in the direction indicated
by the arrow,
)remove the tweezer.

Access to the tools

To replace a fuse, you must:)
use the special tweezer to extract the fuse from its housing and check the condition of
its filament. ) always replace the failed fuse with a fuse of the same rating (same colour); using a
di
fferent rating could cause faults (risk of fire).
If the fuse fails again soon after replacement,
have the vehicle's electrical system checked by
a CITRO

289
7
Practical information
CITROËN will not accept responsibilityfor the cost incurred in repairing your vehicle or for rectifying malfunctions resulting from the installation of accessories not supplied and notrecommended by CITROËN andnot installed in accordance with its instructions, in par ticular when the combined consumption of all of the additional equipment connectedexceeds 10 milliamperes.


Installing electricalaccessories

Your vehicle's electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories on your vehicle, contact a CITROËN dealer or aqualified workshop.
Configurations
The type of electrical system of the vehicle depends on its level of equipment.
To i d e n t i fy the type of electrical system on your vehicle, open the bonnet: the presence of anadditional fusebox in front of the battery indicates that it is type 2.
The type 1 electrical system does not have any fuses in front of the battery.

290
Practical information

Type 1 fuse tables
Fusebox 1


Dashboard fuses

The fusebox is located in the lower dashboard (left-hand side).
Access to the fuses
)Refer to the paragraph "Access to the tools".
Fuse N°RatingFunctions
F
85 A Steering mounted controls
F1
820 A Touch screen tablet, audio and navigation system, CD player,USB por ts and auxiliary sockets.
F1
615 A
Front 12V socket.
F1
515 A
Boot 12V socket.
F2
85 A STA R T/STOP button.
F3
015 A Rear wiper.
F27 15 A
Front screenwash pump, rear screenwash pump.
F2
615 A
Horn.
F20 5
A Airbags.
F215 A Instrument panel.
F1
95 A Rain and sunshine sensor.
F12 5
A Keyless starting unit.
F2 5
A Manual headlamp adjustment control.

291
7
Practical information
Fusebox 2
Fuse N°RatingFunctions
F
915 A Rear 12V socket.

292
Practical information
Type 2 fuse tables
Fuse N°RatingFunctions
F
33 A START/STOP button.
F6A 15 A Touch screen tablet, audio and navi
gation system, CD player,USB ports and auxiliary sockets.
F8 5
A Alarm.
F
93 A Steering mounted controls.
F1
95 A Instrument panel.
F2
43 A Rain and sunshine sensor.
F25 5
A Airbags.
F33 3
A Memorisation of driving position.
F3
45 A Electric power steering.
F13 10 A
Fr
ont 12V socket.
F1410 A
Boot 12V socket.
F1
63 A Map reading lamps in row 1 cour tesy lamps.
F27 5
A Electronic gearbox gear selector.
F3
020 A Rear wiper.
F3
83 A Manual headlamp adjustment control.

293
7
Practical information

Engine compartment fuses
An additional fusebox is fitted in front of thebattery, for type 2. The
fusebox is placed in the engine compartment near the battery (left-hand side).Access to the fuses
)
Unclip the cover, by pushing the two red latches towards the rear of the vehicle. )
Change the fuse (see correspondingparagraph). )
When you have finished, close the cover carefully to ensure correct sealing of the
fusebox.