2013 Citroen C4 PICASSO RHD ECO mode

171
4
Driving
Steering mounted controls
The information is grouped together in the instrument panel.
6. Cruise control pause / resume indication.
7.Cruise control mode selection indication. 8.Speed value setting.






Cruise control

System which automatically maintains the speed of the vehicle at the value programmed by the driver, without any action on the accelerator pedal.


The cruise control system cannot, in any circumstances, replace the need to obser ve speed limits, nor can it replace the need for vigilance and responsibility on the par t of the driver.
You are advised to keep your feet near the pedals at all times.
Th
e cruise control is switched on
manually: it
requires a minimum vehicle speed of 25 mph
(40 km/h) and engagement of:


- at least four th gear on a manual gearbox,

- second gear on an electronic or automatic gearbox, in manual driving mode,

- position A
on an electronic gearbox or D
on an automatic gearbox.
The controls o
f this system are grouped
together at the steering wheel. 1.Cruise control mode selection wheel.
2. Decrease value or speed setting on the flybutton.3.
Increase value or speed setting on the flybutton.
4. Cruise control pause / resume button.
5. Memorised speeds display button.
For more information on the list of memorisedspeeds, refer to "Memorising speeds" section).


Displays in the instrument panel

Switching off the ignition cancels any programmed speed value. Th
e cruise control is paused
manually or
by pressing the brake or clutch pedal or
on triggering of the ESP system for safety
reasons.
It is possible to exceed the programmed speed
temporarily by pressing the accelerator pedal.
To return to the programmed speed, simply
release the accelerator pedal until the programmed cruise speed is reached again.

172
Driving
If the cruise control is on, you can then modify
the initial speed in one of the following ways:


- using buttons 2
or 3
: )
by successive shor t presses, to modify
the speed by + or - 1 mph (km/h), )
by a long press, to modify the speed insteps of + or - 5 mph (km/h),
)Turn wheel 1to the "CRUISE"position: thecruise control mode is selected but is not
switched on (Pause).)Press button 2 or 3
: your vehicle's current
speed becomes the cruise speed (selected
on the fly).
The cruise control is activated (ON).

Modifi cation of the initial speed
setting


- pressing button 5:)the six memorised speeds are displayed
in the touch screen tablet,
)choose a value: it is displayed in the
instrument panel.
Th
e selection screen closes after a fewmoments.
The modification is then accepted.
Pause
Once switched on, you can pause the cruisecontrol at any time by pressing button 4
:
the screen confirms the pause.

174
Driving





Active cruise control
This systems allows, in addition to maintainingyour vehicle's speed at a value that you have defined, the inter-vehicle time you have
selected between your vehicle the the one ahead to be maintained (2 seconds by default,
on activating the function).

Principles of operation

Using a radar with a range of about 100 metres,located at the front of the vehicle, this system
detects a vehicle running in front of your
vehicle.
It automatically adapts the speed of the vehicle
to that of the vehicle in front.
If the vehicle in front is running more slowly,
the system progressively reduces the speed of your vehicle using just engine braking (as if thedriver had pressed the "- " button).
If your vehicle is too close to or approaching tooquickly the vehicle in front, the cruise control
is automatically deactivated. The driver is then
aler ted by an audible signal, accompanied by a message.
If the vehicle in front accelerates or changeslane, the active cruise control progressively
accelerates your vehicle to return to the
programmed speed.
If the driver operates a direction indicator to
the left (left hand drive) or the right (right hand
drive), to over take a slower vehicle, the active cruise control allows your vehicle to temporarily
approach the vehicle in front to assist the
over takin
g manoeuvre, though never exceeding
the programmed speed.

The active cruise control operates byday and at night, in fog or in moderate rainfall.


The system does not act on the brakingsystem, but works only with engine braking.
The regulation range is limited: there willno longer be any adjustment of speed if the difference between the programmed speedsetting and the speed of the vehicle in front becomes too high (18 mph (30 km/h).


The activation of this system deactivates the function of inter-vehicle time.


If the difference between the programmed speed setting and the speed of the vehicle in front is toogreat, the speed cannot be adjusted: the cruise control is automatically
deactivated.

175
4
Driving
The active cruise control is switched onmanually: it requires that the speed of the vehicle
be between 25 mph (40 km/h) and 90 mph (15 0 km / h), as well as the engagement of:


- at least four th gear with a manual gearbox,

- second gear with an electronic or automatic gearbox in manual mode,

- position A
with an electronic gearbox or Dwith an automatic gearbox.


General points
The active cruise control can above be pausedmanually with the control, or automatically:
- b
y pressing the brake or clutch pedal,
- in the event of operation of the DSC, for
safety reasons,
- in the event of an action of the electric
parking brake control,
- when an inter-vehicle time threshold isreached (calculated according to therelative speeds of your vehicle and the
vehicle in front and the inter-vehicle time setting chosen),
- when the distance between your vehicle
and the one in front becomes to small,
- when the speed of the vehicle in front is to
low,
- when the speed of your vehicle becomes
too low.


The active cruise control cannot in any
circumstances replace the obser vation of speed limits, nor the the vigilanceand responsibility of the driver. It is recommended that you always keepyour feet close to the pedals.



If the speed setting selected is above93 mph (15 0 km/h), the system switches
to normal cruise control operation(a message appears in the instrument panel).
Switching off the ignition cancels any
programmed value, and the inter-vehicle time is reset to 2 seconds.

176
Driving
The controls for this system are grouped
together on the steering wheel. 1. Cruise control mode selection wheel. 2.
Button for reducing the cruise value settingor for setting the cruise value on the fly.3.Button for increasing the cruise value
setting or for setting the cruise value on the
fly.4. Button for pausing / resuming the cruise control.5.
Button for displaying the list of memorised
speeds and for adjusting the inter-vehicle
time.
For more information on the list of memorised
speeds, refer to "Memorising speeds".
Steering mounted controls

Switching on
)
Turn the wheel 1
to the "CRUISE" position: cruise control mode is selected, but notstarted (Pause).)
Press one of the buttons 2or 3: the currentspeed of your vehicle becomes the cruisespeed setting (set on the fly).
The cruise control is activated (ON).
The inter-vehicle time is set at 2 seconds.


Operation


Modifi cation of the cruise controlspeed and/or the inter-vehicletime p

Button 5 (MEM)
Press button 5, the six memorised speeds and
the inter-vehicle time setting are displayed in
the touch screen tablet.)Choose a speed setting: it is displayed in
the instrument panel, )press or the " +" or "- " button to choose a new inter-vehicle time setting between
2.5 seconds and 1 second.
The selection screen closes after a fewmoments. The modifications are then accepted.


Modifi cation of the cruise control
speed only
Buttons 2 and 3
)
By successive shor t presses, to modify by steps of + or - 1 mph (km/h), )
by a maintained press, to modify in steps
of + or - 5 mph (km/h).


As a precaution, it is recommended that
you
select a speed setting close to the current
speed of your vehicle.


If the active cruise control has not beenswitched on, pressing this button hasno effect.

204
Visibility
Rear foglamps
Rotate and release the rin
g C:)
forwards a first time to switch on the front foglamps,)
forwards a second time to switch on the
rear foglamps,) rearwards a first time to switch off the rear foglamps,)
rearwards a second time to switch of thefront fog lamps.
Model with front and rear foglampsFo
glamps
The foglamps operate with the dipped and mainbeam headlamps.
)
To switch on the foglamps, turn the ring Cforwards.
Front and rear
foglamps
) To switch off the foglamps, turn the ring Crearwards. When the headlamps switch off with automatic
illumination o
f headlamps or when the dipped
beam headlamps are switched off manually, the foglamps and sidelamps remain on.)Turn the ring rear wards to switch off thefoglamps, the sidelamps will then switch off.


When switching off dipped beam manually, the rear foglamps also go off.

205
5
Visibility

Operation of the rear foglamps is inhibited with the tailgate open. Opening the boot when these lamps are on causes them and their indicator lamp in the instrument panel to go off. They do not come back onautomatically when the boot is closed: they must be switched on again using the control stalk.

In good or rainy weather, by both day and night, the front foglamps and therear foglamps are prohibited. In thesesituations, the power of their beams may dazzle other drivers. They should only be used in fog or falling snow.In these weather conditions, you shouldswitch on the foglamps and dippedbeam headlamps manually, as thesunshine sensor may detect sufficient light.Do not forget to switch off the front andrear foglamps when they are no longer necessary.


Switching off the lightingwhen switching off the ignition

When the ignition is switched off, all of thelamps switch off immediately, except for thedipped beam headlamps if automatic guide-me-home lighting is activated.


Switching on the lightingwhen switching on the ignition

To reactivate the lighting control stalk, turn the ring A
to position A"0"- lighting off, thento the position of your choice.
If the lighting is switched on manually after switching off the ignition, there is an audiblesignal when a front door is opened to warnthe driver that they have forgotten to switch
off the vehicle's lighting, with the ignition off.
They switch off automatically after a periodwhich depends on the state of charge of thebattery (entry to energy economy mode).

219
5
Visibility






Courtesy lamps
1.Front courtesy lamp2.Front map reading lamps 3.Rear cour tesy lamp4.Rear map reading lamp s
Front - rear courtesy lamps
)
With the ignition on, press thecorresponding switch.


Front - rear map reading
lamps
With the "permanent lighting" mode, the lightingtime varies according to the circumstances:


- with the ignition off, approximately ten minutes,

- in energy economy mode, approximatelythirty seconds,

- with the engine running, unlimited.


In this position, the courtesy lamp comes on gradually:
Permanentl
y off.

Permanent lighting. - when the vehicle is unlocked
,
- when the electronic key is removed from
the reader,
- when opening a door,
- when the remote control locking button is
activated, in order to locate your vehicle.
It switches o
ff gradually:
- when the vehicle is locked,
- when the i
gnition is switched on,
- 30 seconds after the last door is closed.


Take care to avoid leaving anything in contact with the courtesy lamps.

Dependin
g on
version, you canalso switch the courtesy lamp on or
off by pressing thisbutton.