2013 Citroen C4 PICASSO instrument panel

1
53
Monitoring
Engine oil level indicator
System which informs the driver whether theengine oil level is correct or not.
This information is indicated for a few secondswhen the ignition is switched on, after theservice information.

The level read will only be correct if the vehicle is on level ground and the engine has been off for more than30 minutes.
Oil level correct
This is indicated by a message in the instrument panel.
Oil level incorrect
This is indicated by a message in the instrument panel.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to avoid damage to the engine.

Oil level indicator fault

This is indicated by a message in the
instrument panel. Contact a CITROËN dealer or a qualified workshop.


Dipstick

Refer to the "Checks" section to locate the
dipstick and the oil filler cap on your engine.
There are 2 marks on the dipstick:
-A
= max; never exceed this level,-B
= min; top up the level via
the oil filler, using the grade of oil suited to your engine.

1
55
Monitoring
Allows the manual adjustment of the brightness of the instrument panel and touch screen tablet tosuit the ambient light level.

Operates only when the vehicle lighting is on, with the exception of the daytime running lamps.

Two buttons

With the headlamps on, press button Bto
increase the brightness of the instruments
and controls and the interior mood lighting or button Ato reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
Touch screen tablet
)
Press on the "Configuration"
menu. )
Adjust the brightness by pressing on
the "+ " or " -" buttons.

56
Monitoring
instrument panel to be switched off for night
driving.
The instrument panel remains on with the
vehicle speed, the
gear selected in an electronic or automatic gearbox, cruise control
or speed limiter information, if in use, and the
low fuel aler ts as appropriate.
If there is an aler t or a change in a function
or to a setting, the black panel mode is
interrupted.
Using the steering mounted control:) With the vehicle lighting on, press this button again to activate the black panel. )
Press this button again to deactivate it.


Black screen (touch screen tablet)Black screen (black panel)
)Press on the " Configuration
" menu.)Press the " Turn off screen" button. Thescreen in the touch screen tablet goes off.
Press the screen again (anywhere on itssurface) to switch it on again.

58
Monitoring
Tr i p c o m p u t e r
Type 1 instrument panel
System that gives you information on the journey in progress (range, fuel consumption…).
Information display in the touch screen tablet
Permanent display: )Select the " Driving assistance" menu.
The trip computer information is displayed in
the primary page of the menu. )Press one of the buttons to display thedesired tab.
- The current fuel consumption tab
with:
●
the ran
ge,
●
the current fuel consumption,
●
the Stop & Star t time counter.


- The tri
p "1"
tab with:
●
the distance travelled.
●
the average fuel consumption,
●
the average speed,
for the first trip.
-
The trip "2"tab with:
●
th
e distance travelled.
●
the average fuel consumption,
●
the average speed,
for the second trip.




Trip reset
)When the desired trip is displayed, press
the reset button or on the end of the wiper
control stalk.
Trips "1"
and "2"are independent but their useis identical.
For example, trip "1"
can be used for daily figures, and trip "2"
for monthly figures. Th
e information is accessible in the " Driving assistance " menu.
Temporary display in a new window: )Press the end of the wiper control stalk for access to the information and display the different tabs.

1
59
Monitoring




Tr i p c o m p u t e r
Type 2 instrument panel


Information display in the instrument panel
)Press the button on the end of the wiper control stalk
to display the various tabs insuccession.- Th
e current information tab with:


●
the range,

●
the current fuel consumption,

●
the Stop & Star t time counter.
- Tr i p "1"
with:


●
the avera
ge speed.

●
the average fuel consumption,

●
the distance travelled, for the first trip.
-
Trip "2"
with:


●
t
he average speed,

●
the average fuel consumption,

●
the distance travelled,
for the second trip.





Tr ip reset
)
When the trip required is displayed, press
the control for more than two secondsor use the left hand thumb wheel of the steering mounted controls.
Trips "1"
and "2"are independent but their use
is identical.
For example, trip "1"can be used for daily figures, and trip "2"for monthly figures.
For all other display modes, pressing the end
of the wiper stalk displays this information in anew window. The displa
y of trip computer information ispermanent when you select the "DIALS"
display mode.

70
Access
Remote control problem -
reinitialisation
Changing the battery of the electronic key
Battery ref.: CR2032 / 3 volts.
A message appears in the instrument panel
screen when replacement of the battery is
needed. ) Unclip the cover using a small screwdriver at the cutout. )
Lift off the cover.)
Remove the flat battery from its location.)
Fit the new battery into its location observing the original direction of fitment.
)
Clip the cover onto the casing. Followin
g disconnection of the vehicle battery, replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.)Place the mechanical key (integral with theremote control) in the lock to unlock your
vehicle.)Place the electronic key in the reader.)Switch on the ignition by pressing STA R T/STOP.
The electronic key is fully operational again.
If the problem persists, contact a CITRO

72
Access
Manual central
locking














Central locking
)Press this button to operate the centrallocking of the vehicle (doors and boot) from inside the vehicle. )Pressing the button again unlocks the
vehicle completely.



Automatic central locking
of doors
(anti-intrusion
securit
y)
The doors and boot lock automatically when
driving, as soon as the speed exceeds 6 mph
(10 km/h).
To activate or deactivate this function (activated
by default): )with the ignition on, press this button until a message appears in the instrument panel.
When locking / deadlocking from the outsideIf the vehicle is locked or deadlockedfrom the outside, the button is notactive. )After normal locking, pull one of theinterior door handles to unlock thevehicle.)After deadlocking, you have to usethe remote control, the Keyless Entry and Starting system or the integralkey to unlock the vehicle.



If one of the doors or the boot is open, automatic central locking does not complete: the sound of the locksrebounding can be heard.
Transporting long or voluminousobjects
If you want to drive with the boot open but the vehicle's side doors locked, press the central locking control buttonto lock the doors.

Driving with the doors locked may makeaccess to the passenger compartmentby the emergency services moredifficult in an emergency.

73
2
Access





Doors


Opening


From outside
)After unlocking the vehicle using theremote control or the Keyless Entry and Starting system, pull the door handle.

From inside
)
Pull the front or rear door lever to open thedoor.

I
f a door is not properly closed:- with the engine running
, this warning lamp and a message
appear in the instrument panel
(type 1) for a few seconds,-when driving(speed above 6 mph (10 km/h)), thiswarning lamp and a message,
accompanied by an audible
signal, appear in the instrument
panel
(type 1 and type 2) for a
few seconds.

Closing