Page 85 of 420
83
2
Access
Reinitialisation of the
electric windows
Deactivating the rear controls for the rear windows
In the event of contact during operationof the windows, you must reverse themovement of the window. To do this,press the switch concerned.
When operating the passenger electricwindow switches, the driver mustensure that nothing is preventingcorrect closing of the windows.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operatingthe windows.
Be aware of passengers or other persons present when closing thewindows using the the electronic key or the "Keyless Entry and Starting" system.
Followin
g reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch function is not active
during these operations. For the safety of your children, pressswitch 5to prevent operation of the rear windows irrespective of their positions.
The warnin
g lamp in the button comes on,
accompanied by a message confirmingactivation. It remains on, as long as the childlock is deactivated.
Use of the rear electric windows from thedriver's controls remains possible.F
or each window:
- lower the window completely, then raise it,
it will rise in steps of a few centimetres with each action. Repeat the operation until the
window closes completely,
- continue to
pull the switch for at least one second after reaching this position, windowclosed.
Page 89 of 420
87
3
Comfort
System which registers the electrical settings of the driver's seat and door mirrors. It enables you to store and recall two positions using the buttons on the side of the driver's seat.
Storing driving positions
Storing a position
Usin
g buttons M / 1 / 2
) Switch on the ignition. )
Adjust your seat and the door mirrors. )
Press button M
, then press button 1or 2
within four seconds.
An audible signal indicates that the position
has been stored.
Storing a new position cancels the previousposition.
Recalling a stored position
I
gnition on or engine running
)
Press button 1or 2to recall the corresponding position.
An audible signal confirms that adjustment
is complete.
You can interrupt the current movement b
ypressing button M, 1
or 2
or by using one of theseat controls.
A stored position cannot be recalled while driving.
Recalling stored positions is deactivated
45 seconds after switching off the ignition.
Page 106 of 420
104
Comfort
Vent ilat ion
The air circulating in the passenger compartment
is filtered and originates either from the outside via
the
grille located at the base of the windscreen or from the inside in air recirculation mode.
Air treatment
The incoming air follows various routes
depending on the controls selected by thedriver:
- direct arrival in the passenger compartment (air intake),
- passage through a heating circuit (heating),
- passage through a cooling circuit (air conditioning).
Control panel
The controls of this system are accessible
in the " Air conditioning " menu of the touchscreen tablet A .
The demisting/defrosting controls for the
windscreen and rear screen are located on theleft of the touch screen tablet.
1.Windscreen demisting-defrosting vents.2. Front quar ter light demisting-defrosting
vents. 3. Front side window demisting/defrosting
v
ents.
Adjustable side air vents.
4. Central adjustable air vents.
5. Air outlets for the front footwells.
6.Side vents for the 2nd row.
7. Air outlets for 2 nd
row footwells.
8.Sunshine sensor.
Air distribution
Page 108 of 420
106
Comfort
Heating
Temperature adjustment
)
Press one of these buttons,or move the cursor from blue (cold) to red (hot) to adjust the
temperature to your wishes.
Air flow adjustment
) Press one of these buttons toincrease or decrease the speedof the booster fan.
Air distribution adjustment
The intake of exterior air prevents and eliminates misting of the windscreen and side
windows.
The recirculation of interior air prevents exterior
odours and smoke enterin
g the passenger compartment. Win
dscreen.
Footwells.
Centre and side vents. The air distribution can be varied b
y using more
than one button.
Each press of a button activates or deactivates
th
e function.
The indicator lamp is on when the button is activated. For an even distribution of air in the passenger compar tment, the three buttons can
be activated simultaneously.
Air intake / Air recirculation
)
Press this button to recirculate
the interior air. The indicator lamp
in the button comes on. ) Press the button again to allow
the intake of exterior air. This is confirmed by the indicator lamp going off.
Avoid driving for too long withoutventilation (risk of misting and deterioration of air quality).
The heatin
g system works only when theengine is running.
Press the button for the " Air conditioning"menu to display the page for the system
controls. The s
ymbol for air flow (a fan) fills progressively
according to the air flow setting made.
By reducing the air flow to the minimum, you
are stopping ventilation of the passenger
compartment.
Page 109 of 420
107
3
Comfort
Dual-zone manual air conditioning with temperature regulation
The air conditioning system operates with the engine running.
The temperature at the nozzles and vents
is re
gulated by the system according to the
temperature in the passenger compartment
and the temperature setting.
Press the button for the " Air conditioning"menu to display the system controls page.
Temperature adjustment
)
Press one of these buttons toreduce (blue) or increase (red)the value.
Air flow adjustment
Press one of these buttons to
increase or decrease the speed of
the air booster fan. The driver and
front passenger can each adjust
the temperature.
The value indicated corresponds to a level of comfor t and not to a temperature in degrees Celsius
or Fahrenheit (depending on the unit selected). A setting of around 21 provides optimumcomfort. Depending on your requirements, a
setting between 18 and 24 is normal.
In addition, it is recommended that a di
fference
between left and right of more than 3 should beavoided. The air
flow symbol (a fan) fills progressivelyaccording to the quantity of air wanted.
By reducing the air flow to minimum, you arestopping ventilation.
Avoid driving too long without ventilation(risk of misting and deterioration of air quality).
Page 111 of 420
109
3
Comfort
Dual-zone digital air conditioning
This air conditioning system operates with the engine running, but the ventilation and its controls
are available with the ignition on.
Operation of the air conditioning and regulation of temperature, air flow and air distribution in the passenger compartment are automatic.
Press the button for the " Air conditioning" menu to display the controls for the air conditioningsystem.
Temperature adjustment
1.
Automatic mode. 2.Driver's side temperature adjustment.3.Passenger's side temperature adjustment. The driver and
front passenger can each set
t
he temperature.
)Press one of these buttons
to increase the value.
)Press one of these buttons
to decrease the value.
The value indicated corresponds to a level of
comfor t and not to a precise temperature.
It is recommended that
you avoid a left /right setting difference of more than 3.
Dependin
g on the colour scheme chosen, the system controls page is displayed differently:
4.
Air conditioning On / Off.
5. Air distribution adjustment.6.
Air flow adjustment. 7.
Air intake / air recirculation.
Page 115 of 420
113
3
Comfort
"Rear" function
)Press this button to activate / deactivate the "Rear" function
The indicator lamp in the button
i
s on when the function is activated.
Settings for
passengers in the
3 rdrow of seats
From the secondary page of the " Airconditioning " menu: This
function gives rear passengers access to
t
he adjustment controls and allows.
- the distribution of air conditioned air to the
vents for the 2 nd row of seats,
- the distribution of ambient air to the vents
for the 3rdrow of seats.
)
Turn the upper wheel to open or close therear vent. )
Turn the lower knob to reduce (to the left)
or increase (to the right) the air flow.
Settings for passengers in
the 2ndrow of seats
) Press the vent cover. )
Adjust the flow of air to the two vents usingthe four-position wheel (off, low, medium, high).
)
Direct the vent by turning the cover.
Page 124 of 420
122
Comfort
12 V acc essory socket
The auxiliary socket is located in the central
storage box.
It permits the connection of a por table device,
such as a di
gital audio player of the iPod® type,®
to listen to your music files using the vehicle's
speakers.
The management of the files is done using your
por table device. Dependin
g on equipment, one or two USBports are located in the central storage box.
They allow the connection of a por table device
or a USB memory stick.
They read the audio files which are transmitted
to your audio equipment and played via the
vehicle's speakers.
You can manage these files using the steeringmounted or touch screen tablet controls.
Auxiliary socket USB ports
For more information on the use of thisequipment, refer to the "Audio and telematics"section.
When a USB por t is used, the por tabledevice charges automatically.
Only the right hand USB por t can be used to connect an Apple®
player or the ®
"CITROËN MULTICITY CONNECT" connection key.
)To connect a 12 V accessory (maximum power: 120 Watts), lift the cover andconnect a suitable adaptor.
