2013 Citroen C3 PICASSO RHD Owner's Manual

11
Practical information
167
Changing the LED lamps
For the replacement of this type of LED lamp,contact a CITROËN dealer or a qualified
workshop.
Changing integral direction indicator side repeaters
To obtain a new module, contacta CITROËN dealer or a qualified workshop.


If you experience any difficulty in replacing these lamps, you can contact a CITROËN dealer or a qualifiedworkshop.

While removing the module:


- take care not to damage your vehicle's
paintwork with the screwdriver,

- do not allow the wiring and connector to slip behind the wing.
To r e f i t , c a r ry out these operations in reverseorder.
)
Inser t a screwdriver in the edge of therepeater.)
Lever with the screwdriver to extract therepeater and pull it out. )
Disconnect the wiring from the repeater.)
Replace the module.

Practical information
168
Rear lamps
1.Brake lamps / sidelamps (12VP21/5 W).2.Foglamp, right-hand side (PR21W) Reversing lamp, left-hand side (P21W).3.Direction indicators (P21W)
Changing brake lamp / sidelamp and direction indicator bulbs
)turn the bulb holder a quar ter turn, )remove the failed bulb and replace it.
To r e
fit, carry out these operations in reverse order.
)
unscrew the two lamp fixing bolts, )
extract the lamp carefully pulling it
straight out,

11
Practical information
169

Changing foglamp / reversing lamp bulbs
)
open the boot,)
press on the tabs using 2 screwdrivers,)
disconnect the lamp connector,
)
turn the bulb holder by a quar ter turn,)
remove the bulb and replace it.
To r efit, carry out these operations in reverseorder.
Changing the third brake lampbulbs (4 W5W bulbs)
)
open the boot,)
remove the two plugs located on the bootinner panel,
)
press on the body of the lamp with
2 screwdrivers to remove it from its
housing, ) turn the corresponding bulb-holder a quarter turn, )
pull the bulb out and replace it.
To r e f i t , c a r ry out these operations in reverse order.

Changing the number plate lamp
bulbs (W5W)
) insert a thin screwdriver into one of the lens' exterior holes,)
push it outwards to unclip.
)
remove the lens. )
pull the bulb out and replace it.
To r efit, carry out these operations in reverseorder.

Practical information
170
Interior lighting
Interior lamps (1 / W5W)
Detach the cover of the interior lamp 1 with athin screwdriver, close to the button, to access
the faulty bulb.
Map reading lamps (2 / W5W)
Detach the cover of the interior lamp. To access
the faulty bulb, detach the par tition for thereading lamp 2concerned, as necessary.

Footwell lamps (W5W)
Unclip the cover using a thin screwdriver to
access the faulty bulb.

Front courtesy lamp mood
lighting LED
For the replacement of the LED, contact a CITROËN dealer or a qualified workshop.

11
Practical information
171

To r c h (Krypton 3.6V)
)Open the tab.)Push with a flat screwdriver in the holeunder the tab and recover the bulb unit.)Open the bulb unit fully to change the bulb.

Door mirror lamps (W5W)
Unclip the cover using a thin screwdriver toaccess the faulty bulb.



Boot lamps (W5W)
Detach the unit by pushing it rear wards.

Practical information
172




















Changing a fuse
The extraction tweezer and the spare fusestorage compar tment are installed on the backof the dashboard fusebox cover.
For access to them:)Open the glove box,)unclip the fuse access cover by pulling on
the side, )remove the cover completely,)remove the tweezer.



Changing a fuse

Before changing a fuse, the cause of the failure
must be identified and rectified. ) Identify the failed fuse by checking thecondition of its filament.
)
Use the special tweezer to extract the fuse from its housing.)
Always replace the faulty fuse with a fuse of the same rating.)
Check that the number marked on thefusebox, the rating marked on the fuse and
the following tables all agree.
GoodFailed
CITROËN will not accept responsibilityfor the cost incurred in repairing your vehicle or for rectifying malfunctions resulting from the installation of accessories not supplied and notrecommended by CITROËN andnot installed in accordance with its instructions, in par ticular when thecombined consumption of all of the additional equipment connectedexceeds 10 milliamperes.



Installing electricalaccessories
Your vehicle's electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories on your vehicle, contact a CITROËN dealer or aqualified workshop.
Access to the tools

11
Practical information
173

Dashboard fuses

The fusebox is located in the glove box.


Access to the fuses
)
refer to the paragraph "Access to the tools".

Fuse tables
Fuse N°RatingFunctions
FH36 5
A Tr a i l e r r e l ay unit.
FH3
715 A Trailer accessories socket supply.
FH3
820 A Navigation.
FH39
- Not used.
FH4
030 A Tr a i l e r r e l ay unit.
Fuse N°RatingFunctions
F115 A Rear wiper.
F2
- Not used.
F3
5 A Airbags and pretensioners control unit.
F410 A Steering wheel angle sensor, air conditioning, clutch switch,
par ticle filter pump, diagnostic socket, air flow meter.
F530 A Electric windows panel, passenger's electric window control,
front electric windows motor.
F
630 A Rear electric windows motor and driver's electric window motor.
F7
5 A Courtesy and front map reading lamps, torch, rear reading lamps.

Practical information
174
Fuse N°RatingFunctions
F8
20 A Multifunction screen, audio system, navigation radio.
F
930 A
Audio system (fitted as an option), 12 V socket.
F1
015 A Steering mounted controls.
F1115 A
Ignition, diagnostic socket.
F12 15 A
Rain / sunshine sensor, trailer rela
y unit.
F13 5
A Main stop switch, engine relay unit.
F1415 A Parking sensors control unit, seat belt unfastened warninglamp, airbag control unit, instrument panel, air conditioning,USB Box.
F1
530 A
Locking.
F1
6- Not used.
F1740 A
Rear screen and door mirrors demist/defrost.
S
H- PA RC shunt.