.Familiarisation
13
Lighting
Ring A
Ring B
Raise or lower the lighting stalk passing thepoint of resistance; the corresponding directionindicators will flash for as long as the stalkremains in this position.
Direction indicators
Switching on "AUTO" mode
)Press the stalk down and release it.
Ring B: rear wiper
8188 Li
ghting off.
Automatic illumination of headlamps.
Sidelamps.
Dipped / main beam headlamps.
Rear
foglamp.
or
Front and rear
foglamps. P
ark.
Intermittent wipe.
Wash-wi
pe.
Control stalk A: windscreen wipers
Wipers
Switching off "AUTO" mode
)
Push the stalk up and return it to position "0".
114
"Motorway" function
Press the lighting stalk up or down once,without passing the point of resistance; thecorresponding direction indicators will flash
three times.
You can use this function at any speed, but it is particularly useful when changing lane on high-
speed roads.
Seeing clearly
87
89
80
Practical information
164
Changing a bulb Procedure for replacing a faulty bulb with a new bulb.
1.Direction indicators (H21W amber).2.Dipped beam headlamps (H7-55W).3. Main beam headlamps (H1- 55W).4.Sidelamps (W5W).5.Foglamps (PSX24W).6.LED daytime running lamps.
Front lamps
The headlamps are fitted withpolycarbonate glass with a protectivecoating: )do not clean them using a dryor abrasive cloth, nor with adetergent or solvent product, )use a sponge and soapy water or apH neutral product, )when using a high pressure washer on persistent marks, do not keepthe lance directed towards thelamps or their edges for too long,so as not to damage their protectivecoating and seals, )do not touch the bulb directly withyour fingers, use lint-free cloths.
Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of seriousburns).It is imperative to use only anti-ultraviolet (UV) type bulbs in order not to damage the headlamp.
Always replace a failed bulb with anew bulb with the same type and specification.
