Page 130 of 284
Driving
128
6-speed electronic gearbox system
Six-speed electronic gearbox system which
offers a choice between the comfor t of fully automatic operation or the pleasure of manualgear changing. There are two driving modes: -automatedmode for automatic control
of the gears by the gearbox, without anyaction on the par t of the driver
- manualmode for sequential gear changingby the driver using the gear lever or the
steering mounted paddles.
In automated mode, you can temporarily take
over control of gear changing.
Gear lever
R.
Reverse )
With your foot on the brake, move the gear lever forwards to select this position.
N.Neutral. ) With your foot on the brake, select this
position to start.
A. Automated mode. )
Move the lever backwards to select this
m
ode. M + / -.
Manual mode with sequential gear changing. )
Move the lever backwards then to the left
to select this mode, then:
●
give a push for wards to change up,
●
or give a push rear wards to change down.
+. Paddle to the right of the steering wheel for changing up. )Press the back of the "+"
steering mounted paddle to change up a gear.-.
Paddle to the left of the steering wheel for changing down. )Press the back of the "-"steering mounted paddle to change down a gear.
Steering mounted control paddles
The steering mounted paddles cannotbe used to select neutral or to engageor disengage reverse gear.
Page 138 of 284
Driving
136
Speed limiter
The controls of this system are grouped
together on stalk A.1. Speed limiter mode selection thumb wheel. 2.
Value decrease button.3.Value increase button.4.
Speed limiter on / off button.
The pro
grammed information is grouped
together in the instrument panel screen.
5.Speed limiter on / off indication.
6. Speed limiter mode selection indication.7.Programmed speed value.
Steering mounted controls
Displays in the instrument panel
The speed limiter is switched onmanually:
it requires a programmed speed of at least
20 mph (30 km/h).
The speed limiter is switched off by manual foperation of the control.
The programmed speed can be exceeded
temporarily by pressing the accelerator firmly.To return to the programmed speed, simply slow down to a speed below the programmed speed.
The pro
grammed speed remains in the memorywhen the ignition is switched off.
The speed limiter cannot, in any circumstances,
replace the need to respect speed limits, nor can it replace the need for vigilance and responsibilityon the par t of the driver.
System which prevents the vehicle fromexceeding the speed programmed by the driver.
When the programmed speed limit is reached, pressing the accelerator pedal in the normalmanner no longer has any effect.
Page 154 of 284
Practical information
152
Temporary puncture repair kit
Description of the kit
A.
"Sealant" or "Air" position selector.
B. On "I"
/ off "O"
switch.C.
Deflation button. D.Pressure gauge (in bar or p.s.i.). E.Compartment housing:
- a cable with adaptor for 12 V socket,
- various inflation adaptors for
accessories, such as balls, bicycle
t
yres...F
.Sealant car tridge.G. White pipe with cap for repair.
H. Black pipe for inflation.I.
Speed limit sticker.
Access to the kit
This kit is installed in the storage box, under
the boot floor.
The speed limit sticker Imust be affixed to the vehicle's steering wheel to remind you that a wheel is in temporary use.
Do not exceed a speed of 50 mph (80 km/h) when driving with a tyre repaired using this type of kit. Complete s
ystem consisting of a compressor and a sealant car tridge which permits
temporary repair of a tyre so that you can rdrive to the nearest garage.It is designed to repair most punctures which could affect the tyre, located on the tyre tread or shoulder.
Page 176 of 284
Practical information
174
Dashboard fuses
The fusebox is placed in the lower dashboard(left-hand side).
Access to fuses
)
refer to the paragraph "Access to tools".
Fuse tables
Fuse N°RatingFunctions
FH3
65 A Tr a i l e r r e l ay unit.
FH37 15 A
Trailer accessories socket supply.
FH3
820 A Aftermarket navigation.
FH39
20 A Heated seats.
FH4
030 A Tr a i l e r r e l ay unit.
Fuse N°RatingFunctions
F115 A Rear wiper.
F2
- Not used.
F
35 A Airbags and pretensioners control unit.
F410 A Steering wheel angle sensor, air conditioning, clutch switch, par ticle filter pump, diagnostic socket,airflow meter.
F530 A Electric window switch panel, passenger's electric windowcontrol, front electric window motor.
F
630 A
Rear electric window motor and driver's electric window motor.
F7 5
A Courtesy and front map reading lamps, glove box lighting,
torch, rear reading lamps.
Page 177 of 284
11
Practical information
175
Fuse N°RatingFunctions
F
820 A Multifunction screen, audio system, navigation radio.
F
930 A Audio system (aftermarket), 12 V socket.
F1
015 A Steering wheel controls.
F1115 A
Ignition, diagnostic socket.
F12 15 A
Rain / sunshine sensor, trailer rela
y unit.
F1
35 A Main stop switch, engine relay unit.
F1415 A Parking assistance control unit, seat belt unfastened warninglamp, airbag control unit, instrument panel, air conditioning,USB Box.
F1
530 A Locking.
F1
6- Not used.
F1740 A
Rear screen and door mirrors demist/defrost.
S
H- PA RC shunt.
Page 186 of 284
Practical information
184
Towing the vehicle
Access to the tools
The towing eye is installed under the boot floor.
To gain access to it: )open the boot, )remove the adjustable boot floor, )lift up the boot carpet, )remove the towing eye from the tool holder.
Procedure for havin
g your vehicle towed or for towing another vehicle using a removable towing eye.
General recommendations
Obser ve the legislation in force in your country. Ensure that the weight of the towing vehicle is higher than that of the towed vehicle. The person at the wheel of the towed vehicle must have a valid driving licence.When towing a vehicle with all four wheels on the ground, always use an approved towing bar; rope and straps are prohibited. When towing a vehicle with the engine off, there is no longer any power assistance for braking or steering. In the following cases, you must always call on a professional recovery service: - vehicle broken down on a motor way or fast road, - 4 wheel drive vehicle, - when it is not possible to put the gearbox into neutral, unlock the steering, or releasethe parking brake,- towing with only two wheels on the ground, - where there is no approved towing bar available...
Page 190 of 284
Practical information
188
"Comfort":
front and rear parking sensors, insulated module, reading lamp, sun blinds, head restraint-mounted coat hanger, centre armrest, air deflector, scented air freshener car tridges, portable ashtray, solar films for windows...
"Protection":
mats *
, seat covers, mudflaps, bumper protectors, vehicle protective cover, dog guard,pet seat and boot covers...
"Transport solutions":
boot liner, boot carpet, towbar, towbar wiring harness, transverse and longitudinal roof
bars, bicycle carrier, ski carrier, roof box, bootspacers, boot net, business/commercial vehicle
conversion kit, sliding boot floor...
"Safety and security":
anti-theft alarm, warning triangle, high visibility
vest, breathalyzer, first aid kit, snow chains,
non-skid covers, security wheel bolts, vehicle
tracking system, child seats, fire extinguisher,
caravan mirror, glass security films...
"Style":
allow wheels, chromed mirror shells, leather
steering wheel, gear lever knob, aluminium
footrest, wheel caps...
Accessories A wide range of accessories and genuine par ts is available from the CITROËN dealer network.
These accessories and par ts have been tested and approved for reliability and safety.
They are all adapted to your vehicle and benefit from CITROËN's recommendation and warranty.
*
To avoid any risk of jamming of the pedals:
- ensure that the mat is positioned and
secured correctl
y,
- never fit one mat on top of another.
Page 236 of 284
234
07RADIO
By alphabetical list
Pr
ess RADIO, select the station of your choice and confi rm.
B
y automatic frequency search
Press or
for the automatic searchfor a lower or higher radio frequency.
Or turn the thumb wheel at the steeringmounted controls.
B
y manual frequency search
Pr
ess
or
to adjust the radio
frequency step by step.
SELECTING A STATION
The external environment (hill, building, tunnel, underground car park...) may interfere with the reception, including in RDS station tracking mode. This phenomenon is a normal result of the way in which radio waves are transmitted and does not in any way indicate a fault with the audiosystem.
The qualit
y of reception is represented by the number of
active waves in this symbol.
Pr
ess RADIO
or OK
to display the contextual menu.
CHANGING BAND
Select "Change waveband".
Select "AM / FM" and confi rm.
