2013 Citroen C3 key battery

Access
68
Remote control problem
Reinitialisation
)
Switch off the ignition. )
Turn the key to position 2 (Ignition on)
. )
Press the closed padlock immediately for a few seconds. )
Switch off the ignition and remove the key from the ignition switch.
The remote control is full
y operational again.


Changing the battery

Battery ref.: CR1620 / 3 volts.
If the batter
y is flat, you are informed by illumination of this warning lamp,
an audible signal and a message in
the multifunction screen.
)Unclip the casing using a coin at the notch. )Slide the flat battery out of its location.)Slide the new battery into its location
observing the original direction. )Clip the casing. )Reinitialise the remote control.


Switching the vehicle off


Key reminder

If the key is left in the ignition switch, an audible signal sounds when the driver's door is opened.

Do not attach any heavy objects to the key as this could weigh down on it when in the ignition switch and cause a fault. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or
in the event of a remote control malfunction,you can no longer unlock, lock or locate your
v
ehicle. ) First of all, use the key in the lock to unlock or lock your vehicle.)
Then, reinitialise the remote control.
If the problem persists, contact a CITRO

Access
74
Emergency control

Locking the driver's door
)
Inser t the key in the lock, then turn it to the
right.
Unlocking the driver's door
)
Inser t the key in the lock, then turn it to theleft.


Locking the front and rear passenger doors
)Remove the black cap, located on the edge
of the door, using the key. )Insert the key in the socket, then turn it to
the stop.)Remove the key and refit the cap.



Unlocking the front and rear passenger doors
)Pull the interior door opening control.
In the event of failure of the centrallocking system, the battery must bedisconnected to lock the boot and so ensure that the vehicle is locked completely.
Check that the rear doors child lock is not on.
System allowing the doors to be locked andunlocked manually in the event of a fault with
the central locking system or a battery failure.
Activation
)Press button Afor more than two seconds.
A confirmation message appears on themultifunction screen, accompanied by an audible signal.
Deactivation
)Press button Aagain for more than
two seconds.
A confirmation message appears on themultifunction screen, accompanied by an audible signal.


Driving with the doors locked may make access more difficult for the emergency services in an emergency.

4
Access
75











Boot
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.
)
Lower the tailgate using the interior grab
handle.
-when the engine is running, this
warning lamp comes on, accompanied
b
y a message on the multifunctionscreen for a few seconds,
Tailgate release
Unlocking
)
Fold back the rear benchseat to gainaccess to the lock from inside the boot.)
Insert a small screwdriver into hole Aof thelock to unlock the tailgate.

I
f the tailgate is not closed correctly:

Opening Closing
-when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
a messa
ge on the multifunction screen for a few seconds.
System for mechanical unlocking of the boot
in the event of a battery or central locking
malfunction.

Driving
124
The Stop & Star t system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restar ts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
-with a manual gearbox , at speeds below
12 mph (20 km/h), when you put the gear lever into neutral, and you release theclutch pedal. - with a 5 or 6-speed electronic gearbox
, at speeds below 5 mph (8 km/h), when you press the brake pedal or put the gear lever in position N.
Going into engine STOP mode

The "ECO"warning lamp comes
on in the instrument panel and the engine goes into standby:

A time counter calculates the sumof the periods in STOP mode
during a journey. It rests itself
to zero every time the ignition is switched on with the key.


Special cases: STOP mode not available
STOP mode is not invoked when:


- the driver's door is open,

- the driver's seat belt is not fastened,

- the vehicle has not exceeded 6 mph
(10 km/h)since the last engine star t using the key,

- the engine is needed to maintain acomfor table temperature in the passenger compartment,

- demisting is active,

- some special conditions (battery charge, engine temperature, braking assistance,
ambient temperature...) where the engine isneeded to assure control of a system.

The "ECO"warning lamp flashes for
a few seconds then goes off.
This operation is per fectly normal.











Stop & Start
Never refuel with the engine in STOPmode; you must switch off the ignition with the key.
For your comfor t, during parkingmanoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...

Driving
126

Operating fault
Maintenance

In the event of a fault with the system, the
"ECO OFF"
switch warning lamp flashes thencomes on continuously.
Have it checked by a CITROËN dealer or aqualified workshop.
In the event of a fault in STOP mode, the
vehicle ma
y stall. All of the instrument panel
warning lamps come on. It is then necessary
to switch o
ff the ignition and star t the engine
again using the key. This s
ystem requires a battery with a specialspecification and technology (reference numbers available from a CITROËN dealer or a qualified workshop).
Fitting a battery not listed by CITROËN
introduces the risk of malfunction of the system.
Press the "ECO OFF"switch again.
The system is active again; this is con
firmed
by the switch warning lamp going off,accompanied by a message in the screen.

Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting from automatic operation of STA R T m o d e .


The system is reactivated automaticallyat every new star t using the key.


The Stop & Star t system makes use of advanced technology. All workon this type of battery must be doneby a CITROËN dealer or a qualifiedworkshop.
Reactivation

.
Visual search
271
Remote control key 66-69 - opening/closing - anti-theft protection - starting - battery

Exterior
Lighting controls 79-83 Headlamp adjustment 83Changing bulbs 157-160- front lamps - foglamps- direction indicator repeaters
Door mirrors 64
Doors 72-74 - opening/closing - central locking - emergency controlChild lock 104 Electric windows 70-71


Accessories 182-183
Wiper controls 84-86 Changing a wiper blade 175
Boot 75 Te m p o r a ry puncture repair kit 144-148 Changing a wheel 149 -155 - tools- removing/refitting


Changing bulbs 161-162 - rear lamps - 3 rd
brake lamp - number plate lamps

Rear parking sensors 132-133 Reversing camera 134 To w b a r 178-179 To w i ng 176 -17 7


Hill start assist 127
Braking assistance 107
Tr ajectory control 108
Tyre pressures 144, 194Fuel tank 76 -77Misfuel prevention 78