2013 AUDI A5 COUPE ECO mode

248 Tires and wheels
driving a few yards and correct if neces­
sary. Follow the instructions from the
snow cha in manufacturer when doing so.
(D Tips
Where snow chains are mandatory oncer ­
tain roads, this normally also applies to
vehicles with all wheel drive.
Wheel bolts
Wheel bolts must always be tightened to the
correct torque.
The design of whee l bolts is matched to the
factory installed rims. If different rims are fit­
ted, the correct wheel bolts with the right length and correctly shaped bolt heads must
be used. This ensures that wheels are fitted
securely and that the brake system functions
correctly .
In certain circumstances, you may not use
wheel bolts from a different vehicle -even if it
is the same model
¢ page 275.
.&_ WARNING
Improperly tightened or maintained wheel
bolts can become loose causing loss of
control, a collision and serious persona l in­
Jury.
- Always keep the wheel bolts and the
threads in the wheel hubs clean so the
wheel bolts can turn easily and be prop­
erly tightened.
- Never grease or oil the wheel bolts and
the threads in the wheel hubs. They can
become loose while driving if greased or
oiled, even if tightened to the specified
torque.
- Only use wheel bolts that belong to the
rim being installed.
- Never use different wheels bolts on your
vehicle.
- Always maintain the correct tightening
torque for the wheel bolts to reduce the
risk of a wheel loss . If the tightening tor­
que of the wheel bolts is too low, they
can loosen and come out when the veh i- cle
is moving.
If the tightening torque is
too high, the wheel bolts and threads
can be damaged and the wheel can be­
come loose.
(D Note
The specified torque for the whee l bolts is
90 ft lbs . (120 Nm) with a tolerance of
± 7,4 ft lbs. (± 10 Nm). Torque wheel bolts
diagonally . After changing a wheel, the
torque must be checked as soon as possi­
ble with a torque wrench -preferably by an
authorized Audi dealer or qualified work­
shop.
Low aspect ratio tires
Your Audi is factory -equipped with low aspect
ratio tires. These tires have been thoroughly
tested and been se lected specifically for your
model for their superb performance, road feel
and handling under a variety of driving condi­
t ions . Ask your authorized Audi dealer for
more details .
The low aspect ratio of these tires is indicated
by a numeral of
55 or less in the tire's s ize
designation . The numeral represents the ratio
of the tire's sidewall height in relation to its
tread width expressed in percentage. Conven­
tional tires have a height/w idth rat io of 60 or
more.
The performance of low-aspect-ratio tires is
particularly sensitive to improper inflation
pressure. It is therefore important that low
aspect ratio tires are inflated to the specified
pressure and that the inflation pressure is
regularly checked and maintained. Tire pres­
sures should be checked at least once a
month and always before a long trip
¢ page 237, Checking tire pressure.
What you can do to avoid tire and rim
damage
Low aspect ratio tires can be damaged more
easily by impact with potholes, curbs, gul lies
or ridges on the road, particularly if the tire is
underinflated . ..,.

264 Emergency situations
@ Tips
The discharged battery must be properly
connected to the vehicle's electrical sys­
tem. When jump starting or charging the
battery, never connect the negative
ground cable to the battery negative post
because the batte ry manager system must
be able to detect the battery 's state of
charge. Always connect the negative
ground cab le to the negative ground post
of the battery manager control unit.
Use of jumper cables
Make sure to connect the jumper cable
clamps in exactly the order described below!
Fig. 195 Engine compartment: Connecto rs fo r jum per
cables and charger
Fig. 196 Jump sta rting wi th the battery of anot her ve ·
h ide :@ booster battery, @ disc harged vehicle battery
The procedure described below for connecting
jumper cables is intended to provide a jump
start for your vehicle .
Vehicle with discharged battery:
.. Turn off lights and accessories, move lever
of automatic transmission to N (Neutral) or
P (Park) and set parking brake .
Connect POSITIVE(+) to POSITIVE(+)
(red)
.. Remove the cover above the jump start con­
nection .
.. Open the red
cover on the positive pole
¢fig. 195.
1. Connect one end of the red positive cable
on the
jump start bolt c::> fig. 196 @
(Bolts under red cover= "positive") of the
vehicle to be started @.
2. Connect the other end to the positive ter-
mina l@ of the booster battery@.
Connect NEGATIVE (-) to NEGATIVE (-)
(black)
3. Connect one end of the b lack negative ca­
ble to the negative terminal @of the
booster battery @.
4. Connect the other end to the
jump start
bolt @
(Bolts with hex head= "negative")
of the vehicle to be started ®·
Starting the engine
.. Sta rt the engine of the vehicle with the
booster battery@. Run the engine at a
moderate speed.
.. Start engine with discharged vehicle battery
® in the usual manner .
.. If the eng ine fails to start: do not keep the
starter cranking for longer than 10 seconds .
Wait for about 30 seconds and then try
again .
.. With engine running, remove jumper cables
from both vehicles in the exact
reverse or­
der .
.. Close the red
cover on the positive pole .
T he battery is vented to the outside to prevent
gases from entering the vehicle interior . Make
sure that the jumper clamps are well connect­
ed with their
metal parts in full contact with
the battery terminals.
A WARNING
--
To avoid serious personal injury and dam­
age to the veh icle, heed all warnings and
i nstructions of the jumper cable manufac-
turer . If in doubt, call for road service . ..,.

Consumer Information
Warranty coverages
Your Audi is covered by the following war­
ranties :
- New Vehicle Limited Warranty
- Limited Warranty Against Corrosion Perfo-
ration
- Emissions Control System Warranty
- Emissions Performance Warranty
- California Emissions Control Warranty (USA
vehicles only)
- California Emissions Performance Warranty
(USA vehicles only)
Detailed information regarding yo ur warran ­
ties can be found in your
Warranty & Mainte­
nance booklet .
Operating your vehicle
outside the U.S.A. or
Canada
Government regulations in the United States
and Canada require that automobiles meet
specific emission regulations and safety
standards. Therefore, veh icles built for the
U.S.A. and Canada differ from vehicles sold in
other countries .
I f you p lan to take your vehicle outside the
continental limits of the United States or Can­
ada, there is the possibility that:
- unleaded fuels for vehicles with cata lytic
converter may not be available;
- fuel may have a considerably lower octane
rating . Improper fuel may cause engine
damage;
- service may be inadequate due to lack of
proper service facilities, tools or testing
equipment;
- replacement parts may not be readily availa­
ble.
- Navigation systems for vehicles built for the
U.S.A. and Canada will not necessari ly work
in Europe, and may not work in other coun­
tries outside of North America.
Consumer Information 273
@ Note
Audi cannot be responsible for mechanical
damage that could result from inadequate
fuel, serv ice or parts availab ility.
Audi Service Repair
Manuals and Literature
Audi Offic ial Factory Service Manuals and Lit ­
erature are published as soon as possible after
model introduct ion. Service manuals and lit­
erat ure are available to order from the Audi
T echnical Literature Ordering Center at:
www.audi.techliterature.com
Maintenance
' General
Your vehicle has been designed to help keep
maintenance requirements to a m inimum.
However, a certain amount of regular mainte­
nance is still necessary to assure your vehicle's
safety, economy and reliability . For detailed
vehicle maintenance consult your Warranty
&
Maintenance booklet.
Under difficult operating conditions , for ex­
ample at extremely low outside temperatures,
in very dusty regions, when towing a tra iler
very frequently, etc., some serv ice work
shou ld be pe rformed between the intervals
specified. This applies particularly to:
- oil changes, and
- cleaning or replacing the air filter.
® For the sake of the environment
By regularly maintaining your veh icle, you
help make sure that emission standards
are maintained, thus min imiz ing adverse
effects on the environment .
Important considerations for you and
your vehicle
The increasing use of electronics, sophisticat­
ed fuel injection and emission contro l sys-
tems, and the genera lly increasing technica l ..,_
•
•

Front passenger's door emergency locking 3 7
Front seats Adjusting .. ............. .... .. ... 126
C hi ld restra ints in the front seat . .. .. . 14 3
Fue l
Addit ives . ..... ........... ... ... .. 211
Blended gasoline .............. .... 211
Consumpt ion . . . . . . . . . . . . . . . . . . . . . . 25
Fill er ne ck .. .. ........... .. .. .. ... 2 13
Fu el gauge . ............. .. .. .. .. .. 12
Gasoline ... .... ...... ... .. .. .. ... 211
Gasoline additives ..... ... .. .. .. .. . 2 12
L ow fuel level symbo l . . . . . . . . . . . . . . . 21
Octane rating ............ .... .. .. . 211
Recommendation . . . . . . . . . . . . . . . . . . 211
Refue lling ..... ........... ... ... .. 213
Reserve .. ..... ........... ... ... ... 1 2
Tank capacity ............... ... ... 271
Tank system ............. .... .. .. .. 2 1
Un loc king the f ue l filler fl ap by hand . . 215
Fuel economy messages (eff iciency pro-
gram) ..... ... ...... ............. ... 29
F ue l filler flap
Unlock ing the fue l filler f lap by hand 215
F uses
Assignment . . . . . . . . . . . . . 2 59 , 26 0, 26 1
Replacing . ... .... .... ... .. .. .. ... 259
G
Garage door opener (Home Link) .. .. .. . 119
Garment hooks . . . . . . . . . . . . . . . . . . . . . . 60
Gas discharge lamps ..... ... .. .. .. .. . 262
Gauges Eng ine coolan t temper ature .. .. .. .. .. 10
Fu el gauge ... .. .. .... ... .. .. .... .. 12
Tac hometer . . . . . . . . . . . . . . . . . . . . . . . 11
Gea r recommendat ion . . . . . . . . . . . . . . . . 28
Gearshift ind icator ......... .. .. .. .. .. 27
Gea rshift lever
6 -speed manual transmission ... .. .. .. 82
Ge ne ral illustra tion
I nstruments and controls . . . . . . . . . . . . . 8
Generator (warn ing/indicator lights) .. .. 17
Glossa ry o f tir e and load ing te rm ino logy 232
Glove compartment . . . . . . . . . . . . . . . . . . 60
GPS controlled clock ..... ... .. .. .. .. .. 1 2
Inde x 283
Gross Vehicle Weight Rating (GVW R) ... 269
H
Head lights
C leaning sys tem . ... .. .. ...... ... .. . 49
De fective . . . . . . . . . . . . . . . . . . . . . . . . . 21
Head light range control ..... ... .. .. . 22
Left hand drive, r ight hand drive .. .. .. . 4S
Travel mode . . . . . . . . . . . . . . . . . . . . . . . 45
Head light washer rese rvoir .... ... .. .. 2 30
Head restraints .. .. .. ... ....... .... . 127
Adjusting ....... .. ........ 56, 57, 127
Remov ing/ instal ling .. ......... .. .. . 57
Heated exter ior mirro rs .. .... ... .... .... .. . 46
r ear w indow ..... .. ..... ........... 69
seats ........ ... .. ..... ........... 69
windshield washer sp ray no zzles . .. .. . 49
Heating ...... .. ...... ............. . 67
Heavy clothing and safety be lts . ... .. .. 137
Hig h beam .. .. .. .. .. . .. .... .... .. .. . 44
Hig h voltage warning label ......... .. 269
Hill des cent con tro l .. .. ......... .. .. . 91
Homelink (remote control)
Hood 119
Opening . ... .. .... . ... ...... ... .. 216
Re lease lever .. .. ............. .... 216
Horn ...... .. .. .. ................... 8
How are child rest raint system anchors re -
lated to ch ild safety .. .. .. ...... .... . 180
How many a irbags does my vehicle have? 149
How ofte n should I che ck my tire pres -
s ur es? ..... .. .. .. ... ............ .. 238
How safety belt pretens ioners work .... 140
Hydrop laning ..... ... .. .. ..... ... .. 242
I
Ign it ion
switching on/off .. .. . ... ...... ... .. . 71
Ig nition key
E mergen cy un lo ck ing ........... .. .. . 35
Ig nition lock .. .. .. .. ............... . 71
Ind icator light ... .. . .. .... .... .. .. . 18
Malfunction . . . . . . . . . . . . . . . . . . . . . . . 23
Immobilizer . . . . . . . . . . . . . . . . . . . . . . . . 12
•
•