1
2
3
4
5
6
7
8
9
3-7
EAU1044E
INSTRUMENT AND CONTROL FUNCTIONS
EAU12349
Handlebar switchesLeft
132
1. Dimmer switch “%/&”
2. Turn signal switch “4/6”
3. Horn switch “*”Right
1
1. Start switch “,”
EAU12400
Dimmer switch “&/%”
Set this switch to “&” for the high
beam and to “%” for the low beam.
EAU12460
Turn signal switch “4/6”
To signal a right-hand turn, push this
switch to “6”. To signal a left-hand
turn, push this switch to “4”. When
released, the switch returns to the
center position. To cancel the turn
signal lights, push the switch in after it
has returned to the center position.
EAU12500
Horn switch “*”
Press this switch to sound the horn.
EAUM1132
Start switch “,”
Push this switch while applying the
front or rear brake to crank the en-
gine with the starter. See page 5-1 for
starting instructions prior to starting
the engine.
EAUS2010
Front brake lever
1
1. Front brake leverThe front brake lever is located on
the right handlebar grip. To apply the
front brake, pull this lever toward the
handlebar grip.
This model is equipped with a unifi ed
brake system.
As this system is mechanical, addi-
tional free play can be felt in the front
brake lever when the rear brake lever
is being applied. See “Rear brake
lever” for detailed information on the
unifi ed brake system.
53B-F8199-E0_CS.indd 3-753B-F8199-E0_CS.indd 3-7
2011/11/01 12:32:082011/11/01 12:32:08
Process BlackProcess Black
1
2
3
4
5
6
7
8
9
3-8
EAU1044E
INSTRUMENT AND CONTROL FUNCTIONS
EAUS1961
Rear brake lever
1
1. Rear brake leverThe rear brake lever is located on the
left handlebar grip. To apply the rear
brake, pull the lever toward the han-
dlebar grip.
This model is equipped with a unifi ed
brake system.
When pulling the rear brake lever, the
rear brake and a portion of the front
brake are applied. For full braking
performance, apply both brake levers
simultaneously.TIP● As the unified brake system is
mechanical, additional free play
can be felt in the front brake lever
when the rear brake lever is be-
ing pulled.
● The unified brake system does
not function when the front brake
is applied alone.
EAUT3590
Fuel tank cap
1
2
1. Fuel tank cap
2. Match marksTo remove the fuel tank cap
1. Open the seat. (See page 3-11.)
2. Turn the fuel tank cap counter-
clockwise and pull it off.
To install the fuel tank cap
1. Insert the fuel tank cap into the
tank opening and turn it clockwise
until the “ W/ X” marks on the cap
and rubber mat are aligned.
2. Close the seat.
EWA11091
WARNING
Make sure that the fuel tank cap
53B-F8199-E0_CS.indd 3-853B-F8199-E0_CS.indd 3-8
2011/11/01 12:32:082011/11/01 12:32:08
Process BlackProcess Black
