2012 TOYOTA URBAN CRUISER light

410 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)Front position light
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2

411 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)Front turn signal light
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2

412 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)Stop/tail, rear turn signal and back-up light/rear fog light
Open the back door and remove
the cover.
Use a flathead screwdriver which
is wrapped with a cloth.
Turn the bulb bases counter-
clockwise.
Remove the light bulb.
Stop/tail light
Rear turn signal light
Back-up light/rear fog light
STEP1
STEP2
STEP3

413 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)License plate light
Open the back door and remove
the cover.
Use a flathead screwdriver which
is wrapped with a cloth.
Turn the bulb bases counter-
clockwise.
Remove the light bulb.
Lights other than the above
If any of the lights listed below has burnt out, have it replaced by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.
Side turn signal lights
High mounted stoplight
STEP1
STEP2
STEP3

414 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)
LED lights
The side turn signal lights and high mounted stoplight consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to any authorized
Toyota dealer or repairer, or another duly qualified and equipped
professional to have the light replaced.
Condensation build-up on the inside of the lens
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional, for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water are built up on the inside of the lens.
Water has built up inside the headlight.
CAUTION
Replacing light bulbs
Turn off the headlights. Do not attempt to replace the bulb immediately
after turning off the headlights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failing to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
Do not attempt to repair or disassemble light bulbs, connectors, electric
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

5When trouble arises
415
URBAN CRUISER_EE (OM52C21E)
5-1. Essential information
Emergency flashers .......... 416
If your vehicle needs
to be towed ..................... 417
If you think something is
wrong .............................. 425
Fuel pump shut off system
(gasoline engine) ............ 4265-2. Steps to take in an
emergency
If a warning light turns on
or a warning buzzer
sounds... ......................... 427
If you have a flat tire
(vehicles with a spare
tire) ................................. 437
If you have a flat tire
(vehicles without a spare
tire) ................................. 452
If the engine will not
start................................. 468
If you lose your keys ......... 470
If you cannot operate
the back door opener...... 471
If the electronic key does
not operate properly ....... 472
If the battery is
discharged ...................... 475
If your vehicle
overheats ........................ 481
If you run out of fuel and
the engine stalls
(diesel engine) ................ 485
If the vehicle becomes
stuck ............................... 488
If your vehicle has to be
stopped in an
emergency ...................... 490

416
URBAN CRUISER_EE (OM52C21E)
5-1. Essential information
Emergency flashers
NOTICE
To prevent battery discharge
Do not leave the emergency flashers on longer than necessary when the
engine is not running.
Use the emergency flashers if the vehicle malfunctions or is
involved in an accident.
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.

5
427
When trouble arises
URBAN CRUISER_EE (OM52C21E)
5-2. Steps to take in an emergency
If a war ning light tur ns on or a war ning buzzer sounds...
Stop the vehicle immediately. Continuing to drive the vehicle
may be dangerous.
The following warning indicates a possible problem in the brake sys-
tem. Immediately stop the vehicle in a safe place and contact any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
*:Parking brake engaged warning buzzer:
A buzzer will sound if the vehicle is driven at a speed of approximately
5 km/h (3 mph) or more.
Warning lightWarning light/Details
Brake system warning light (warning buzzer)
*
• Low brake fluid
• Malfunction in the electronically controlled brake system
This light also comes on when the parking brake is not
released. If the light turns off after the parking brake is fully
released the system is operating normally.
Calmly perform the following actions if any of the warning lights turn
on or flash. If a light turns on or flashes, but then turns off, this does
not necessarily indicate a malfunction in the system.
However, if this continues to occur, have the vehicle inspected by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.