Page 246 of 580

246 2-2. Instrument cluster
PRIUS +_OM_OM47821E_(EE)Press and hold the “DISP” button for 1 second or more to
complete the setup.
If setup is not completed by pressing and holding the “DISP” button
for 1 second or more, or if nothing is operated within approximately
10 seconds, the screen will return and the settings will be lost.
Eco Driving Indicator Light
Eco Driving Indicator Light will turn on when driving power is lower than the
upper limit of Eco driving. It will turn off when the acceleration exceeds the
Eco driving accelerator upper limit or when the vehicle is stopped.
Eco Driving Indicator Light will not operate in the following conditions:
The shift position is anything other than D.
The driving mode is set to power mode or EV drive mode. (P. 221, 226)
The vehicle speed is approximately 130 km/h (80 mph) or higher.
Eco Driving Indicator Light can be set to activated or deactivated.
(P. 245)
Remaining hybrid battery (traction battery) charge display
The charge amount of the hybrid battery (traction battery) is automatically
controlled by the hybrid system. For this reason, even if electricity is recov-
ered via the regenerative braking, or electricity is generated via the gasoline
engine, the displayed hybrid battery (traction battery) charge amount may
not reach the highest level (level 8). However, this does not indicate a mal-
function.
STEP 3
Page 247 of 580

247 2-2. Instrument cluster
2
When driving
PRIUS +_OM_OM47821E_(EE)
Engine speed
On hybrid vehicles, engine speed is precisely controlled in order to help
improve fuel efficiency and reduce exhaust emissions etc.
There are times when the engine speed that is displayed may differ even
when vehicle operation and driving conditions are the same.
Brightness of the instrument cluster light
If the headlight switch is turned to ON while the surrounding area is dark, the
instrument cluster lights will dim.
When disconnecting and reconnecting 12-volt battery terminals
The average fuel consumption and cruising range will be reset.
NOTICE
To prevent damage to the engine and its components
The engine may be overheating if the high coolant temperature warning light
comes on or flashes. In this case, immediately stop the vehicle in a safe
place, and check the engine after it has cooled completely. (P. 528)
The trip information display at low temperatures
Allow the interior of the vehicle to warm up before using the liquid crystal
information display. At extremely low temperatures, the information display
monitor may respond slowly, and display changes may be delayed.
Page 259 of 580

259 2-2. Instrument cluster
2
When driving
PRIUS +_OM_OM47821E_(EE)Press the display position adjust-
ment switch to select ON or OFF.
Press and hold the “SET” switch.
STEP 3
System check display
After switching the “POWER” switch to ON mode, “welcome to PRIUS +” is
displayed while system operation is checked. When the system check is
complete, the normal screen will return.
When driving on snowy roads or in other bright environments
When the highest level of brightness has been reached, the display can be
made even brighter by pressing and holding “” on the brightness control
button.
Pressing “” on the brightness control button or turning the “POWER” switch
off will cause the brightness level to revert to the original level.
Head-up display
The head-up display may seem dark and hard to see when viewed
through sunglasses, especially polarized sunglasses.
Adjust the brightness of the head-up display or remove your sunglasses.
When the head-up display is turned off, it will remain off even if the power
switch is turned to ON mode after the power switch has been turned off.
When the 12-volt battery is disconnected
The head-up display settings will be reset.
STEP 4
Page 265 of 580
265 2-3. Operating the lights and windshield wipers
2
When driving
PRIUS +_OM_OM47821E_(EE)
Automatic headlight leveling system (if equipped)
The level of the headlights is automatically adjusted according to the number
of passengers and the loading condition of the vehicle to ensure that the
headlights do not interfere with other road users.
Customization
Settings (e.g. light sensor sensitivity) can be changed.
(Customizable features P. 554)
NOTICE
To prevent 12-volt battery discharge
Do not leave the lights on longer than necessary when the hybrid system is
off.
Page 267 of 580
267 2-3. Operating the lights and windshield wipers
2
When driving
PRIUS +_OM_OM47821E_(EE)
Fog lights can be used when
Vehicles with front and rear fog light
Front fog lights: The front position lights are turned on.
Rear fog light: The front fog lights are turned on.
Vehicles with rear fog light
The front position lights are turned on.
NOTICE
To prevent 12-volt battery discharge
Do not leave the lights on longer than necessary when the hybrid system is
off.
Rear fog light switch (if equipped)
Turns the rear fog light off
Turns the rear fog light on
Page 271 of 580
271 2-3. Operating the lights and windshield wipers
2
When driving
PRIUS +_OM_OM47821E_(EE)
CAUTION
Caution regarding the use of windshield wipers in “AUTO” mode
The windshield wipers may operate unexpectedly if the sensor is touched or
the windshield is subject to vibration in “AUTO” mode. Take care that your
fingers or anything else do not become caught in the windshield wipers.
NOTICE
When the windshield is dry
Do not use the wipers, as they may damage the windshield.
When the washer fluid tank is empty
Do not operate the switch continually as the washer fluid pump may over-
heat.
When a nozzle becomes blocked
In this case, contact any authorized Toyota dealer or repairer, or another
duly qualified and equipped professional.
Do not try to clear it with a pin or other object. The nozzle will be damaged.
To prevent 12-volt battery discharge
Do not leave the wipers on longer than necessary when the hybrid system is
off.
Page 338 of 580

338 3-1. Using the air conditioning system and defogger
PRIUS +_OM_OM47821E_(EE)
Air conditioning odors
During use, various odors from inside and outside the vehicle may enter
into and accumulate in the air conditioning system. This may then cause
odor to be emitted from the vents.
To reduce potential odors from occurring:
• It is recommended that the air conditioning system be set to outside air
mode prior to turning the vehicle off.
• The start timing of the blower may be delayed for a short period of time
immediately after the air conditioning system is started in automatic
mode.
Customization
Settings (e.g. switching between outside air and recirculated air mode linked
to “AUTO” switch operation) can be changed.
(Customizable features P. 554)
CAUTION
To prevent the windshield from fogging up
Do not use
during cool air operation in extremely humid weather. The
difference between the temperature of the outside air and that of the wind-
shield can cause the outer surface of the windshield to fog up, blocking your
vision.
NOTICE
To prevent 12-volt battery discharge
Do not leave the air conditioning system on longer than necessary when the
hybrid system is off.
Page 341 of 580
341
3-1. Using the air conditioning system and defogger
3
Interior features
PRIUS +_OM_OM47821E_(EE)
Rear window and outside rear view mirror defogger switch
Operating conditions
The “POWER” switch is in ON mode.
The outside rear view mirror defoggers
Turning the rear window defogger on will turn the outside rear view mirror
defoggers on.
CAUTION
When the outside rear view mirror defoggers are on
Do not touch the outside surface of the rear view mirrors, as they can
become very hot and burn you.
NOTICE
To prevent 12-volt battery discharge
Do not leave the rear window defogger on longer than necessary when the
hybrid system is off.
Defoggers are used to defog the rear window, and to remove rain-
drops, dew and frost from the outside rear view mirrors.
Turns the rear window and
outside rear view mirror defog-
gers on/off
The defoggers will automati-
cally turn off after approxi-
mately 15 minutes.