2012 TOYOTA LAND CRUISER oil type

312 2-4. Using other driving systems
L/C200_EE (OM60G38E)
CAUTION
If the malfunction indicator light comes on
The malfunction indicator light comes on if you continue driving while the
DPF system warning message “DPF FULL ENGINE SERVICE REQUIRED”
appears on the display. In this event, damage may be caused to the vehicle
or an accident may occur. Have the vehicle inspected by any authorized Toy-
ota dealer or repairer, or another duly qualified and equipped professional,
immediately.
NOTICE
To prevent the DPF system from failing
Do not drive for long periods of time while the DPF system warning mes-
sage “DPF FULL ENGINE SERVICE REQUIRED” appears on the display
Do not use fuel other than the specified type
Do not use engine oil other than the recommended type
Do not modify the exhaust pipe

506 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine. (P. 649)
Make sure to check the oil type and prepare the items needed before
adding oil.
Remove the oil filler cap.
Add engine oil slowly, checking the dipstick.
Install the filler cap, turning it clockwise.
Engine oil selectionP. 649
Oil quantity
(Low  Full)1.5 L (1.6 qt., 1.3 Imp.qt.)
Items Clean funnel
STEP1
STEP2
STEP3

622 5-2. Steps to take in an emergency
L/C200_EE (OM60G38E)
NOTICE
Vehicles with a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the
wheel beyond repair.
When performing an emergency repair
Perform the emergency repair without removing the nail or screw that has
punctured the tread of the tire. If the object that has punctured the tire is
removed, the repair using the sealant in the emergency tire puncture repair
kit may fail.
When fixing the flat tire
Do not put the valve core on dirty ground or in the sand.
Store it in a clean place.
Do not remove the inside cap of the sealant bottle.
Turn the valve core tool with your hand when screwing it in. If you use
another tool in conjunction with the valve core tool, damage may occur.
Do not operate the compressor continuously for more than 10 minutes.
The motor may overheat and be damaged. Let the compressor cool before
using it again.
Compressor precautions
The compressor power source should be 12 V DC suitable for vehicle use.
Do not connect the compressor to 24 V DC or any other power source.
The compressor is an oil-less type. Do not lubricate with oil.

656 6-1. Specifications
L/C200_EE (OM60G38E)
Differential
Your Toyota vehicle is filled with “Toyota Genuine Differential Gear Oil” at the
factory.
Use Toyota approved “Toyota Genuine Differential Gear Oil” or an equivalent of
matching quality to satisfy the above specification. Please contact any autho-
rized Toyota dealer or repairer, or another duly qualified and equipped profes-
sional for further details.
Automatic transmission
The fluid capacity is the quantity of reference. If replacement is necessary, con-
tact any authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
Oil capacity
Front
Rear1.90 L (2.01 qt., 1.67 Imp.qt.)
4.20 L (4.44 qt., 3.70 Imp.qt.)
Oil type and
viscosityToyota Genuine Differential Gear Oil LT
75W-85 or equivalent
Fluid
capacity
(Reference)Gasoline engine11.5 L (12.2 qt., 10.1 Imp.qt.)
Diesel engine11.8 L (12.5 qt., 10.4 Imp.qt.)
Fluid typeToyota Genuine ATF WS
NOTICE
Automatic transmission fluid type
Using transmission fluid other than “Toyota Genuine ATF WS” may cause
deterioration in shift quality, locking up of your transmission accompanied by
vibration, and ultimately damage the transmission of your vehicle.

657 6-1. Specifications
6
Vehicle specifications
L/C200_EE (OM60G38E)
Transfer
*: Your Toyota vehicle is filled with “Toyota Genuine Transfer Gear oil LF” at the
factory. Use Toyota approved “Toyota Genuine Transfer Gear oil LF” or an
equivalent of matching quality to satisfy the above specification. Please con-
tact any authorized Toyota dealer or repairer, or another duly qualified and
equipped professional for further details.
Brakes
*1: Minimum pedal clearance when depressed with a force of 490 N (50 kgf,
110 lbf) while the engine is running
*2: Parking brake lever travel when pulled up with a force of 200 N (20.4 kgf,
45.0 lbf)
Oil capacity1.45 L (1.53 qt., 1.28 Imp.qt.)
Oil type*Toyota Genuine Transfer Gear oil LF or
equivalent
Recommended oil viscositySAE 75W
Pedal clearance*1
Left-hand drive
Right-hand drive92 mm (3.6 in.) Min.
93 mm (3.7 in.) Min.
Pedal free play 1  6 mm (0.04  0.24 in.)
Parking brake lever travel*25  7 clicks
Fluid type SAE J1703 or FMVSS No. 116 DOT 3

692
L/C200_EE (OM60G38E)
GAS STATION INFORMATION
Fuel filler door
P. 1 1 6Auxiliary catch lever
P. 501
Tire inflation pressure
P. 6 5 9
Fuel filler door opener
P. 1 1 6
Hood lock release lever
P. 501
Fuel tank capacity (Reference) 93 L (24.5 gal., 20.4 Imp.gal.)
Fuel type P. 648
Cold tire inflation
pressureP. 6 5 9
Engine oil capacity
(Drain and refill —
reference)
Gasoline engine L (qt., Imp.qt.)
With filter 7.5 (7.9, 6,6)
Without filter 7.1 (7.5, 6.2)
Diesel engine L (qt., Imp.qt.)
With filter 9.2 (9.7, 8.1)
Without filter 8.2 (8.7, 7.2)
Engine oil type P. 649