2012 TOYOTA HILUX light

536 4-3. Do-it-yourself maintenance
HILUX_EE (OM0K132E)License plate lights
Remove the unit.
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2
STEP3

537 4-3. Do-it-yourself maintenance
4
Maintenance and care
HILUX_EE (OM0K132E)Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.
Side turn signal lights (mirror-mounted type) (if equipped)
High mounted stoplight (if equipped)
When installing the rubber cover of the headlight
Ensure the rubber cover is securely attached.
LED light bulbs
The high mounted stoplight consists of a number of LEDs. If any of the LEDs
burn out, take your vehicle to any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional to have the light replaced.
Condensation build-up on the inside of the lens
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water have built up on the inside of the lens.
Water has built up inside the headlight.
Fit the rubber cover outer circumfer-
ence in firmly.
Fit the rubber cover around the light
bulb in until the light bulb plug can be
seen.

538 4-3. Do-it-yourself maintenance
HILUX_EE (OM0K132E)
CAUTION
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
To prevent damage or fire
Make sure bulbs are fully seated and locked.
Check the wattage of the bulb before installing to prevent heat damage.

5When trouble arises
539
HILUX_EE (OM0K132E)
5-1. Essential information
Emergency flashers .......... 540
If your vehicle needs to
be towed ......................... 541
If you think something
is wrong .......................... 547
Fuel pump shut off
system ............................ 548
5-2. Steps to take in an
emergency
If a warning light turns on
or a warning buzzer
sounds ............................ 549
If you have a flat tire ......... 557
If the engine will not
start................................. 576
If the shift lever cannot
be shifted from P ............ 577
If you lose your keys ......... 578
If the vehicle battery is
discharged ...................... 579
If your vehicle
overheats ........................ 584
If you run out of fuel and
the engine stalls.............. 587
If the vehicle becomes
stuck ............................... 588
If your vehicle has to be
stopped in an
emergency ...................... 590

540
HILUX_EE (OM0K132E)
5-1. Essential information
Emergency flashers
NOTICE
To prevent battery discharge
Do not leave the emergency flashers on longer than necessary when the
engine is not running.
Use the emergency flashers if the vehicle malfunctions or is
involved in an accident.
Vehicles without automatic air conditioning system
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.
Vehicles with automatic air conditioning system
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.

5
549
When trouble arises
HILUX_EE (OM0K132E)
5-2. Steps to take in an emergency
If a warning light tur ns on or a warning buzzer sounds
Stop the vehicle immediately. Continuing to drive the vehicle
may be dangerous.
The following warning indicates a possible problem in the brake sys-
tem. Immediately stop the vehicle in a safe place and contact any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
Warning lightWarning light/Details
Brake system warning light
• Low brake fluid
• Malfunction in the brake system
This light also comes on when the parking brake is not
released. If the light turns off after the parking brake is
fully released the system is operating normally.
• Low negative pressure in the vacuum tank
Calmly perform the following actions if any of the warning lights
comes on or flashes. If a light comes on or flashes, but then goes
off, this does not necessarily indicate a malfunction in the system.
However, if this continues to occur, have the vehicle inspected by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.

550 5-2. Steps to take in an emergency
HILUX_EE (OM0K132E)
Stop the vehicle immediately.
The following warning indicates the possibility of damage to the vehi-
cle that may lead to an accident. Immediately stop the vehicle in a
safe place and contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
Have the vehicle inspected immediately.
Failure to investigate the cause of the following warnings may lead to
the system operating abnormally and possibly cause an accident.
Have the vehicle inspected by any authorized Toyota dealer or
repairer, or another duly qualified and equipped professional immedi-
ately.
Warning lightWarning light/Details
Charging system warning light
Indicates a malfunction in the vehicle’s charging system
Low engine oil pressure warning light
Indicates that the engine oil pressure is too low
Warning lightWarning light/Details
Malfunction indicator lamp
Indicates:
• Malfunction in the electronic engine control system.
• The boost pressure in the turbocharger is abnormally
high.
*
• Malfunction in DPF system

5
551 5-2. Steps to take in an emergency
When trouble arises
HILUX_EE (OM0K132E)
Warning lightWarning light/Details
SRS warning light
Indicates a malfunction in:
• The SRS airbag system; or
• The seat belt pretensioner system
ABS warning light
Indicates a malfunction in:
• The ABS; or
• The brake assist system (vehicles with VSC system)
(flashes)
and
VSC OFF and slip indicator lights (if equipped)
Indicates a malfunction in:
• Vehicle stability control; or
• Traction control
(flashes rapidly)
Four-wheel drive indicator light
Indicates a malfunction in the four-wheel drive system
(P. 211)
(flashes)
Cruise control indicator light (if equipped)
Indicates a malfunction in the cruise control system
(P. 202)
Automatic transmission fluid temperature warning
light (if equipped)
Indicates that the automatic transmission fluid tempera-
ture is too high.
Timing belt replacement warning light
Indicates that the timing belt should be replaced