13
12
Getting
Started Instrument
Panel Gauges
Personalize Controls While
OperatingSafety / In Case
of Emergency Additional
Information
13
GetGttintigStartedInsItrument PanelGauGgesPersonalizeConCtrotlslWhiWhile lOperatingSafSfetyt / /In ICasCe of EmergencyAddAdditiiional lInformation
Personalize
PersonalizeTilt and Telescopic
Steering ColumnPush the lever down firmly to adjust the height
and lengthwise position of the column; firmly
push the lever back up to lock the column in
place. Do not adjust while driving.Power Exterior Mirrors 1 V T I U I F N J S S P S T F M F D U J P O T X J U D I U P U I F i - w
T J E F U P B E K V T U U I F M F G U I B O E N J S S P S P S U P U I F i 3 w
side to adjust the right-hand mirror. Push and
hold the direction mirror control switch in the
direction you want to move the mirror. Push
the mirror selection switch back to the middle
to prevent unintended operation.
Power Moonroof
(if equipped)
With the moonroof in the fully closed position,
press the switch
4 to tilt the moonroof up.
Press and hold the switch
3 to lower the
moonroof. Press the switch 2 to fully open
the moonroof. Press the switch 1 to close
the moonroof. To stop the moonroof in a
midway position while opening or closing,
momentarily press the switch to the 1 side
or
2 side.
12
34
15
14
Getting
Started Instrument
Panel Gauges
Personalize Controls While
OperatingSafety / In Case
of Emergency Additional
Information
15
GetGttintigStartedInsItrument PanelGauGgesPerPsonalilizeControlsWhiWhile lOperatingSafSfetyt / /In ICasCe of EmergencyAddAdditiiional lInformation
Controls
Controls
Illumination
Brightness Control
While the light switch
is on, rotate the dial downward to dim
the instrument panel
illumination. Rotate the dial upward to make the illumination
brighter. When the dial is fully rotated
upward, the instrument panel illumination
becomes full bright.
Windshield WipersTo turn on the wipers, press the wiper control lever down one level for intermittent,
U X P M F W F M T G P S M P X
P S U I S F F M F W F M T G P S I J H I T Q F F E 3 F U V S O U I F M F W F S U P U I F i 0 ' ' w
position to stop the wipers. For a single wipe, pull the lever toward you. To spray
washer fluid, press and hold the button at the end of the lever.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob downward
to wash and wipe the rear window.Daytime Running LightsDaytime running lights are standard on your vehicle. Only a reduced brightness high
beam will be automatically turned on when the engine has started and the parking
C S B L F J T G V M M Z S F M F B T F E B O E U I F M J H I U T X J U D I J T J O U I F i 0 ' ' w P S i
w Q P T J U J P O 5 I F
brightness of the illumination of the high beam headlights is reduced by the daytime
running light system. You must always switch on your headlights when it’s dark
outside by turning the light switch to the
position.
Light Controls
Turns on instrument panel lights,
taillights, parking lights and
license plate lights.
Turns on headlights, instrument
panel illumination, parking lights,
taillights and license plate lights. Turns on
fog lights
(if equipped).
Push up for right
turn signal.
Push down for
left turn signal.
OFF123
INT.
LOW
HIGH
Headlight Beam
Leveler
(if equipped)
Your vehicle’s High-Intensity
Discharge (HID) headlights
generate more light than
conventional halogen
headlights. Therefore, a driver
of an oncoming vehicle may
experience too much glare
when your headlight beam
height adjustment is high
because the vehicle is carrying
a heavy load. The headlight
beam leveler can be used to
adjust beam height to avoid
such a condition. To lower the
beam, turn the knob to the
higher numbers.
17
16
Getting
Started Instrument
Panel Gauges
Personalize Controls While
OperatingSafety / In Case
of Emergency Additional
Information
17
GetGttintigStartedInsItrument PanelGauGgesPerPsonalilizeControlsWhiWhile lOperatingSafSfetyt / /In ICasCe of EmergencyAddAdditiiional lInformation
Controls
ControlsAutomatic Climate Control1. Air Flow Control Dial
On the automatic setting, the system
determines the air flow location to achieve
the desired temperature or you can
choose the direction of air flow. Rotate the
dial for the desired air flow position.
Defrost / Defog
To clear the windshield and front door
windows of fog or frost, rotate the air flow
control dial to the defrost position, set the
temperature control to the red position,
and set the fan speed control to the
fastest speed.
2. Rear Window Defogger Button
Press the rear window defogger button
to turn on the defogger. The defogger
will automatically shut off after about 15
minutes. If the window clears before that
time, you can press the button again to
turn it off.
3. Fan Speed Control Dial On the automatic setting, the system
determines the fan speed to achieve the
desired temperature or you can manually
rotate the fan speed control dial to select
one of seven fan speeds.
4. Air Conditioning Button 1 S F T T U I F i " $ w C V U U P O U P B D U J W B U F U I F
air conditioning. Press it again to turn
off the air conditioning.
5. Recirculated / Outside Air Button In the automatic mode, the system will
determine if recirculated air is needed
to achieve a desired temperature.
In manual mode, press the air inlet
selection button to prevent outside air
from being drawn into the passenger
compartment. If the button is pushed
in, press it again to draw outside air
J O U P U I F D P N Q B S U N F O U 5 0 1 3 &