2012 SSANGYONG KORANDO diagram

01-150000-00
2) CAN Communication Wiring Diagram
Splice pack Wiring Location
S101 Floor wiring (LH) Under fuse and relay box in engine compartment
S102 Floor wiring (RH) Inside of right fender
S201 Main wiring Behind the instrument cluster (cowl cross member)
S202 Main wiring Behind the instrument cluster (cowl cross member)
S205 Floor wiring (LH) Bottom of driver seat (front right)

04-6
2. INPUT/OUTPUT DIAGRAM
Major functions ▶
Passive LOCK/UNLOCK by outside door handle switch
Passive UNLOCK by tailgate open switch
Passive START by START switch
Engine ECU and High speed CAN communication
BCM, Instrument cluster and Low speed CAN communication
RF communication for REKES operation
Smart key system warning function
Smart key registration (up to 3 keys) 1.2.
3.4.
5.6.
7.8.

05-20
SVC ▶
3) Block Diagram

06-118510-00
Door lock/unlock switch
Function of door lock/unlock switch ▶
There are 5 actuators in door lock/unlock system (including tailgate). All of them can control the
corresponding door lock and unlock separately. But, the driver door lock switch can control all door
locks. The BCM controls the lock/unlock switch using the door lock/unlock relay. This is a same control
type with Auto door lock function that locks the doors when the vehicle speed exceeds 30 km/h. (see
circuit diagram)
Door lock/unlock relay (integrated in BCM) ▶
Door lock/unlock switch
When the door lock/unlock switch is pressed while all doors including the tailgate are locked, all doors
will be unlocked. When the switch is pressed again, all doors will be locked.

09-8
3. OPERATING PROCESS
1) Block Diagram
When PAS receives "R" signal, it starts to detect the obstacles behind vehicle after self diagnosis.
If the system detects the obstacle, the buzzer sounds according to the distance. If there is no obstacle, starts
to detect the obstacles after self diagnosis again.

09-10
Circuit diagram of ECU ▶
Internal circuit diagram of sensors ▶

02-6
2) Sectional Diagram
Double planetary gear-set
Clutch packSingle planetary gear-set
Oil pump
Torque converter
Input shaft
Intermediate shaft
Differential assembly

02-173680-01
6. CAN NETWORK
The TCU sends signals to be used by other vehicle systems via the CAN bus, such as:
Selector lever position
Selected gear state
Manual mode activation
Output torque
Transaxle fluid temperature
Engine torque reduction requests -
-
-
-
-
-
Schematic Diagram of Network Communication ▶