> ( G L W 0 R G H O . $ 2 ( 0 B 5 H Q D X O W @
2-38Instruments and controls
3. Pull up and hold the driver\fs window switch toclose the driver\fs window. \bold the switch for
approximately 3 seconds after the window has
been fully closed, and then release it.
4. Check if the power window functions operate properly.
If you open or close the power window continuously, it
may cause the power window not to operate properly.
Perform the above procedure.
If the power window functions do not operate properly
after performing the above procedure, repeat the
steps. See a RENAULT dealer, if necessary, for
checking the power window system.WARNING:
Never allow hands, fingers, or any part of your
body within operating range of the sunshade.
You could be injured.
CAUTION:
. Do not place any heavy objects on the roof
glass or surrounding area.
. Do not hang from the sunshade and/or the
sunshade opening or hang any objects from
it. It may cause damage or deformation to
the sunshade.
. Close the sunshade when you leave the
vehicle for extended periods of time to
prevent the inside of the vehicle from reach-
ing high temperatures.
JVI0020X
To open or close the sunshade, operate the knob*A.
To open the sunshade, slide it toward the rear of the
vehicle
*1. To close, slide the sunshade toward the
front of the vehicle*2. If the battery cable is disconnected, the clock will reset
its time and the correct time will not be indicated.
Readjust the time.
For model with the vehicle information display, see
“Vehicle information display” (P.2-20)
For the clock adjustment in the audio unit (if equipped) .
See “Audio system” (P.4-8) .
ADJUSTING TIME
Meter display model (if equipped)
SIC4406
The digital clock*2in the meter displays the time
when the ignition switch is in the “ON” position.
To display the clock, push the adjusting knob
*1. To
adjust the time, perform the following procedure.
1. Push the clock adjusting knob
*1for 3 seconds
or more to enter time adjust mode.
The hours display will start to flash.
2. Push the clock adjusting knob
*1to adjust the
hour.
To advance the time, hold down the knob
*1.
3. Wait at least 5 seconds for the minute display to flash.
SUNSHADE (if equipped) CLOCK
& R Q G L W L R Q
