Page 69 of 340
3
67
Comfort
Front seats
Manual adjustments
1.Adjustments to the height and angle of
the head restraint
To raise it, pull upwards.
To lower it, hold the button in and press on
the head restraint (pushing to go past the stiff point of the button).2.Adjustment of the backrest angle Operate the control lever and adjust the position of the backrest to the front or to the rear. 3. Adjustment of the seat height Raise or lower the control lever the number
of times required to obtain the desiredposition.4.Adjustment of the lumbar support This system allows the height and depth
of the lumbar suppor t to be adjusted separately. )Forwards or backwards to increase or
decrease the lumbar suppor t.
)Upwards or downwards to raise or lower
the lumbar contact zone.
5.Forwards-backwards adjustment of the
seat position
Lift the control bar and slide the seatforwards or backwards.
6. Ad
justing the cushion
Pull the handle to adjust the length of the
cushion.
Page 85 of 340

3
83
Comfort
Warning triangle (stowing)
Before leaving your vehicle to set up and install the triangle, put on your high visibility vest.
The dimensions o
f the triangle (once folded) or its storage box must be:
-
A
: length = 438mm,
-
B: height = 56
mm,
- C: width = 38mm.
Saloon
)
Press the lug 1and pull the assembly
towards you.
SW
) Turn the knob 2
to remove the cover. )
Hold the cover and the triangle so that theydo not fall.
The location for a folded trian
gle is in the inner
trim panel of the boot lid.Placing the triangle in the
roa
d
Distance from your vehicle (in metres)
Road
Motorway
DayNight
50 m 80 m
150 m
These are the internationally recognisedvalues.
Use the triangle in line with local driving regulations.
The trian
gle is available as an accessory, contact a PEUGEOT dealer or a qualified
workshop.
) Place the triangle at a distance behind
the vehicle, as shown in the table below,
according to the type of road and the level
of ambient light.
To use the triangle, refer to themanufacturer's instructions.
Page 86 of 340
84
Comfort
High load retaining net
Hooked onto the special upper and lower
fixings, this allows the use of the entire loading
volume up to the roof:
- behind the front seats (row 1) when the rear seats are folded.
- behind the rear seats (row 2).
Never reposition the rear seats if thenet's roller is attached to the backs of the folded seats. )
position the net's roller above the two rails (located on the back of the folded rear seats), )
the two grooves Amust be placed above
the two rails B
. Slide the two rails B
in the grooves A
and push the roller (lengthwise)from right to left to secure it, )
check that the net is hooked and tightened correctly,
)fold the rear seats, )unroll the high load retaining net withoutstretching it, )position one of the ends of the net's metal
bar in the corresponding upper fixing 1, )pull the net's metal bar to position the other end in the other upper fixing 1 .
Row 1
(SW)
Page 137 of 340