2012 MITSUBISHI iMiEV tow

6-16 For emergencies
6
15. Check and adjust the tire pressure with reference to the air
pressure gauge on the compressor. If you overinflate the
tire, release air by loosening the hose’s end fitting. (Refer
to “Tire inflation pressures” on page 7-21.)
If there is a gap between the tire and wheel because the
tire has moved inward from the wheel rim, press the tire
tread towards the wheel to close the gap before running
the compressor. (With no gaps, the tire pressure will rise.)NOTE
If the tire pressure does not rise to the specified level
within 10 minutes, the tire may be so severely damaged
that the tire sealant cannot be used to effect the emergency
repair. Do not drive the vehicle. Please contact a certified
i-MiEV dealer.
WA R N I N G
!
Do not place your hand or fingers between the tire
and wheel while inflating the tire. Your hand or fin-
gers may become caught between the tire and wheel.
CAUTION
!
The supplied compressor is designed only for infla-
tion of your vehicle tires.
The compressor is designed to run on a vehicle’s
12 V power supply. Do not connect it to any other
power source.
The compressor is not waterproof. If you use it in
rain, make sure water does not get on it.
Any sand or dust sucked into the compressor could
make the compressor break down. Do not place the
compressor directly on any sandy or dusty surface
when using it.
Do not disassemble or modify the compressor. Also,
do not subject the air pressure gauge to shock. It
could malfunction.
CAUTION
!
The surface of the compressor will get hot while the
compressor is running. Do not keep the compressor
running continuously for more than 10 minutes.
After using the compressor, wait for the compressor
to cool before using it again.
If the compressor becomes sluggish or hot while
operating, it is overheating. Immediately place the
switch in the OFF position and let the compressor
cool down for at least 30 minutes.
BK0140800US.book 16 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-18 For emergencies
6
18. When you have inflated the tire to the specified pressure,
stow the compressor, bottle, and other items in the vehicle
and make sure that the seat cushion is properly secured.
(Refer to “Tire repair kit storage” on page 6-8.) Promptly
start driving the vehicle so that the tire sealant can spread
evenly in the tire. Drive with great care. Do not exceed a
speed of 50 mph (80 km/h). Observe local speed limits.19. After driving for 10 minutes or 3 miles (5 km), park the
vehicle in safe place. Remove the air compressor from the
stowed position. (Refer to “Tire repair kit storage” on
page 6-8.) Check the tire pressure using the air pressure
gauge on the compressor. (Refer to “Tire inflation pres-
sures” on page 7-21.)
If the tire pressure is not sufficient, inflate the tire to the
specified pressure again and drive the vehicle carefully
without exceeding a speed of 50 mph (80 km/h).
Before driving, stow the compressor and make sure that
the rear seat cushion is properly secured. (Refer to “Tire
repair kit storage” on page 6-8.)
CAUTION
!
If you sense any abnormality while driving, stop the
vehicle and contact a certified i-MiEV dealer. Other-
wise the tire pressure may drop before the emer-
gency repair procedure is completed, rendering the
vehicle unsafe to drive.
CAUTION
!
If the tire pressure is lower than the minimum per-
mitted pressure (18 psi {130 kPa}), the tire cannot
successfully be repaired with the tire sealant. Do not
drive the vehicle any further. Contact a certified i-
MiEV dealer.
BK0140800US.book 18 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-19
6
20. After driving for 10 minutes or 3 miles (5 km) again,
check the tire pressure using the air pressure gauge on the
compressor. (Refer to “Tire inflation pressures” on page
7-21.) If the tire pressure has apparently not dropped, the
emergency repair procedure is complete. Before driving,
make sure that the compressor is stowed and the seat
cushion is properly secured. You must still not exceed a
speed of 50 mph (80 km/h). Observe local speed limits.NOTE
If the tire pressure has dropped below the specified level
when you check it at the end of the repair procedure, do
not drive the vehicle any further. Contact a certified i-
MiEV dealer.

In cold conditions (when the ambient temperature is 32 °F
{0 °C} or lower), the time and driving distance necessary
until completion of the repair can become longer than in
warmer conditions, and the tire pressure may drop below
the specified level even after you have inflated the tire the
second time and subsequently driven the vehicle. If this
happens, inflate the tire to the specified pressure once
more, drive for about 10 minutes or 3 miles (5 km), then
check the tire pressure again. If the tire pressure has again
dropped below the specified level, stop driving the vehicle
and contact a certified i-MiEV dealer.

Please give the empty sealant bottle to a certified i-MiEV
dealer or dispose of the sealant bottle according to regula-
tions for the disposal of chemical waste.
To w i n g
N00837000859
If your vehicle needs to be towedIf you need to tow your vehicle, contact a certified i-MiEV
dealer or a commercial tow truck service.
Transport the vehicle on a flatbed truck or tow the vehicle
either with all wheels or the rear wheels (drive wheels) off the
ground.Flat bed type
Dolly type
Towing with rear wheels off the ground
BK0140800US.book 19 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-20 For emergencies
6
WA R N I N G
!
Never tow the vehicle with rear wheels (drive
wheels) on the ground. This may cause damage to
the electric motors. Also this may cause a fire, if wir-
ing in the electric motor unit room becomes dam-
aged.Towing with all wheels on the ground
Towing with front wheels off the ground
CAUTION
!
Never tow the vehicle using a sling type truck.
Doing so will damage the bumper and/or body.
CAUTION
!
Never attempt to tow the vehicle using another vehi-
cle with a rope.
Never tow another vehicle using your i-MiEVTowing with a sling-type truck
BK0140800US.book 20 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-21
6
If a wheel gets stuck in a ditch, do not try to tow the vehicle.
Please contact a certified i-MiEV dealer or a commercial tow
truck service for assistance.
There may be local regulations concerning towing in your area.
Obey the regulations in the area where you are driving your
vehicle.Towing the vehicle by a tow truckTowing with rear wheels off the ground
Place the selector lever in the “N” (NEUTRAL) position. Turn
the electric motor switch to the “ACC” position and secure the
steering wheel in a straight-ahead position with a rope or tie-
down strap. Never place the electric motor switch in the
“LOCK” or “ON” position when towing.
WA R N I N G
!
Never get under your vehicle after it has been lifted
by a tow truck.
Never ride in a vehicle that is being towed.
CAUTION
!
If the transmission or the steering system has a
problem or damage, transport the vehicle on a flat-
bed truck or tow the vehicle with the all wheels off
the ground.
If the electric motor switch is in the “ON” position,
the Active Stability Control (ASC) system may oper-
ate, resulting in an accident. Make sure the electric
motor switch is in the “ACC” position before tow-
ing.
BK0140800US.book 21 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-22 For emergencies
6Operation under adverse driving conditions
N00837200747
If your vehicle becomes stuck in sand, mud or
snow If your vehicle becomes stuck in snow, sand, or mud, it can
often be moved by a rocking motion. Rock your vehicle back
and forth to free it.
Do not spin the wheels. Constant efforts to free a stuck vehicle
can cause transmission failure.
If your vehicle is still stuck after several rocking attempts, call
for a commercial tow truck service.
On wet roads
WA R N I N G
!
When trying to rock your vehicle out of a stuck posi-
tion, make sure that there are no people nearby. The
rocking motion can make your vehicle suddenly
lurch forward or backward, and injure any
bystanders.
CAUTION
!
Do not drive on a flooded road. If you drive on a
flooded road, not only the electric motor unit stops
but also a failure like electric leakage or short circuit
may occur.
If you inevitably had to run on a flooded road and
the vehicle was exposed to water, be sure to have
your vehicle inspected by a certified i-MiEV dealer.
When driving in rain, on water-covered roads, or
through a car wash, water could get into the brake
discs and make them fail temporarily. In such cases,
lightly press the brake pedal to see if they are work-
ing properly. If they are not, press the pedal lightly
several times while driving to dry the brake pads or
linings, then check them again.
When driving in rain, a layer of water may form
between the tires and the road surface (aquaplan-
ing). This loosens your tires’ grip on the road, mak-
ing it difficult to steer or brake properly. When
driving on a wet road:
• Drive your vehicle at a safe speed.
• Do not drive on worn tires.
• Always keep the tires at the correct inflation pres-
sures.
BK0140800US.book 22 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-4 Vehicle care and maintenance
7Hood
N00937500549
To openUse the hood release lever (located under the instrument panel
near the passenger’s door) to unlock the hood.
Pull the lever toward you to release the hood latch.Release the safety lever (A) and lift the hood.
NOTE
To prevent damage to the hood and wipers, make sure the
wipers are at resting position when you open the hood.
WA R N I N G
!
Never use the release lever to unlatch the hood while
the vehicle is in motion.
Do not drive your vehicle unless the hood is locked.
BK0140800US.book 4 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-42 Vehicle care and maintenance
7
Rear combination lights
N00943700487
1. Open the liftgate.
(Refer to “Liftgate” on page 3-16.)
2. Remove the screws (A) that hold the light unit and remove
the light unit.3. Move the light unit toward the rear of the vehicle and
remove the pins (B) of the light unit from the vehicle.
BK0140800US.book 42 ページ ２０１１年９月２９日　木曜日　午後３時２８分