If yo
urvehicle has fittings for two-way radio
equipment, use the power supply or aerial
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's
additional instructions whe ninstalling.
Deviations with respect to wavebands, maxi-
mum transmissio noutputs or aerial positions
must be approved by Mercedes -Benz.
The maximu mtransmission outpu t(PEAK) at
the base of the aerial must not exceed the
following values: Waveband Maximum
transmission output Short wave (f
<54MHz) 100 W
4mw
aveband 30 W
2mw
aveband 50 W
Trunked radio/Tetra 35 W
70 cm waveband 35 W
GSM/DCS/PCS
850/900/1800/1900 10 W
UMTS/LTE 10 W
The following can be used in the vehicle with-
out restrictions:
R
RF transmitters with amaximum transmis-
sion output of up to 10 0mW
R mobil ephones (GS M/DCS/PCS/UMTS/
LTE)
Ther eare no restrictions whe npositioning the
aerial on the outside of the vehicle for the fol-
lowin gwavebands:
R Trunked radio/Tetra
R 70 cm waveband
R GSM/DCS/PCS
R UMTS/LTE Identification plates
Vehicle identification plate with vehi-
cle identification number (VIN)
X
Open the front right-hand door.
You will see vehicle identification plate :. Example: vehicle identification plate
:
Vehicle identification plate
; Vehicle manufacturer (Daimler AG)
= EU type approval number (only for certain
countries)
? VIN
A Maximum permissible gross vehicle
weigh t(kg)
B Maximum permissible mass of vehicle/
trailer combination (kg)
C Maximum permissible front axle load (kg)
D Maximum permissible rear axle load (kg)
E Paint code
i The data shown on the vehicle identifica-
tion plate is example data. Thi sdata is dif-
ferent for every vehicle and can deviate
from the data shown here. You can find the 422
Identification platesTechnical data
