2012 Lancia Musa fuel

USE OF ENVIRONMENTAL-FRIENDLY MATERIALS
All components of the LANCIA Musa are asbestos-free. Padding and the climate control system are free from CFC
(chlorofluorocarbon), the gases deemed responsible for the destruction of the ozone layer. Paint and bolt corrosion
protections are cadmium-free and safe for the air and water.
EMISSION REDUCTION DEVICES (petrol engines)
Three-way catalytic converter
The exhaust system is equipped with a catalyser made of noble metal alloys. It is accommodated in a stainless steel
container which can withstand high operating temperatures.
The catalyser converts unburnt hydrocarbons, carbon oxide and nitrogen oxides contained in exhaust gases (the
harmful gas content in exhaust is also limited by the electronic injection and ignition system), turning them into non-
polluting compounds.
Due to the high temperature reached during operation of the catalytic converter, it is advisable not to park the car over
flammable materials (paper, oil, dry grass, dry leaves, etc.).
Lambda sensors
The lambda sensors detect the oxygen content in exhaust gases. The signal transmitted by the lambda sensors is used
by the injection and ignition system electronic control unit to adjust the air-fuel mixture.
Anti-evaporation system
It is impossible to prevent the formation of petrol vapours, even when the engine is off. For this reason, a system has
been developed with traps the vapours in a special activate carbon canister.
The vapours are sucked in and burnt in the engine during operation.

VERY IMPORTANT
REFUELLING
Petrol engines:refuel with unleaded petrol with an octane rating (RON) of 95 or higher only.
Multijet engines:only refuel with diesel fuel conforming to the European specification EN590.
The use of other products or mixtures may damage the engine beyond repair and consequently cause lapse
of warranty in relation to the damage caused.
STARTING THE ENGINE
Petrol engines:make sure that the handbrake is engaged; set the gearshift lever to neutral; fully depress
the clutch without pressing the accelerator, then turn the ignition key to AV Vand release it as soon as the
engine has started.
Multijet engines:Turn the ignition key to MARand wait for the warning lights Yemto go out; turn
the ignition key AV Vand release it as soon as the engine starts.
PARKING ON FLAMMABLE MATERIAL
The catalytic converter develops high temperature during operation. Do not park on grass, dry leaves,
pine needles or other flammable material: fire risk.
RESPECTING THE ENVIRONMENT
The car is fitted with a system that allows continuous diagnosis of the components correlated with
emissions to ensure better respect for the environment.

K

7
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLSDASHBOARD ........................................................ 8
INSTRUMENT PANEL.......................................... 10
SYMBOLS ............................................................. 11
THE LANCIA CODE SYSTEM .............................. 11
KEY KIT AND DOOR LOCKING SYSTEM .......... 13
IGNITION SWITCH ............................................. 20
INSTRUMENTS ................................................... 21
MULTIFUNCTIONAL DISPLAY
(ON TWO-LINE MODAL PANEL) ........................ 22
MULTIFUNCTIONAL DISPLAY
(ON THREE-LINE COMFORT PANEL) ............... 25
ADJUSTING THE SEATS ..................................... 38
HEAD RESTRAINTS ........................................... 44
ADJUSTING THE STEERING WHEEL ............... 45
REAR VIEW MIRRORS ........................................ 46
CLIMATE CONTROL SYSTEM ........................... 47
MANUAL CLIMATE CONTROL SYSTEM ........... 48
AUTOMATIC TWO-ZONE CLIMATE CONTROL
SYSTEM ................................................................ 52
EXTERNAL LIGHTS ........................................... 62
CLEANING THE WINDOWS ............................... 64
CRUISE CONTROL ............................................. 67
CEILING LIGHTS ................................................ 69
LIGHT CONTROL BUTTONS .............................. 71FUEL CUT OFF SWITCH ..................................... 72
INTERIOR EQUIPMENT ..................................... 73
SMOKER’S KIT ..................................................... 75
SUN VISORS ........................................................ 76
SUNROOF ............................................................ 76
WINDOW WINDERS ............................................ 78
BOOT ................................................................... 80
BONNET .............................................................. 82
ROOF RAILS ........................................................ 83
HEADLIGHTS ..................................................... 84
ABS SYSTEM ....................................................... 85
EOBD SYSTEM .................................................... 86
GSI SYSTEM ......................................................... 87
SOUND SYSTEM ................................................. 87
ACCESSORIES PURCHASED BY THE OWNER . 88
“DUAL DRIVE” ELECTRIC POWER STEERING
SYSTEM ............................................................... 89
PARK SENSOR ..................................................... 90
REFUELLING ...................................................... 92
PROTECTING THE ENVIRONMENT ................. 94
DASHBOARD AND CONTROLS

10
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
L0D0372m
L0D0010m
fig. 7
fig. 8
INSTRUMENT PANEL
Modal fig. 7
A – Speedometer
B – Fuel level gauge with reserve warning light
C – Engine coolant temperature gauge and hot
engine coolant warning light
D – Rev counter
E – Multifunctional display
cmWarning lights for Multijet versions only
Comfort fig. 8
A – Speedometer
B – Fuel level gauge with reserve warning light
C – Engine coolant temperature gauge and hot
engine coolant warning light
D – Rev counter
E – Reconfigurable multifunctional display
cmWarning lights for Multijet versions only

14
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
By using the “Setup Menu” of the
multifunctional display (see the spe-
cific paragraph in the “Dashboard
and controls” chapter), the system
can be set so that only the driver’s
door is unlocked when button Ëis
pressed.
IMPORTANT Powerful radio trans-
missions not related to the car (e.g.
mobile phones, amateur radios, etc.)
may interfere with the frequency of
the remote control. Remote control
operation may be impaired.
Unlocking the doors and the
tailgate
Press button Ábriefly: this will release
the doors, the tailgate, the fuel flap;
the internal ceiling light will come on
and the direction indicators will blink
twice. Unlocking the doors and the
tailgate
Press button Ëbriefly: this will release
the doors, the tailgate, the fuel flap;
the internal ceiling light will come on
and the direction indicators will blink
twice.
The doors are automatically unlocked
when the fuel inertia switch trips. To insert the metallic part Aback in
the grip:
❒hold buttonBpressed
❒move the metallic part A
❒release button Band then turn the
metal insert Auntil it clicks.
Button
Ëis used to open the doors,
tailgate and fuel flap (where pro-
vided).
Button
Áis used to lock the doors,
tailgate and fuel flap (where pro-
vided).
ButtonRis used for remote open-
ing the tailgate.
Only press button B with
the key away from your
body, specifically from your eyes
and from objects which could get
damaged (e.g. your clothes). Do not
leave the key unattended, because
someone, a child especially, may
accidentally press the button while
handling the key.
WARNING

18
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
Type of key
Spare
mechanical
key
Main key with remote control
Direction indicators
flash (for key
with remote
control only)
Deterrence led
Press button Ëto open the fuel flap.
The main functions that can be activated with the keys (with or without remote control) are the following:
Locking the doors
from the outside
Turn key
clockwise
(driver’s side)
Turn key
clockwise
(driver’s side)
Press briefly
buttonÁ
blinks once
Steady for approximately
3 seconds and then
deterrent blinking Unlocking the
tailgate
Hold pressed button R
(for longer than two seconds)
2 blinks
Deterrence led Unlocking the doors
Turn key
anticlockwise
(driver’s side)
Turn key
anticlockwise
(driver’s side)
Press briefly
buttonË
2 blinks
Turning off

21
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
INSTRUMENTS
SPEEDOMETER Fig. 20
This indicates the vehicle speed.
REV COUNTER Fig. 21
This indicates the engine revolution
per minute.
IMPORTANT The electronic injection
control system gradually shuts off the
flow of fuel when the engine is ‘over-
revving’ resulting in a gradual loss of
engine power.
When the engine is idling, the rev
counter may indicate a gradual or
sudden increase of the speed.
This is normal and does not indicate
a fault. It may be caused, for exam-
ple, by the operation of the climate
control system or fan. In these case, a
slow change in engine speed is used to
protect the battery charge.The reserve warning light Aturns on
to indicate that approximately
6 litres of fuel are left in the tank.
Do not travel with the tank nearly
empty: lack of fuel supply could dam-
age the catalyser. FUEL LEVEL GAUGE Fig. 22
The instrument shows the litres of fuel
contained in the tank (see the “Refu-
elling” paragraph for a description).
fig. 20L0D0241mfig. 22L0D0023m
fig. 21L0D0242mfig. 23L0D0024m

24
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
Setting the unit of measurement
Proceed as follows to set the required
unit of measurement (kilometres or
miles):
❒repeatedly press MODEto display
Unit”;
❒press button +or–to change the
unit of measurement;
❒to confirm the setting, hold button
MODEpressed for longer than
two seconds.
Fuel inertia
switch tripped indication
The indication appears automatically
if the fuel inertia switch trips follow a
collision of considerable severity.
The switch cuts off fuel feed.
See the “Fuel inertia switch” chapter
for more information. Proceed as follows to select:
❒repeatedly press MODEuntil
“SPEEd” appears;
❒press +to increase the value cor-
responding to speed (the maxi-
mum limit is 250 km/h);
❒press –to decrease the value cor-
responding to speed (the limit is
30 km/h under which it switches
to “OFF”);
❒to confirm the setting, hold button
MODEpressed for longer than
two seconds.
If after the “FPSon” mes-
sage appears, you smell
fuel or see leaks from the fuel sys-
tem, do not reset the switch to
avoid fine risk.
WARNING