2012 INFINITI G-CONVERTIBLE Owners Manual

Page 409 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual 8-12Maintenance and do-it-yourself
After the operationGUID-B97EAD5B-9BEE-4BB5-93D4-6870CAA2D63C1.Install the engine undercover into
position as the following steps.
a. Pull the center of the small pla

Page 410 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual GUID-E6349F5A-30CB-464F-9C20-522FC0ACF05D
SDI1765A
Check the fluid level in the reservoir.
The fluid level should be checked with the
engine off using the HOT range (
*1: HOT
MAX.,
*2: HOT MIN.) at fl

Page 411 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual 8-14Maintenance and do-it-yourself
SDI2025
BRAKE FLUIDGUID-F2196CC1-91E0-488E-BDF6-C329DF32AC3ECheck the fluid level in the reservoir. If the
fluid is below the MIN line
*2or the brake
warning light c

Page 412 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual Recommended fluid is Genuine NISSAN
Windshield Washer Concentrate Cleaner &
Antifreeze or equivalent.
CAUTION
.Do not substitute engine anti-freeze
coolant for window washer solution. This
may result

Page 413 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual 8-16Maintenance and do-it-yourself
seek medical attention.
. Do not operate the vehicle if the fluid in
the battery is low. Low battery fluid can
cause a higher load on the battery which
can generate

Page 414 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual JUMP STARTINGGUID-06B974E0-9B09-4316-BF6D-083DE94FA734If jump starting is necessary, see“Jump
starting” (P.6-13). If the engine does not
start by jump starting, the battery may
have to be replaced

Page 415 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual 8-18Maintenance and do-it-yourself
ess. If the belt is in poor condition or
loose, have it replaced or adjusted by
an INFINITI retailer.
2. Have the belt condition checked reg- ularly.
GUID-900D5AE6-7

Page 416 of 474

INFINITI G-CONVERTIBLE 2012  Owners Manual Always replace spark plugs with recom-
mended or equivalent ones.
GUID-CC965B91-AF8B-4F99-99C4-ECB0137BE4DE
SDI2363
Remove the retainers*1as illustrated and
pull out the filter element
*2.
The filter