2012 FORD FUSION (AMERICAS) Owners Manual

Page 65 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual 3. Reaching through the wheel well,
remove the rubber bulb access
cover from the housing.
4. Remove the bulb socket by rotating it counterclockwise, then pull it
straight out of the lamp assembly.
5.

Page 66 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual Replacing headlamp bulbs (3.5L engine)
High beam/low beam bulb replacement
For driver side replacement of the high beam/low beam bulbs, do the
following:
1. Make sure the headlamp switch is in the off

Page 67 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual Replacing front parking lamp/turn signal bulbs (2.5L/3.0L engines)
1. Make sure headlamp control is in the off position, then open the hood.
2. Reach over the front bolster.
3. Disengage the windshiel

Page 68 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual Replacing front parking lamp/turn signal bulb (3.5L engine)
For driver side replacement of the front parking lamp/turn signal
bulb, do the following:
WARNING:To reduce the risk of vehicle damage and/o

Page 69 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual For passenger side replacement of the front park/turn signal bulb, do
the following:
1. Turn the steering wheel left to gain access to the wheel well.
2. Remove the press pins located in
the wheel wel

Page 70 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual 4. With the bulb exposed, carefully
remove the bulb from the socket by
grasping the bulb and pulling it
away from the wire harness.
Replace with a new bulb, and reverse the removal steps to complete t

Page 71 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual 4. Remove the bulb socket by
turning it counterclockwise and
pulling it straight out.
5. Pull the bulb from the socket and
push in the new bulb.
6. Install the bulb socket into the
lamp assembly by ro

Page 72 of 370

FORD FUSION (AMERICAS) 2012 1.G Owners Manual Replacing fog lamp bulbs
1. Make sure the fog lamp switch is
in the off position.
2. From underneath the vehicle,
partially remove the tire splash
shield by removing four drive
screws.
After removing