93Comfort
Rear seats
Bench seat with fixed one-piece cushion and split backrest (left hand 2/3, right hand 1/3) which can be folded individually to adapt the load space in the boot.
)Move the corresponding front seat forward
if necessary. )Position the seat belt between the outer and centre head restraints to avoid trapping
the belt when repositioning the seat backrest. )Place the head restraints in the lowposition.
Folding the backrest
)
Pull control 1
forwards to release the seat
back 2
. )
Fold the seat back 2on to the cushion.
)
Straighten the seat back 2
and secure it. )
Check that the red indicator, located next
to the control 1, is no longer visible. ) Put the seat belt back in place on the side of the seat backrest.
Repositioning the seat backrest
When repositioning the seat backrest,take care not to trap the seat belts.
Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)Fold back the rear seats to gain access to
the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )Move the latch to the left.
)After unlocking the boot or the vehicleusing the remote control or the key, press
the opening control, then raise the tailgate.
Opening
Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate to fully close it.
-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
-
when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal andthe display of an aler t message for a fewseconds.
Locking after closing
If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:
