Page 10 of 316
8
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1.
Electric windows/door mirrors/child safety
controls.
2.
Storing driver’s seat and door mirror settings.
3.
Audio/telematic steering mounted controls.
4.
Horn.
5.
Steering mounted controls:
- Speed limiter
- Cruise control
6.
Driver's airbag.
7.
Navigation controls for the audio/telematic and
trip computer systems.
8.
Driver's air vent.
9.
Instrument panel.
10.
Driver's air vent.
11 .
Stop & Start switch.
12.
Lighting/Direction indicators/Foglamp/Voice
recognition control stalk.
13.
Manual headlamp height adjustment.
14.
Steering wheel adjustment.
15.
Knee airbag.
16.
Locking/unlocking of doors and boot.
17.
Checks/Anti-intrusion alarm/Parking space
sensor controls.
18.
Ignition switch.
19.
Windscreen wiper/screenwash control stalk.
20.
Oddments tray or programmable heater
controls.
21.
USB port.
Page 15 of 316
13
FAMILIARISATION
VISIBILITY
Front wipers
Control stalk positions
2
Fast wipe.
1
Normal wipe.
I
Intermittent wipe.
0
Off.
Lighting
Sidelamps.
Dipped/main beam. Lighting off.
)
Pull the control stalk towards you
to change between dipped and main
beam.
Front and rear foglamps on. Front foglamps on. Automatic illumination of head-
lamps.
Rear wiper (Tourer)
)
Rotate control C
to the desired posi-
tion.
Off
Intermittent wipe
Screenwash
Ring A
Ring B
86
Screenwash
)
Pull the screen wipe control stalk to-
wards you.
92-93
92
One press downwards:
- AUTO:
Automatic rain sensitive wip-
ers activated.
- Single wipe.
If the ignition has been switched off for
around 1 minute, automatic wiping must
be selected again.
Page 17 of 316
15
FAMILIARISATION
MONITORING
Instrument panel
The hazard warning lamps
can also be used with the
ignition switched off.
A.
Fuel gauge and low fuel warning lamp.
B.
Cruise control/speed limiter information.
C.
Coolant temperature.
D.
Speedometer.
E.
Instrument panel screen.
F.
Mileage recorder.
G.
Trip mileage recorder reset button.
H.
Rev counter.
I.
Engine oil temperature.
J.
Automatic gearbox information.
- When the ignition is switched on, the orange and
red warning lamps come on.
- When the engine is running, these warning lamps
should go off .
- If any warning lamps remain on, refer to the
"Monitoring" section.
Hazard warning lamps
26
114
Page 19 of 316
17
FAMILIARISATION
PASSENGER SAFETY
Front passenger's airbag
deactivation
Child lock
Seat belts and front
passenger's airbag
The seat belt fastened/unfastened sta-
tus for each seat category is indicated
by the illumination or fl ashing of the
warning lamps for each position:
A.
Not fastened/unfastened front and/
or rear seat belts warning lamp.
B.
Front left-hand seat belt warning lamp.
C.
Front right-hand seat belt warning
lamp.
D.
Rear right-hand seat belt warning
lamp.
E.
Rear centre seat belt warning lamp.
F.
Rear left-hand seat belt warning
lamp.
G.
Front passenger's airbag deactiva-
tion warning lamp.
H.
Front passenger's airbag activation
warning lamp.
35, 37-38
To use a rear facing child seat in the front
passenger's seat position, the passen-
ger's airbag must fi rst be deactivated.
To do this:
)
With the ignition switched off, insert
the key into the switch I
.
)
Turn the key to the "OFF"
position; the
passenger's airbag is deactivated.
The front passenger's airbag deactiva-
tion warning lamp G
comes on when
the ignition is switched on.
123
This deactivates the controls in the rear
of the vehicle, both for the rear windows
and for opening the rear doors from the
inside. The electric child safety device
is activated by pressing button J
.
The activation of the function is indi-
cated by a message on the instrument
panel screen and the lamp on button J
.
113
Page 20 of 316
!!!
18
FAMILIARISATION
Electric parking brake
Never leave a child alone inside
the vehicle with the ignition on,
as they could release the park-
ing brake.
Hill start assist
Manual operation
The MANUAL application/release of
the parking brake is always possible
by pulling/pushing the control lever B
,
keeping your foot on the brake pedal.
Before leaving the ve-
hicle, check that warn-
ing lamp A (!)
(red) in
the instrument panel is
on fi xed (not fl ashing) and that warn-
ing lamp P
(red) in the control lever B
is on.
If you leave the vehicle with the
engine still running, apply the
parking brake manually. Do not leave the vehicle while
it is being held in the temporary
immobilisation hill start assist
phase. To aid starting on a gradient, your ve-
hicle is equipped with a system which
keeps it immobilised for a short time
(about 2 seconds), the approximate
time it takes to move your foot from the
brake pedal to the accelerator pedal.
This system is only active when:
- The vehicle is completely stationary,
with your foot on the brake pedal.
- In certain conditions on a gradient.
- With the driver's door closed. Before leaving the ve-
hicle, check that warn-
ing lamp A (!)
(red) in
the instrument panel is
on fi xed (not fl ashing) and that warn-
ing lamp P
(red) in the control lever B
is on.
Automatic operation
The electric parking brake releases au-
tomatically and progressively when you
press the accelerator. With the vehicle
stationary, the parking brake is auto-
matically applied when the engine is
switched off.
DRIVING SAFELY
128
134
127
Page 22 of 316
20
FAMILIARISATION
)
Move the stalk briefl y upwards or
downwards, without going beyond
the point of resistance; the direction
indicators will fl ash 3 times.
Direction indicators -
"Motorway" function
DRIVING SAFELY
114
Ignition switch
●
S: Steering lock
To release the steering, turn the
steering wheel slightly while turning
the key, but without forcing.
●
M: Ignition on, drive position
●
D: Starter
Release the key as soon as the en-
gine starts. Do not operate the star-
ter when the engine is running.
70
Page 24 of 316
22
FAMILIARISATION
DRIVING SAFELY
Stop & Start
Going into engine STOP mode
The "ECO"
warning lamp comes
on in the instrument panel and
the engine goes into standby:
- with the 6-speed electronic gear-
box system
; at speeds below 4 mph
(6 km/h), press the brake pedal or
put the gear lever into position N
.
Going into engine START mode
You can deactivate the system at any
time by pressing the "ECO OFF"
button;
the button's warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key.
Before refuelling or doing anything
under the bonnet, you must switch off
the ignition with the key. The "ECO"
warning lamp goes
off and the engine restarts:
- with the gear lever in position A
or
M
, release the brake pedal,
- or with the gear lever in position N
and the brake pedal released, move
to position A
or M
,
- or engage reverse.
In certain circumstances, the STOP
mode may not be available; the "ECO"
warning lamp fl ashes for a few sec-
onds, then goes off.
In certain circumstances, START mode
may be invoked automatically; the
"ECO"
warning lamp fl ashes for a few
seconds, then goes off.
141
142
Deactivation / Reactivation
142
Page 32 of 316
I
30
MONITORING
A few definitions
(trip computer)
Range
(miles or km)
Current fuel
consumption
(mpg or l/100 km or km/l)
Average fuel
consumption
(mpg or l/100 km or km/l)
Average speed
(mph or km/h)
Distance travelled
(miles or km)
This indicates the distance which
can still be travelled with the fuel re-
maining in the tank in relation to the
average fuel consumption over the
last few miles (kilometres) travelled.
This value may vary following a
change in the style of driving or
the relief, resulting in a signifi cant
change in the current fuel con-
sumption.
When the range falls below 20 miles
(30 km), dashes are displayed. After
fi lling with at least 5 litres of fuel,
the range is recalculated and is dis-
played when it exceeds 60 miles
(100 km).
If dashes are displayed continu-
ously while driving in place of the
digits, contact a CITROËN dealer
or a qualifi ed workshop. This function is only displayed from
20 mph (30 km/h). This is the average fuel consump-
tion during the last few seconds.
This is the average fuel consump-
tion since the last trip computer zero
reset.
This is the average speed calculated
since the last trip computer zero reset
(ignition on). This indicates the distance travelled
since the last trip computer zero reset.
Stop & Start time
counter
(minutes / seconds or hours /
minutes)
If your vehicle is fi tted with Stop &
Start, a time counter calculates the
time spent in STOP mode during a
journey.
It resets to zero every time the igni-
tion is switched on with the key.
