2012 Citroen C5 ignition

VIII
11 9
SAFETY
SEAT BELTS

Front seat belts

The front seat belts are fi tted with
a pretensioning system and force
limiter.
This system improves safety in the
front seats in the event of a front
impact.
Depending on the seriousness of the
impact, the pretensioning system in-
stantly tightens the seat belt against
the body of the occupant.
Fastening


)
Pull the belt down in front of you
in a steady movement, making
sure that it does not become
twisted.

)
Press the fastening into its buckle.

)
Check that it is properly secured
and that the automatic locking
mechanism operates correctly
by pulling sharply on the belt
strap.

)
The lap strap should be posi-
tioned as low down as possible
in the lap and as tight as pos-
sible.

)
The diagonal strap should be
positioned across the chest and
away from the neck.
Each belt has a reel that adjusts its
length automatically to the girth of
the seat occupant.
The pretensioning seat belts are ac-
tive when the ignition is on.
The force limiter reduces the pres-
sure of the seat belt against the
chest of the occupant, so increasing
his protection.

Reactivation
Below 30 mph (50 km/h), press the
"ESP OFF"
button to reactivate
these systems.
They are reactivated automatically
above 30 mph (50 km/h) or every
time the ignition is switched off.

Operating fault
If this warning lamp comes
on, accompanied by an
audible signal and a mes-
sage in the instrument panel
screen, this indicates a fault with
these systems.
Have it checked by a CITROËN
dealer or a qualifi ed workshop.
The ESP/ASR systems offer ex-
ceptional safety in normal driving,
but this should not encourage the
driver to take extra risks or drive at
high speed.
The correct operation of these sys-
tems depends on observation of
the manufacturer's recommenda-
tions regarding the wheels (tyres
and rims), the braking components,
the electronic components and ob-
servation of the assembly and re-
pair procedures used by CITROËN
dealers.
After an impact, have these systems
checked by a CITROËN dealer or a
qualifi ed workshop.

VIII
122
SAFETY

AIRBAGS



System designed to maximise the
safety of the occupants (with the
exception of the rear centre pas-
senger) in the event of violent col-
lisions. It supplements the action of
the force-limiting seat belts.
If a collision occurs, the electronic
detectors record and analyse the
front and side impacts sustained in
the impact detection zones:


- in the case of a serious impact,
the airbags are deployed instantly
and protect the occupants of the
vehicle (with the exception of the
rear centre passenger); immedi-
ately after the impact, the airbags
defl ate rapidly so that they do not
hinder visibility or the exit of the
occupants,

- in the case of a minor or rear im-
pact or in certain roll-over con-
ditions, the airbags will not be
deployed; the seat belt alone
is suffi cient to provide optimum
protection in these situations.

The airbags do not operate when
the ignition is switched off.
This equipment will only operate
once. If a second impact occurs (dur-
ing the same or a subsequent acci-
dent), the airbag will not operate.
Impact detection zones


A.
Front impact zone.

B.
Side impact zone. Deployment of the airbag(s) is ac-
companied by a slight emission of
harmless smoke and a noise, due to
the activation of the pyrotechnic car-
tridge incorporated in the system.
This smoke is not harmful, but sen-
sitive individuals may experience
slight irritation.
The noise of the detonation may
result in a slight loss of hearing for
a short time.

VIII
123
SAFETY






Front airbags

System which protects the head and
chest of the driver and front passen-
ger in the event of a front impact.
The driver's airbag is fi tted in the
centre of the steering wheel; the
front passenger's airbag is fi tted in
the dashboard above the glove box.

Deployment
The airbags are deployed simultane-
ously, unless the passenger's front
airbag is deactivated, in the event of
a serious front impact to all or part of
the front impact zone A
, in the lon-
gitudinal centreline of the vehicle on
a horizontal plane and directed from
the front to the rear of the vehicle.
The front airbag infl ates between the
front occupant of the vehicle and the
dashboard to cushion their forward
movement.
Deactivation
This warning lamp comes on
in the roof console screen
when the ignition is on and
until the airbag is reactivated.

To assure the safety of your child,
the passenger's airbag must be
deactivated when you install a
"rearwards-facing" child seat on
the front passenger seat.
Otherwise, the child would risk be-
ing seriously injured or killed if the
airbag were deployed.
Activation
When you remove the child seat,
turn switch 1
to the "ON"
position to
reactivate the airbag and so assure
the safety of your front passenger in
the event of an impact.

Operating fault

If this symbol appears in the
instrument panel screen,
accompanied by an audible
warning and a message,
contact a CITROËN dealer or a
qualifi ed workshop to have the sys-
tem checked. The airbags may no
longer be deployed in the event of a
serious impact. Only the front passenger's airbag
can be deactivated:


)
with the ignition off
, insert the
key in the passenger airbag de-
activation switch 1
,

)
turn it to the "OFF"
position,

)
then, remove the key keeping
the switch in this position. If this warning lamp fl ashes,
contact a CITROËN dealer
or a qualifi ed workshop.
If both airbag warning lamps come
on continuously, do not install a
"rearwards-facing" child seat on
the front passenger seat.
Have it checked by a CITROËN
dealer or a qualifi ed workshop.

IX
!!
127
DRIVING
ELECTRIC PARKING BRAKE
The electric parking brake combines
2 operating modes:


- AUTOMATIC

Automatic application when the
engine stops and automatic re-
lease on use of the accelerator
(automatic operation by default),

- MANUAL

Manual application / release of
the parking brake is always pos-
sible by pulling control lever A

while pressing the brake pedal.


Automatic operation


Application with the engine off
With the vehicle stationary, the park-
ing brake is automatically applied
when the engine is switched off.

The application of the parking brake
is confi rmed by:
Application with the engine running
With the engine running and the ve-
hicle stationary, in order to immobi-
lise the vehicle you need to manually
apply the parking brake by pulling

on control lever A
.
The application of the parking brake
is confi rmed by:

- warning lamp P
in the con-
trol lever A
coming on,
Before leaving the vehicle,
check that warning lamp P

and the warning lamp in the
instrument panel are on fi xed (not
fl ashing).
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake.
- display of a message "parking
brake on" in the instrument panel
screen.
The noise of operation will confi rm to
you the application/ release of your
electric parking brake.

- warning lamp P
in the con-
trol lever A
coming on,

- display of a message "parking
brake on" in the instrument panel
screen.
When the driver’s door is opened, a
beep is heard and a message dis-
played if the parking brake has not
been applied.
Before leaving the vehicle,
check that warning lamp P

and the warning lamp in the
instrument panel are on fi xed (not
fl ashing).
-
this warning lamp in the in-
strument panel coming on,

- this warning lamp in the in-
strument panel coming on,

IX
!
129
DRIVING

Release
With the ignition on or the engine
running, to release the parking
brake, press on the brake pedal,
push then release
control lever A
.
The full application of the parking
brake is confi rmed by:


- warning lamp P
in the
control lever A
going off,

- display of a message "parking
brake released" in the instru-
ment panel screen.
If you push control lever A
without
pressing the brake pedal, the park-
ing brake will not be released and
the message "Foot on brake" will be
displayed in the instrument panel.

When stationary, with the en-
gine running, do not press the
accelerator pedal unneces-
sarily, as you may release the
parking brake.


Maximum application

If necessary, you can utilise maxi-
mum application
of the parking
brake. It is obtained by means of a
long pull
on control lever A
, until
you see the message "Max appli-
cation of the parking brake" and a
beep is heard.

Maximum application is essen-
tial:



- in the case of a vehicle towing
a caravan or a trailer, if the au-
tomatic functions are activated
but you are applying the parking
brake manually,

- when the effective gradient you
are parked on is variable (e.g. on
a ferry, in a lorry, during towing).


- In the case of towing, a loaded
vehicle or parking on a gradient,
turn the front wheels towards the
pavement and engage a gear
when you park.

- After a maximum application, the
release time will be longer.



Particular situations

In certain situations (starting the en-
gine...), the parking brake can auto-
matically alter its level of application.
This is normal operation.
To advance your vehicle a few cen-
timetres without starting the engine,
but with the ignition on, press on the
brake pedal and release the parking
brake by pushing
then releasing

control lever A
.
The full release of the parking brake
is confi rmed by the warning lamp P

in the control lever and the warning
lamp in the instrument panel going
off and the display of a message
"parking brake off" in the instrument
panel screen.
If the parking brake malfunctions
while applied
or if the battery is fl at,
an emergency release is still pos-
sible.
To ensure correct operation of the
parking brake and therefore your
safety, the number of successive
application/release operations is
limited to eight.
If this number is exceeded, you are
warned by the message "Parking
brake faulty" and a warning lamp
fl ashes.
- this warning lamp in the in-
strument panel going off,

IX
!
131
DRIVING

)
On sloping ground: immobilise
the vehicle by placing the chocks
(if your vehicle has them) in front
or behind the two front wheels,
against the slope
On level ground: immobilise the
vehicle by placing the chocks
(if your vehicle has them) in
front and behind one of the front
wheels.

)
Open the lower compartment of
the centre armrest by pulling it.

)
Ensure that the cup holder B
is
folded away.

)
Remove the rubber mat covering
the base of the armrest.
This strap does not permit
application of the parking
brake.
To re-engage the electric parking
brake (after rectifying the malfunc-
tion or battery failure), give a long
pull on the control A
until the park-
ing brake warning lamp (!) fl ashes
in the instrument panel then give a
second long pull until this warning
lamp is on fi xed.
The time required for the subse-
quent application may be longer
than during normal operation.
It is essential that the ignition is
not switched on until the parking
brake has re-engaged (fl ashing of
the warning lamp (!) in the instru-
ment panel then the warning lamp
on fi xed) to avoid damage to the
parking brake.
Take care not to allow moisture or
dust in the proximity of the diagnos-
tic socket D
which is essential for
the maintenance of your vehicle.
)
Release the strap from its loca-
tion C
.

)
Pull the strap to release the
brake. A loud knock confi rms the
release of the brake.

)
Take care to put the strap
back in its location C
correct-
ly. Otherwise, it will no longer
be possible to apply the brake.
Contact a CITROËN dealer or a
qualifi ed workshop.

)
Put the rubber mat back in place
on the base of the armrest.

IX
133
DRIVING


SITUATION



CONSEQUENCES




4

Display of messages " Parking brake faulty
"
and " Anti roll-back
fault
" and of the
following warning lamps:
and/or
fl ashing

- The automatic functions are deactivated.

- The hill start assist is not available.
To apply the electric parking brake:


)
Immobilise the vehicle and switch off the ignition

)
Pull the control lever for at least 5 seconds or until maximum
application.

)
Switch on the ignition and check that the electric parking brake
warning lamps are on.


- Application may take longer than in normal operation.

- If warning lamp (!)
fl ashes or if the warning lamps do not come
on when the ignition is switched on, this method does not work.
Have it checked by a CITROËN dealer or a qualifi ed workshop.
To release the electric parking brake:


)
Switch on the ignition.

)
Push the control lever and hold it for approximately 3 seconds.


5

Display of message " Parking brake control
faulty – automatic mode activated
" and
the following warning lamps:
and/or
fl ashing

- Only the functions for automatic application on switching off
the engine and automatic release on acceleration are
available.

- Manual application/release of the electric parking brake and
dynamic emergency braking are unavailable.


6

Display of message " Parking brake faulty
"
and of the following warning lamp:
fl ashing



- Application of the parking brake is not guaranteed.

- The parking brake is temporarily unavailable.
It this situation arises:


)
Wait approximately 3 minutes.

)
After 3 minutes, if the warning lamp is still fl ashing, try to
reinitialise the parking brake, either by pushing and releasing
the control A
while pressing the brake pedal or by means of a
long pull on control lever A
.


7

Battery problem

-
Illumination of the battery warning lamp makes it essential to stop the
vehicle as soon as traffi c allows. Stop and immobilise your vehicle.


- Apply the electric parking brake before switching off the engine.

IX
!
140
DRIVING

When immobilising the ve-
hicle, with the engine running,
you must place the gear lever
in neutral N
.
Before carrying out any work in the
engine compartment, check that
the gear lever is in neutral N
and
that the parking brake is applied.



SPORT programme
Stopping the vehicle

Before switching off the engine, you
can choose to:


- move to position N
to engage
neutral,

- leave the gear engaged; in this
case, it will not be possible to
move the vehicle.
In both cases, you must apply the park-
ing brake to immobilise the vehicle.

Operating fault

With the ignition on, the fl ashing of
AUTO
, accompanied by an audible
signal and a message in the mul-
tifunction screen, indicates a fault
with the gearbox.
Have it checked by a CITROËN
dealer or a qualifi ed workshop.


)
Wit the gear lever at A
and the
engine running, press button S
to
activate the SPORT
programme,
which provides a more dynamic
driving style.

S
appears in the instrument panel.


)
Press the S
button again to
switch it off.

S
then disappears from the instru-
ment panel screen.
You must press the brake pedal
when starting the engine.
Whatever the circumstances, you
must manually apply the parking
brake when parking, unless the
parking brake is programmed in au-
tomatic mode.