2012 Citroen C1 RHD ignition

52Safety
Front seat belts(s) not fastened /
unfastened warning lamp *
Not fastened
Unfastened
When the ignition is switched on, the
warning lamp flashes if the driver
and
/or front passenger has not fastened their seat belt.
Above a speed of about 12 mph (20 km/h) and for two minutes, the warning lamp flashes accompanied by an increasing audible signal.
After these two minutes, the warning lampcontinues to flash but without the audiblesignal, if the driver and/or front passenger hasnot fastened their seat belt.
The warnin
g lamp flashes when the
driver and/or the front passenger unfastens their seat belt with the engine running.
Above a speed of about 12 mph (20 km/h) and for two minutes, the warning lamp flashes accompanied by an increasing audible signal.
After these two minutes, the warning lampcontinues to flash but without the audiblesignal, if the driver and/or front passenger has
not fastened their seat belt.

*
Dependin
g on version.

54Safety











Airbags Front airbags


Front airbag fault

Immediately after the impact, the airbags
deflate rapidly so that they do not hinder
the visibility of the occupants nor their exit if
necessary from the vehicle. The air bags are
not deployed in the case of minor impacts, rear impacts or in cer tain roll-over conditions. The seat belt is sufficient to ensure maximumprotection in these situations. The seriousness
of a collision depends on the nature of the
obstacle and the speed of the vehicle at the
m
oment of the collision.
Airbags only operate when the ignition
is switched on. When they are deployed,
a noise is heard during inflation.
The airbags have been designed to maximise
the safety of the occupants in the event of serious collisions. They work in conjunction
with the force-limiting seat belts. Theelectronic detectors register and analyse any abrupt deceleration of the vehicle in the
impact detection zones (see diagram): if the
deployment threshold is reached, the airbags
in
flate instantly and protect the occupants of
the vehicle.

These are
fitted in the centre of the steeringwheel for the driver and in the dashboard for the front passenger. They are deployed simultaneously, except in cases where thepassenger's airbag is deactivated, in theevent of a serious front impact applied in the
impact zone A
in the longitudinal centreline
of the vehicle, on a horizontal plane and from
th
e front of the vehicle towards the rear. T he
airba
g inflates between the front occupant of
the vehicle and the dashboard to cushion hisfor ward movement. The airbags therefore limit
the risk of injury to the head and chest.
A.Front impact zone.B. Side impact zone.
Note:
the gas escaping from the airbags can be a minor irritant.
Flashin
g indicates an airbag fault, contact a CITROËN dealer or aqualified workshop to have the
system checked. The airbags mayno longer be deployed in the event of a serious impact.
Impact detection zones

7
55 Safety
To ensure the safety of your child, it is essential to deactivate the passenger'sairbag when you install a "rear-facing"child seat on the front passenger seat.
Other wise, the child would risk being
seriously injured or killed if the air bag wereto inflate.)With the ignition switched off, inser t thefkey into the passenger airbag deactivation switch 1, turn it to the "OFF"position, then remove the key keeping the switch in this position.
In the "OFF"position, the passenger airbag willnot be deployed in the event of an impact.
As soon as the "rear-facing"
child seat is
removed, turn the airbag switch to the "ON"position to re-activate the airbag and thus ensure the safety of your passenger in the
event of an impact. If the passen
ger airbag is
deactivated, the warning lamp in the
instrument panel remains on until the
passen
ger airbag is reactivated.
Flashin
g indicates a fault with at least
one of these airbags.Contact a CITROËN dealer or aqualified workshop to have thesystem checked. The airbags may no longer be
deployed in the event of a serious impact.
Deactivation (check)

Airba
g fault


*
According to version.












Lateral airbags * and
curtain airbags *

The lateral airbags are built into the front seatbacks on the door side.
The deployment of these airbags requires a
serious side impact applied in the side impact
zone B , perpendicular to the longitudinalcentreline of the vehicle, on a horizontal plane and from the outside of the vehicle towards the inside. The lateral airbag inflates between the front occupant of the vehicle and the door trimpanel. It therefore limits the risk of injury to
the chest.
The cur tain airba
gs are built into the headlining.
The cur tain airba
g inflates between the front or rear occupant and the windows. It therefore
limits the risk of head injuries. In the event of a
minor impact or bump on the side of the vehicle
or if the vehicle rolls over, the airbag may notbe deployed. The airbag is not deployed in the event of a front or rear collision.
Deactivating the
passenger's airbag

9
65 Practical information
)As far as possible, immobilise the vehicle
on level, stable, non-slippery ground. )Apply the parking brake, switch off the
ignition and engage first gear or reverse
for the manual gearbox, position Nfor theelectronic gearbox. The followin
g tools are installed in a carrier,
located in the centre of the spare wheel:
1
. Wheelbrace 2.Jack with handle 3.Removable towing eye

Access to the spare wheel and
the jack in the boot
) Remove the carpet then the plastic cover using the handle.



Tyre pressures

These are indicated on the label positioned on the inner pillar of the left door, see
"Identification markings".



























Changing a wheel
)
If necessary, chock the wheel diagonally
opposite the wheel to be changed.) You must ensure that the occupants leave
the vehicle and wait in a safe location.

Parking the vehicle
To o l s

78Practical information
Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before disconnecting the battery.


Following reconnection of thebattery

Following reconnection of the battery, switch on
the i
gnition and wait 1 minute before star ting to
permit initialisation of the electronic systems.However, if problems remain following this
operation, contact a CITROËN dealer or aqualified workshop.
Referring to the corresponding section, you
must yourself reinitialise:


- the remote control key,

- the audio system.

86Checks






Checking levels
There are two marks on thedipstick:A= maximum
If you fill past this mark, contact a CITROËN dealer or a qualified workshop. B= minimum
Never allow the level to fallbelow this mark.
Dipstick
Brake fluid level

The brake fluid level should be close to the
"MA X" mark. If it is not, check the brake pad
w
ear. If a level drops si
gnificantly, have the corresponding system checked by a CITROËN dealer or a
qualified workshop.
Check all of these levels re
gularly and top them up if necessary, unless other wise indicated.
Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns).
Oil level
The check is carried out either when the ignition is switched on using the oil level indicator on the instrument panel, or using the
dipstick.
This manual check will only be correct if the
vehicle is on level ground and the engine has
been off for more than 30 minutes.
It is normal to top up the oil level between two ser vices (or oil changes). CITROËN recommends that you checkthe level, and top up if necessary, every 3 000 miles (5 000 kms). After topping up the oil, the check whenswitching on the ignition with the oillevel indicator in the instrument panelis not valid during the 30 minutes after topping up.


Engine oil change

Refer to the servicing booklet for details of the
interval for this operation.
In order to maintain the reliabilit
y of the engine
and emission control system, the use of
additives in the engine oil is prohibited.

Oil specifi cation

The oil must be the correct grade for your engine and conform to the manufacturer'srecommendations.



Changing the fl uid

Refer to the servicing booklet for details of the
interval for this operation.

10
87 Checks
Screenwash fluid level
Top up the level when necessary.
Coolant level
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced
with plain water.



Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet the
D
OT4 standard.


The coolant level should be close to the "MAX" mark but should never exceed it.
When the engine is warm, the temperature of
the coolant is regulated by the fan. This can
operate with the ignition off.
In addition, as the cooling system is pressurised, wait at least one hour after switching off the engine before carrying out anywork.
To avoid any risk of scalding, unscrew the cap by two turns to allow the pressure to drop.
When the pressure has dropped, remove thecap and top up the level.
Changing the coolant
The coolant does not have to be changed.
Fluid specifi cation
The coolant must conform to the
manufacturer's recommendations.









Used products
Avoid prolonged contact of used oil or fluids
with the skin.
M
ost of these fluids are harmful to health or indeed very corrosive.
Do not discard used oil or fluids intosewers or onto the ground.Take used oil to a CITROËN dealer or a qualified workshop (France) or to an authorised waste disposal site.

03
VOLMENUSRC/
LISTESCSEEK +
_MP3
100











CD, USB
AUDIO


PLAYING A COMPILATION

Insert an MP3 compilation in the CD pla
yer or connect a memory stick to the USB port.
The system creates playlists
(temporary memory) the creation timefor which can take from a few seconds to several minutes.
The pla
ylists are updated every time the ignition is switched off or aUSB memory stick is connected.
Pla
y starts automatically after a period which depends on the capacity of the USB memory stick.

At a fi rst connection, the order suggested is by folder.When connecting again, the order previously chosen is retained.
To pla
y a disc or memory stick whichhas already been inserted, press
SRC/TELseveral times in succession and select " CD " or " USB".


Press one of the buttons to select the next or previous track.

Pr
ess one of the buttons to select the next or previous folder in the order chosen.

Pr
ess and hold one of the buttons for
fast forwards or backwards.