24GETTING TO KNOW YOUR CAR
Display of selected driving mode
(“Alfa DNA” system)
(for versions/markets, where provided)
On versions equipped with a “Reconfigurable multifunctional Dis-
play” a message + symbol associated with the selected driving
mode - “DYNAMIC”, “NORMAL” or “ALL WEATHER” - is shown.
A warning message is shown on the display if one of these dri-
ving modes is not available.
On versions equipped with a “Multifunctional display” a letter (d
or a) associated with the selected driving mode is shown togeth-
er with a dedicated message.
Engine oil level display
(for versions/markets, where provided)
When the ignition key is turned to MAR the display shows, for a few
seconds, the engine oil level. In the event of an insufficient engine
oil level, a warning message appears on the display.
IMPORTANT To determine the correct engine oil quantity, always check
using the marks on the dipstick (see paragraph "Checking levels" in
"5" section).
IMPORTANT For a correct engine oil level indication, perform the check
with the car parked on a level surface.
IMPORTANT To perform the engine oil reading correctly, after turning
the key to MAR wait for about 2 seconds before starting the engine.
IMPORTANT The engine oil level may increase after a long stop.
T.P.M.S. system failure (amber)
(for versions/markets, where provided)
This warning light (or symbol in the display) comes on (on some
versions together with a message in the display) when a fault is
detected in the T.P.M.S tyre inflation pressure monitoring system:
if this occurs, contact your nearest Alfa Romeo Authorised Service
as soon as possible.
Should one or more wheels be fitted without sensors, the display
will show a warning message until initial conditions are restored.
Check tyre inflation pressure
(for versions/markets, where provided)
If this warning light (or symbol in the display) comes on (on some
versions together with a message in the display) this indicates that
the tyre pressure is below the optimum value recommended to
guarantee long tyre life and low fuel consumption. It may also in-
dicate a slow loss of pressure.
Should two or more tyres be discovered to be in the above men-
tioned condition, the display will show the indications corresponding
to each tyre in sequence. Under these circumstances you should
restore the correct pressure values (see chapter 6).
246TECHNICAL DATA
Synthetic-based oil, grade SAE 5W-40 ACEA C3.
FIAT 9.55535-S2 Classification
Synthetic-based oil, grade SAE 5W-30
FIAT 9.55535-S1 Classification
For diesel engines, in emergency cases where genuine products are not available, lubricants with min. performance ACEA C2 are acceptable.
If this is the case, the best engine performance is not guaranteed. We recommend replacing the lubricant as soon as possible at an Alfa Romeo
Authorised Service.
The use of products with characteristics that are not up to ACEA C3 (for petrol engines) and ACEA C2 (for diesel engines) standard could cause
engine damage not covered by the warranty.
For petrol versions with Multi Air system, the use of lubricants with features below ACEA C3 and SAE grade other than 5W-40 could cause damage
to the engine, not covered by the warranty.
SELENIA StAR P.E.
Contractual Technical
Reference N
°F603.D08
SELENIA WR P.E.
Contractual Technical
Reference N
°F510.D07
According to
Scheduled
Servicing Plan
According to
Scheduled
Servicing Plan
FLUIDS AND LUBRICANTS
RECOMMENDED PRODUCTS AND SPECIFICATIONS
Use Fluid qualitative specifications and lubricants Fluids and lubricants Interval
for correct vehicle operation original replacement
Lubricants for
petrol engines
Lubricants for
diesel engines
