2012.5 Peugeot RCZ ignition

4/
VISIBILITY
DIRECTIONAL LIGHTING
When the dipped or main beam headlamps are on, this function enables
the light beams to provide improved lighting of the side of the road when
cornering.
The use of this function, from approximately 12 mph (20 km/h) and
associated with the xenon headlamps only, considerably improves the
quality of your lighting when cornering.

with directional lighting


without directional lighting



PROGRAMMING

OPERATING FAULT

When stationary or moving at very low speed or when reverse
gear is engaged, the function is inactive.
The status of the function remains in the memory when the
ignition is switched off. If a fault occurs, this warning lamp fl ashes in the instrument
panel, accompanied by a message in the screen.
Contact a PEUGEOT dealer or a qualifi ed workshop. The function is activated or deactivated via the vehicle
confi guration menu.

4/
VISIBILITY









WINDSCREEN AND HEADLAMP WASH



)
Pull the windscreen wiper stalk towards you. The windscreen wash
then the windscreen wipers operate for a fi xed period.
The headlamp washers only operate when the dipped beam
headlamps are on
.











Screenwash/headlamp wash low


In the case of vehicles fi tted with headlamp washers, when
the minimum level of the reservoir is reached, this warning
lamp and/or the service warning lamp is displayed in the
instrument panel, accompanied by an audible signal and a
message in the screen.
Next time you stop, fi ll the screenwash / headlamp wash fl uid reservoir.
The warning lamp is displayed when the ignition is switched on, or
every time the stalk is operated, until the reservoir is fi lled.

100












AUTOMATIC RAIN SENSITIVE WINDSCREEN
WIPERS
The windscreen wipers operate automatically, without any action on the
part of the driver, if rain is detected (sensor behind the rear view mirror),
adapting their speed to the intensity of the rainfall.

Activation

This is controlled manually by the driver by pushing the stalk
downwards to the "AUTO"
position.
It is accompanied by a message in the screen.


Switching off

This is controlled manually by the driver by moving the stalk upwards
then returning it to position "0"
.
It is accompanied by a message in the screen.


Operating fault

If an automatic wiping malfunction occurs, the wipers will operate in
intermittent mode.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop. The automatic rain sensitive wipers must be reactivated if the
ignition has been off for more than one minute, by pushing the
stalk downwards.
Do not cover the rain sensor, linked with the sunshine sensor
and located in the centre of the windscreen behind the rear view
mirror.
Switch off the automatic rain sensitive wipers when using an
automatic car wash.
In winter, to avoid damaging the wiper blades, it is advisable
to wait until the windscreen is completely clear of ice before
activating the automatic rain sensitive wipers.

4/
VISIBILITY









SPECIAL POSITION OF THE WINDSCREEN
WIPERS

To maintain the effectiveness of the "fl at-blade" type of wiper
blades, it is advisable to:


- handle them with care,

- clean them regularly using soapy water,

- avoid using them to retain cardboard on the windscreen,

- replace them at the fi rst signs of wear.

This position permits release of the windscreen wiper blades.
It is used for cleaning or replacement of the blades. It can also be
useful, in winter, to detach the blades from the windscreen.



)
Any action on the wiper stalk in the minute after switching off the
ignition places the blades vertically on the screen.

)
To park the blades again, switch on the ignition and operate the
wiper stalk.

102
DIRECTION INDICATORS
If you forget to cancel the direction indicators for more than
twenty seconds, the volume of the audible signal will increase if
the speed is above 40 mph (60 km/h).

)
Left: lower the lighting stalk passing the point of resistance.

)
Right: raise the lighting stalk passing the point of resistance.
HAZARD WARNING LAMPS

A visual warning by means of the direction indicators to alert other road
users to a vehicle breakdown, towing or accident.


)
Press this button, the direction indicators fl ash.
They can operate with the ignition off.







AUTOMATIC OPERATION OF HAZARD
WARNING LAMPS
When braking in an emergency, depending on the deceleration, the
hazard warning lamps come on automatically.
They switch off automatically the fi rst time you accelerate.


)
You can also switch them off by pressing the button.
Deactivating the ESC/ASR systems also deactivates the automatic
operation of the hazard warning lamps; refer to the "Trajectory control
systems - Deactivation" section.

5/
SAFETY


Deactivation

In exceptional conditions (starting a vehicle which is bogged down,
stuck in snow, on soft ground, ...), it may be advisable to deactivate
the ASR and ESP systems, so that the wheels can move freely and
regain grip.


)
Press the button located in the centre of the dashboard.
Illumination of the indicator lamp in the button indicates that these
systems are deactivated.
This action also deactivates the automatic operation of the hazard
warning lamps.


Reactivation

These systems are reactivated automatically each time the ignition is
switched back on.


)
Press the button again to reactivate them manually.
This action also reactivates the automatic operation of the hazard
warning lamps.


Operating fault

These systems offer exceptional safety in normal driving, but this
should not encourage the driver to take extra risks or drive at high
speed.
The correct operation of these systems depends on observation of
the manufacturer's recommendations on :


- wheels (tyres and rims),

- braking components,

- electronic components,

- assembly and repair procedures.
After an impact, have these systems checked by a PEUGEOT
dealer or a qualifi ed workshop.
The illumination of this warning lamp and the indicator lamp in
the button, accompanied by an audible signal and a message
in the screen, this indicates a malfunction of these systems.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop dealer.

5/
SAFETY
ACTIVE SPOILER
System which improves the aerodynamics and stability of the vehicle
when driving. It can be controlled automatically or manually.

OPERATION


The use of the vehicle must comply with the legislation in force
in your country. This system can be used to its full potential on a
closed circuit.



Automatic mode

The spoiler rises automatically according to the speed and has two
positions.


- When the speed of the vehicle is higher than 50 mph (85 km/h),
the spoiler rises automatically to the intermediate position A
.
It remains in this position for as long as the speed remains above
35 mph (55 km/h).

- If the speed of the vehicle falls below 35 mph (55 km/h), the spoiler
retracts automatically.

- When the speed of the vehicle is higher than 95 mph (155 km/h),
the spoiler rises automatically to the maximum position B
. It remains
in this position for as long as the speed remains above 90 mph
(142 km/h).

- If the speed of the vehicle falls below 90 mph (142 km/h),
the spoiler retracts automatically to the intermediate position.
In this mode, the indicator lamp in the control button is off.


Manual mode

To control the operation of the spoiler manually, with the ignition on:


)
press the control button briefl y, the spoiler rises to the maximum
position B
.
In this mode, the indicator lamp on the control button is on.
When stationary or moving at less than 6 mph (10 km/h), press and
hold the button until the indicator lamp goes off, the spoiler then retracts
completely.

11 0
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.

MAINTENANCE


To maintain the spoiler, with the vehicle stationary, ignition on:


)
raise the spoiler to the maximum position B
by pressing the button
briefl y,

)
once the cleaning is complete, retract the spoiler: press and hold
the button until the end of the manoeuvre.
The keep this system in good working order, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.

OPERATING FAULT

If the control system fails, the indicator lamp in the control button
fl ashes, accompanied by an audible signal and a message in the
screen. As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
If the problem persists and you wish to retract the spoiler:


)
stop where it is safe to do so,

)
switch off the ignition,

)
switch the ignition on again.
If the indicator lamp no longer fl ashes, the failure was temporary, the
system has resumed normal operation. To retract the spoiler, refer to
the paragraph "To exit from manual mode".
If the indicator lamp fl ashes again and the spoiler is still raised, the
system is still faulty.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
In the event of a system operating fault (e.g. jamming of the spoiler), the
indicator lamp in the control button fl ashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
Before washing the vehicle, always retract the spoiler into its
housing.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing.

Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
To exit from manual mode:


)
press the button briefl y: the indicator lamp on the button goes off
(return to automatic mode).
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.