2012.5 Citroen C3 PICASSO RHD ignition

Visibility
88
Vertical windscreen wiper
position
Automatic rain sensitive
w
indscreen wipers
The windscreen wipers operate automatically,
without any action on the par t of the driver, if rain
is detected (sensor behind the rear view mirror),adapting their speed to the intensity of the rainfall.
Activation
This is controlled manually by the driver by pushing the stalk downwards to
the "AUTO"
position.
It is accompanied by a message in the screen. This position allows the wiper blades to be lifted
for winter parkin
g, cleaning or replacement
without damaging the bonnet.
In the minute following switching off of the ignition, any action on the wiper stalk positions
the wipers vertically.
To park the wipers after this has been done,switch on the ignition and operate the wiper stalk.
Switching off
This is controlled manually by the driver bymoving the stalk upwards then returning it to position "0"
.


Operating fault

If an automatic wiping malfunction occurs, the
wipers will operate in intermittent mode.
Have it checked b
y a CITROËN dealer or aqualified workshop.
It is accompanied by a message in the screen.The automatic rain sensitive wipers must be reactivated if the ignition hasbeen off for more than one minute, bypushing the stalk downwards.
Do not cover the rain sensor, linked withthe sunshine sensor and located in thecentre of the windscreen behind the rear view mirror. Switch off the automatic rain sensitive wipers when using an automatic car wash. In winter, to avoid damaging the wiper
blades, it is advisable to wait until thewindscreen is completely clear of icebefore activating the automatic rain sensitive wipers.

To retain the effectiveness of the "flat-
blade" wiper blades, it is advisable to:


- handle them with care,

- clean them regularly using soapywater,

- not use them to hold a sheet of cardboard against the windscreen,

- replace them at the first signs of wear.

5
Visibility
89














Courtesy lamps Selection and control of the various passenger compartment lamps.
1.Front courtesy lamp2.Map reading lamps3.Rear cour tesy lamp
Front and rear courtesy lamps


Map reading lamps
)
With the ignition on, press thecorresponding switch. In this position, the courtes
y lamp comes on gradually:
Permanentl
y off.

Permanent lighting. It switches o
ff gradually:
- when the vehicle is locked,
- when the ignition is switched on,
-
30 seconds after the last door is closed. - w
hen the vehicle is unlocked,
- when the key is removed from the ignition,
- when a door is o
pened,
- when the remote control locking button is
pressed, in order to locate your vehicle.
Footwell lighting
These lamps come on at the same time as the courtesy lamps.
In permanent lighting mode, different lighting times are available:


- with the ignition off, approximately ten minutes,

- in energy economy mode, approximately
thirty seconds,-with the engine running, unlimited.

5
Visibility
91
This comes on automatically when the boot is
opened and goes off automatically when the boot is closed.
Torch
This is a removable lamp, fitted in the side of
the boot, which can be used to illuminate the boot or as a torch.




Boot lamp

Use
)
Extract the torch from its location by pullingit from the front.)
Press the switch, located on the back, to switch the torch on or off. )
Unfold the suppor t, located on the back, toset down and raise the torch; for example,
when changing a wheel.



Storing
)
Put the torch back in place in its locationstarting with the rear.
If you have forgotten to switch off the torch,
this switches it off automatically.
It the torch is not engaged correctly, it may notcharge and may not come on when the boot is opened.

Operation
This torch operates with NiMH typerechargeable batteries.
It has a batter
y life of approximately 45 minutes and charges while you are driving.
The lighting time varies according to the circumstances:
- when the ignition is off, approximatelyten minutes,

- in energy economy mode, approximately thirty seconds,
- when the engine is running, no limit.
Obser ve the polarities when fitting the batteries.Never replace the rechargeable batteries with single-use batteries.

6
Fittings
97
Lift the catch to release the table and unfold it.


Aircraft style tables
Reading lamps are built into the back of the
front seats, behind the tables. With the ignition
on, they illuminate the top of the table without inconveniencing other passengers.
They are only accessible if the table isunfolded.) Press the button to switch the lamp on or off.
Individual reading lamps
Side blinds

Blinds are available for the side windows.
Pull the side blind longways by the tab to use it.
Always guide the blind slowly using the tab.
Do not place hard or heavy objects on the table. They could becomedangerous projectiles in the event of sharp braking or impact. As a safety precaution, if too much pressure is exer ted the table will fold downwards.

Child safety
112





Electric child lock


Switching on
)
Press button A
.
The indicator lamp in button Acomes on, accompaniedAby a message in the multifunction screen.
This indicator lamp remains on until the childlock is switched off.


Switching off
)
Press button A
again.
The indicator lamp in button A
goes off,
accompanied by a message in the multifunction screen.
This indicator lamp remains off until the child
lock is switched on. Switchin
g the child lock on isconfirmed by the temporary
illumination of this warning lamp in
the translucent instrument panel.

Any other status of the indicator lampindicates a fault with the electric child lock. Have it checked by a CITROËN dealer or a qualified workshop.

This system is independent and in nocircumstances does it take the place of the central locking control. Check the status of the child lock eachtime you switch on the ignition.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of a serious impact, the electric child lock is switched off automatically to permit the exit of therear passengers.
Control system to prevent opening of the rear
doors using their interior controls and use of the rear electric windows.
The control is located on the driver's door,
with the electric window controls, or on the
dashboard switch panel, if
your vehicle is fitted
with m
anual rear windows.

8
Safety
113














Direction indicators






Hazard warning lamps
)
Press this button, the direction indicators flash.
They can operate with the ignition off.
Automatic operation of
hazard warnin
g lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lampscome on automatically.
They switch off automatically the first time youaccelerate. ) You can also switch them off by pressing
the button.










Horn
)
Press one of the spokes of the steering wheel.
Audible warning to aler t other road users to an
imminent danger.

"Motorway" function

Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash 3 times. A visual warnin
g by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.
)Lower the lighting control stalk fully when moving to the left. )Raise the lighting control stalk fully when moving to the right.

If you forget to cancel the direction indicators for more than twenty seconds, the volume of the audible signal will increase if the speed is above40 mph (60 km/h).

Use the horn moderately and only in thefollowing cases:


- immediate danger,

- over taking a cyclist or pedestrian,

- when approaching an area wherethere is no visibility.

Safety
116

Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft ground...), it may be advisable to deactivate the
ASR and ESP systems, so that the wheels can
move freely and regain grip.) Press the "ESP OFF"
button, located in
the centre of the dashboard.
If this warning lamp comes on
in the instrument panel and the
indicator lamp on the button comes
on
, this indicates that the ASR and
ESP systems are deactivated.

Reactivation

These systems are reactivated automatically each time the ignition is switched back on or
from 30 mph (50 km/h).) Press the "ESP OFF"
button again to
react
ivate them manually.

Operating fault

If this warning lamp comes on,
accompanied by an audible signal
and a messa
ge in the multifunction
screen, this indicates a malfunction
of these s
ystems.














Trajectory control systems
The anti-slip regulation (also known as Traction Control) optimises traction to prevent skidding
of the wheels, by acting on the brakes of the
driving wheels and on the engine.
The electronic stabilit
y programme acts on the
brake of one or more wheels and on the engine to
keep the vehicle on the trajectory required by the
driver, within the limits of the laws of physics.
Anti-slip regulation (ASR)
and electronic stability
programme (ESP)

This is indicated by flashing
of this warning lamp in the
instrument panel.

Activation
These systems are activated automatically each time the vehicle is started.
They come into operation in the event of a grip
or trajectory problem.
The ESP/ASR systems offer exceptionalsafety in normal driving, but this should not encourage the driver to take extra risks or drive at high speed.
The correct operation of thesesystems depends on obser vation of the manufacturer's recommendations regarding wheels (tyres and rims), braking components, electroniccomponents and assembly and repair procedures.
After an impact, have these systems checked by a CITROËN dealer or a qualified workshop.
Have it checked b
y a CITROËN dealer or a qualified workshop.

8
Safety
117

Seat belt not fastened / unfastened warning lamp Fastenin
g
) Pull the strap, then inser t the tongue in thebuckle. )
Check that the seat belt is fastened correctly by pulling the strap.



Height adjustment
)
To lower the attachment point, squeeze the control A
and slide it downwards.)
To raise the attachment point, slide thecontrol A
upwards.
When the ignition is switched on, this warning lamp comes on, either on theinstrument panel or on the seat belt andpassenger's front airbag warning lamp
display, if the driver and/or the frontpassenger has not fastened their seat belt.
Unfastening
) Press the red button on the buckle. )
Guide the seat belt as it rolls up.


Seat belts


Front seat belts


The front seat belts are fitted with apretensioning and force limiting system.
This s
ystem improves safety in the frontseats in the event of a front or side impact.
Depending on the severity of the impact, thepretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The
force limiter reduces the pressure of the seat belt on the chest of the occupant, so
improving their protection.
From approximately 12 mph (20 km/h) this warninglamp flashes for two minutes accompanied by an audible signal. Once these two minutes have
elapsed, this warning lamp remains on until the driver and/or the front passenger fastens their seat belt.