2012.5 Citroen C3 PICASSO RHD tailgate

Access
74
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.











Boot
- when the engine is running
, this
warning lamp comes on, accompanied
by a message on the multifunction
screen for a few seconds,
Tailgate release

Unlocking
)Fold back the rear benchseat to gainaccess to the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate.




Closing

If the tailgate is not closed correctly:
Opening
-when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal anda message on the multifunction screen for a few seconds.

)
Lower the tailgate using the interior grab handle.
System for mechanical unlocking of the boot
in the event of a battery or central lockingmalfunction.

5
Visibility
87
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen wipers,
operate for a pre-determined time.
B
. Rear wiper selection ring:
park,
intermittent wi
pe,
wash-wipe
(set duration).
Reverse gear
When reverse gear is engaged, the rear wiper will operate if the windscreen wipers are
operating.
Programming
The function is activated or deactivated via themultifunction screen configuration menu.
This function is activated by default.
Rear wiper
Wiping zone

The cur ved shape of the rear screen results in
a smaller wiping zone.
If a significant accumulation of snow or ice is present, or when using a tailgate bicycle carrier, deactivate the automatic rear wiper via the multifunction screenconfiguration menu.

6
Fittings
101
Hooks
The hooks can be used to hold shopping bags.
2-panel rear parcel shelf
The rear section is attached to the tailgate bytwo cords.
Removing the shelf
From the boot: )
unhook the two cords,)
pull the shelf towards you to unclip it, )
lift the shelf to remove it.


Refi tting the shelf
From the boot:)
position the shelf so that the two notches
are directly above the fixing pins, ) push the shelf towards the inside of the
vehicle to clip it in place,
) attach the two cords.
It can be stored under the ad
justable boot floor,if this is in its high position.

Fittings
102
3-panel rear parcel shelf
The front section is flexible, and the central andrear sections are rigid. The rear section is secured to the tailgate by
two cords.
Removing the shelf
From the boot: )unhook the two cords, )gently lift up the shelf to unclip it, )remove the shelf.

Refi tting the shelf
From the boot:)
position the shelf so that the two notches
are directly above the fixing pins, ) press gently on the shelf to clip it in place, )
attach the two cords.


It can be stored under the ad
justable boot floor,
if this is in its high position.