Page 25 of 28
OVERVIEW
FEATURES/OPERATIONS
SAFETYANDEMERGENCYFEATURES
22
FEATURES/OPERATIONSSAFETY AND EMERGENCY FEATURES
Door locks
LockUnlock
Moving the lever to “LOCK” will allow the door to be opened only from
the outside.
Rear door
Doors Child safety locks
If belt is fully extended, then retracted even slightly,it cannot be
re extended beyond that point, unless fully retracted again. This feature
is used to help hold child restraint systems securely.
To find more information about seat belts, and how to install a child
restraint system, refer to the
Owner's Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Fuel filler door Internal release
(2) Pull up
(1) Remove
23
Power outlets
Instrument panel
“POWER” switch must be set at “ACC” or “ON” to be used.
Center console
Cup holders
Front
Rear
11_CamryHV_i.qxd 12/22/09 2:26 PM Page 22
Page 26 of 28
25
OVERVIEW
FEATURES/OPERATIONS
SAFETYANDEMERGENCYFEATURES
24
SAFETY AND EMERGENCY FEATURE
Push up, or
squeeze lock
release to lower
System reset initialization
1.Push and hold “ SET” button
until the indicator blinks three
times.
2. Wait a few minutes to allow
initialization to complete.
Seat belts Shoulder belt anchor
Rear seat outside position guides provide added comfort for children who
have outgrown child restraints.
Child comfort guide
Spare tire & tools
Tool location
Wheel nut wrench Jack handle
Transport eyelet
(if equipped)
Removing the spare tire
(1) Loosen and remove the nut.
(2) Remove the spare tire cover.
(3) Loosen and remove the bolt.
(4) Remove the jack tray.
Jack
Spare tire
Trunk Internal release
Pull up
(1)
(4)
(3)
(2)
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or
replaced, turn the POWER switch to “ON” mode, and press and hold the
Owner’sManualfor tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then
remains on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not
been initialized recently,setting the tire pressures to factory
specifications should turn off the light.
Refer to the Owner’s Manualfor
tire changing and jack
positioning procedures.
11_CamryHV_i.qxd 12/22/09 2:26 PM Page 24
Page 27 of 28
25
OVERVIEW
FEATURES/OPERATIONS
SAFETYANDEMERGENCYFEATURES
24
SAFETY AND EMERGENCY FEATURE
Push up, or
squeeze lock
release to lower
System reset initialization
1.Push and hold “ SET” button
until the indicator blinks three
times.
2. Wait a few minutes to allow
initialization to complete.
Seat belts Shoulder belt anchor
Rear seat outside position guides provide added comfort for children who
have outgrown child restraints.
Child comfort guide
Spare tire & tools
Tool location
Wheel nut wrench Jack handle
Transport eyelet
(if equipped)
Removing the spare tire
(1) Loosen and remove the nut.
(2) Remove the spare tire cover.
(3) Loosen and remove the bolt.
(4) Remove the jack tray.
Jack
Spare tire
Trunk Internal release
Pull up
(1)
(4)
(3)
(2)
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or
replaced, turn the POWER switch to “ON” mode, and press and hold the
Owner’sManualfor tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then
remains on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not
been initialized recently,setting the tire pressures to factory
specifications should turn off the light.
Refer to the Owner’s Manualfor
tire changing and jack
positioning procedures.
11_CamryHV_i.qxd 12/22/09 2:26 PM Page 24
Page 28 of 28
MN 00505 QRG11 CAMH
P
rinted in the USA 1/2010
11_CamryHV_i.qxd 12/22/09 2:26 PM Page 26
