2011 TOYOTA AURIS brake

444 5-2. Steps to take in an emergency
UK_AURIS_HV_EE
Once

(Flashes)• When the doors
were unlocked
with the
mechanical key
and then the
“POWER”
switch was
pressed, the
electronic key
could not be
detected in the
vehicle.
• The electronic
key could not be
detected in the
vehicle even
after the
“POWER”
switch was
pressed two
consecutive
times.Touch the elec-
tronic key to the
“POWER”
switch while
depressing the
brake pedal.
Interior
buzzerExterior
buzzerWarning messageDetailsCorrection
procedure

5
445 5-2. Steps to take in an emergency
When trouble arises
UK_AURIS_HV_EE
Once

(Flashes)The driver's
door was
opened and
closed with the
“POWER”
switch turned off
and then the
“POWER”
switch was put
in ACCES-
SORY mode
twice without
the hybrid sys-
tem being
started.Press the
“POWER”
switch while
depressing the
brake pedal.
During a hybrid
system starting
procedure in the
event that the
electronic key
was not func-
tioning properly
(P. 472), the
“POWER”
switch was
touched with
the electronic
key.Press the
“POWER”
switch within 10
seconds of the
buzzer sound-
ing.
Interior
buzzerExterior
buzzerWarning messageDetailsCorrection
procedure

5
447
5-2. Steps to take in an emergency
When trouble arises
UK_AURIS_HV_EE
If you have a flat tire (vehicles with a spare tire)
Remove the flat tire and replace it with the spare provided.
Before jacking up the vehicle
Stop the vehicle in a safe place on a hard, flat surface.
Set the parking brake.
Push the P position switch.
Stop the hybrid system.
Turn on the emergency flashers.
Location of the spare tire, jack and tools
Ty p e A
Tool bag
Jack
Spare tireJack spacer
Wrench

456 5-2. Steps to take in an emergency
UK_AURIS_HV_EE
CAUTION
When the spare tire is attached
The vehicle speed may not be correctly detected, and the following systems
may not operate correctly:
ABS & Brake assist
VSC
Navigation system (if equipped)
TRC
Cruise control (if equipped)
Rear view monitor system (if equipped)
NOTICE
Do not drive the vehicle with a flat tire.
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the
wheel beyond repair.
Tool storage precaution (while the compact spare tire is in use)
Do not stow anything but the soft jack spacer (type A) or toolbox (type B) in
the spare tire well. Hard, unsecured objects may damage nearby compo-
nents.
Be careful when driving over bumps with the compact spare tire
installed on the vehicle.
The vehicle becomes lower when driving with the compact spare tire com-
pared to when driving with standard tires. Be careful when driving over
uneven road surfaces.
Driving with tire chains and the compact spare tire
Do not fit tire chains to the compact spare tire.
Tire chains may damage the vehicle body and adversely affect driving per-
formance.

5
457
5-2. Steps to take in an emergency
When trouble arises
UK_AURIS_HV_EE
If you have a flat tire (vehicles with an emergency tire puncture repair kit)
A puncture caused by a nail or screw passing through the tire tread
can be repaired temporarily with the emergency tire puncture repair
kit.
Before repairing the vehicle
Stop the vehicle in a safe place on a hard, flat surface.
Set the parking brake.
Push the P position switch.
Stop the hybrid system.
Turn on the emergency flashers.
Location of the emergency tire puncture repair kit, jack and
tools
Ty p e A
*: Use of the jack (P. 449)
Tool bag
(if equipped) Jack*
(if equipped)Wrench
Emergency tire
puncture repair kit
Towing eyelet

470 5-2. Steps to take in an emergency
UK_AURIS_HV_EE
Emergency start function
When the hybrid system does not start, the following steps can be
used as an interim measure to start the hybrid system if the
“POWER” switch is functioning normally.
Set the parking brake.
Set the “POWER” switch to the ACCESSORY mode.
Push and hold the “POWER” switch for about 15 seconds
while depressing the brake pedal firmly.
Even if the hybrid system can be started using the above steps, the
system may be malfunctioning. Have the vehicle checked by any
authorized Toyota dealer or repairer, or another duty qualified and
equipped professional.
The interior lights and headlights do not turn on, or the horn
does not sound.
One of the following may be the cause of the problem.
One or both of the 12-volt battery terminals may be discon-
nected.
The 12-volt battery may be discharged. (P. 474)
Contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional, if the problem cannot be
repaired, or if repair procedures are unknown.
STEP1
STEP2
STEP3

472
5-2. Steps to take in an emergency
UK_AURIS_HV_EE
If the electronic key does not operate properly
Locking and unlocking the doors
Use the mechanical key (P. 42)
in order to perform the following
operations from the driver’s door:
Locks all doors
Unlocks all doors
With an alarm: An alarm will
sound if the alarm is set.
(P. 114)
Changing “POWER” switch modes and starting the hybrid system
Apply the brakes.
Touch the Toyota emblem side of
the electronic key to the
“POWER” switch.
An alarm will sound to indicate
that the start function cannot
detect the electronic key that is
touched to the “POWER” switch if
any of the doors is opened and
closed while the key is touched to
the switch.
If communication between the electronic key and vehicle is inter-
rupted (P. 48, 61) or the electronic key cannot be used because the
battery is depleted, the smart entry & start system, push button start
and wireless remote control cannot be used. In such cases, the
doors can be opened or the hybrid system can be started by follow-
ing the procedure below.
STEP1
STEP2

5
473 5-2. Steps to take in an emergency
When trouble arises
UK_AURIS_HV_EETo change “POWER” switch modes: Within 5 seconds of the
buzzer sounding, release the brake pedal and press the
“POWER” switch. Modes can be changed each time the
switch is pressed. (P. 174)
To start the hybrid system: Press the “POWER” switch within
5 seconds after the buzzer sounds, keeping the brake pedal
depressed.
In the event that the “POWER” switch still cannot be operated, con-
tact any authorized Toyota dealer or repairer, or another duly quali-
fied and equipped professional.
Stopping the hybrid system
Push the P position switch and press the “POWER” switch as you normally
do when stopping the hybrid system.
Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery depletes.
(P. 397)
Alarm (if equipped)
Using the mechanical key to lock the doors will not set the alarm system. If a
door is unlocked using the mechanical key when the alarm system is set, the
alarm may be triggered. (P. 114)
STEP3