CONTENTS
Steering lock - Starting 124Parking brake 125Hill start assist 126
Manual gearbox 127Gear shift indicator 128Automatic gearbox 129
Speed limiter 133Cruise control 136Parking sensors 139
Fuel tank 143Bonnet 145Petrol engines 146
Diesel engine 147Running out of fuel (Diesel) 148Checking levels 149
Checks 151
Temporary puncture repair kit 153Changing a wheel 160Changing a wiper blade 164
Energy economy mode 165Battery 166Changing a bulb 168Changing a fuse 175
Towing a vehicle 182Towing a trailer 184Cleaning and maintenance 186Accessories 187
6/DRIVING 124-141
7/CHECKS 142-152
8/PRACTICAL INFORMATION 153-188
ALPHABETICAL INDEX 261-265
VISUAL SEARCH 266-269
Petrol engines 189Weights (petrol) 190Diesel engine 191Weights (Diesel) 192Dimensions 193Identification markings 194
9/TECHNICAL DATA 189-194
Emergency or assistance 195Peugeot Connect Media 199Peugeot Connect Sound 243
10/AUDIO EQUIPMENT and TELEMATICS 195-260
FAMILIARISATION
MONITORING
The instrument panel has permanent back-
lighting for improved visibility in all situations,
both day and night.
- With the ignition on, the fuel gauge needle
should indicate the level of fuel remaining.
- With the engine running, its associated
low level warning lamp should switch off.
- With the ignition on, the oil level indicator
should display "OK" or "correct",
depending on version, for a few seconds.
If the levels are not correct, top up the levels
which are low.
INSTRUMENT PANEL
60
22
- With the ignition on, the orange and red
warning lamps come on.
- With the engine running, these warning
lamps should switch off.
If warning lamps remain on, refer to the page
concerned.
WARNING LAMPS
26 Illumination of the indicator lamp indicates
the status of the corresponding function.
A.
Emergency call in progress.
SWITCH PANEL
54 195
104
140
195
B.
Deactivating the interior volumetric and
anti-tilt sensors (alarm).
C.
Central locking.
D.
Deactivation of the ESP/ASR system.
E.
Deactivation of the front and rear parking
sensors.
F.
Access to PEUGEOT services.
mph70
CRUISE Pause
offmph70
SE
T/+LIM
IT
CRUISE 0 I
I
SE
T/
–
SE
T/+LIM
IT
CRUISE 0 I
I
SE
T/
–
18 The cruise control or speed limiter mode
appears on the instrument panel when it is
selected.
DISPLAY ON THE
INSTRUMENT PANEL
Cruise control
Speed limiter
DRIVING SAFELY
1.
Limiter mode Selection/Off.
2.
Decreasing of the programmed value.
3.
Increasing of the programmed value.
4.
Speed limiter On/Off.
The values must be set with the engine running.
SPEED LIMITER "LIMIT"
133
1.
Cruise control mode Selection/Off.
2.
Programming a speed/Decreasing of the
programmed value.
3.
Programming a speed/Increasing of the
programmed value.
4.
Cruise control Off/Resume.
CRUISE CONTROL "CRUISE"
In order to be programmed or activated, the
vehicle speed must be higher than 25 mph
(40 km/h), with at least fourth gear engaged
on the manual gearbox (second gear for the
automatic gearbox).
136
20
OPTIMISE THE USE OF YOUR
GEARBOX
With a manual gearbox, move off gently,
change up without waiting and drive by
changing up quite soon. If your vehicle has
the system, the gear shift indicator invites
you to change up; it is displayed in the
instrument panel, follow its instructions.
With an automatic or electronic gearbox,
stay in Drive "D"
or Auto "A"
, according to
the type of gearbox, without pressing the
accelerator pedal heavily or suddenly.
DRIVE SMOOTHLY
Maintain a safe distance between vehicles,
use engine braking rather than the
brake pedal, and press the accelerator
progressively. These attitudes contribute
towards a reduction in fuel consumption and
CO
2 emissions and also helps reduce the
background traffi c noise.
When the traffi c is fl owing well, and if you
have cruise control, make use of the system
at speeds above 25 mph (40 km/h).
CONTROL THE USE OF YOUR
ELECTRICAL EQUIPMENT
Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents before
using the air conditioning.
Above 30 mph (50 km/h), close the windows
and leave the air vents open.
Remember to make use of equipment that can
help keep the temperature in the passenger
compartment down (sun roof and window
blinds...).
Switch off the air conditioning, unless it has
automatic digital regulation, as soon as the
desired temperature is attained.
Switch off the demisting and defrosting
controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps
when the level of light does not require
their use.
Avoid running the engine before moving off,
particularly in winter; your vehicle will warm
up much faster while driving.
As a passenger, if you avoid connecting
your multimedia devices (fi lm, music, video
game...), you will contribute towards limiting
the consumption of electrical energy, and so
of fuel.
Disconnect your portable devices before
leaving the vehicle.
ECO-DRIVING
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
LIMIT THE CAUSES OF
EXCESS CONSUMPTION
Spread loads throughout the vehicle; place
the heaviest items in the bottom of the boot,
as close as possible to the rear seats.
Limit the loads carried in the vehicle and
reduce wind resistance (roof bars, roof rack,
bicycle carrier, trailer...). Use a roof box in
preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and
refi t your summer tyres.
OBSERVE THE RECOMMENDATIONS
ON MAINTENANCE
Check the tyre pressures regularly, when cold,
referring to the label in the door aperture,
driver's side.
Carry out this check in particular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the tyres
on any trailer or caravan.
Have your vehicle serviced regularly (engine
oil, oil fi lter, air fi lter...) and observe the
schedule of operations recommended by
the manufacturer.
When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid any
overfl ow.
At the wheel of your new vehicle, it is only
after the fi rst 1 800 miles (3 000 kilometres)
that you will see the fuel consumption settle
down to a consistent average.
0
CHECK/000
0.
5
1.5
2
.
54.5
12
6
7 5 4 3
tr/min
x1000
3.550 01/2
190
130
5.5mph
22
PETROL - DIESEL MANUAL
OR AUTOMATIC GEARBOX
IN
STRUMENT PANELS
DIALS
1.
Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).
2.
Coolant temperature.
Indicates the temperature of the engine coolant (° Celsius).
3.
Fuel level.
Indicates the quantity of fuel remaining in the tank.
4.
Vehicle speed.
Indicates the current speed of the moving vehicle (mph or km/h).
5.
Small display screen.
6.
Central display screen.
7.
Display management button.
Starts a manual CHECK.
Recalls the service information.
Resets the selected function to zero (trip distance recorder or
service indicator).
8.
Lighting rheostat button.
Adjusts the brightness of the lighting of the instruments and
controls.
With large central display screen
Panel. grouping together the vehicle operation indication dials and
warning lamps, with permanent back-lighting.
For more information, refer to the paragraph relating to the button
or function and its associated display.
With small central display screen
1/
offmph
mi.
l/100
55
500
10,2
12
D3
mph
miles
l/100
55
500 LIMIT Pause
10,2
4
INSTRUMENTS AND CONTROLS
DISPLAYS
*
According to engine.
**
Only on the large central display screen.
***
Only on the large central display screen with Peugeot Connect Media.
Small display screen
A.
Trip distance recorder.
(miles or km)
B.
Distance recorder.
(miles or km)
C.
Service spanner,
if a service is due shortly or is overdue.
Central display screen
D. Speed limiter
(mph or km/h) or
Cruise control.
E. Indication:
- of a gear change * (manual gearbox),
or
- of the programme or gear (automatic gearbox).
F. Engine oil level indicator,
service indicator.
(miles or km)
These two functions are displayed when the ignition is switched on,
then disappear after a few seconds.
Warning and status indicator
lamps
/ CHECK.
Tyre under-infl ation detection.
Trip computer.
Vehicle speed repeat ** .
Vehicle parameters ** .
Navigation - Guidance *** .
These six functions are displayed according to the selection.
mph26
WARNING AND INDICATOR LAMPS
Visual indicators which inform the driver of the occurrence of a
fault (warning lamp) or of the operation of a system (operation or
deactivation indicator lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is
switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the
warning lamp concerned.
Associated warnings
The illumination, fi xed or fl ashing, of certain warning lamps may be
accompanied by an audible signal and a message in the screen.
Depending on your version of instrument panel, illumination of the
warning lamp is also accompanied by:
- a pictogramme in the central instrument panel screen and a
message in the multi-function screen,
or
- a pictogramme and a message in the central instrument panel
screen.
Warning lamps
When the engine is running or the vehicle is being driven, the
illumination of one of the following warning lamps indicates a fault which
requires action on the part of the driver.
The illumination of a warning lamp is always accompanied by the
display of an additional message, to assist you in identifying the
fault.
If you encounter any problems, contact a PEUGEOT dealer or a
qualifi ed workshop.