Page 10 of 276
5090
13001/2
1
C
HEC
K/0
00
ON
OFFAIRBA
G
P
A
SS
8
INSTRUMENTS AND CONTROLS
1.
Wipers/screenwash/trip computer
control stalk.
2.
Steering lock and ignition.
3.
Audio and telematics system steering
wheel control stalk.
4.
Driver’s airbag.
Horn.
5.
Gear lever.
6.
Parking brake.
7.
Instrument panel.
8.
Speaker (tweeter).
9.
Side adjustable air vent.
10.
Passenger’s airbag deactivation switch.
11 .
Manual headlamp height adjustment.
Page 13 of 276
FAMILIARISATION
SITTING COMFORTABLY
FRONT SEATS
Forwards-backwards
Height
MANUAL ADJUSTMENTS
63
64
ELECTRIC ADJUSTMENTS
Seat back angle
Page 14 of 276
12
SITTING COMFORTABLY
FRONT SEATS
83
Other functions available...
Lumbar adjustment.
As a safety precaution, these
operations must only be carried out
when stationary. Heated seats. 65
65
STEERING WHEEL ADJUSTMENT
1.
Unlock the control.
2.
Adjust for height and reach.
3.
Lock the control.
67
FRONT ARMREST
For your comfort, the height and the
longitudinal position of the front armrest
can be adjusted.
It also offers a storage compartment. Storing of driving positions (driver's electric
seat).
66
Page 65 of 276
3/
EASE OF USE and COMFORT
FRONT SEATS
Seat with integral head restraint, consisting of a seat cushion and
a seat back which can be adjusted to adapt your position for ease
of driving and comfort.
MANUAL ADJUSTMENTS
Forwards-backwards adjustment
Driver's or passenger's seat height adjustment
Seat back angle adjustment
)
Raise the control bar and slide the seat forwards or backwards.
)
Pull the control lever upwards to raise or push it downwards to
lower, as many times as necessary, to obtain the position required.
)
Turn the knob to set the angle required.
Page 66 of 276
64
FRONT SEATS
Seat with integral head restraint, consisting of a seat cushion and
a seat back which can be adjusted to adapt your position for ease
of driving and comfort.
ELECTRIC ADJUSTMENTS
Forwards-backwards adjustment
Seat cushion height adjustment
)
Push the control forwards or rearwards to slide the seat.
)
Tilt the rear part of the control upwards or downwards to obtain
the required height.
The electrical functions of the seat are deactivated approximately
one minute after the ignition is switched off.
To reactivate them, switch on the ignition.
Seat back angle adjustment
)
Tilt the control forwards or rearwards to adjust the angle
of the seat back.
Page 69 of 276
3/
EASE OF USE and COMFORT
STEERING WHEEL ADJUSTMENT
)
When stationary
, pull the control lever to release the adjustment
mechanism.
)
Adjust the height and reach to suit your driving position.
)
Push the control lever to lock the adjustment mechanism.
As a safety precaution, these operations should only be carried
out while the vehicle is stationary.
Page 85 of 276
3/
EASE OF USE and COMFORT
FRONT ARMREST
Comfort and storage device for the driver and front passenger.
The height and length of the armrest cover can be adjusted.
)
Raise the cover to the required position (low, intermediate or high).
)
If you raise the cover slightly beyond the high position, guide it
when lowering it to the low position.
LONGITUDINAL ADJUSTMENT
)
Slide the cover fully forwards or rearwards.
STORAGE
)
Raise the lever.
)
Raise the cover fully.
HEIGHT ADJUSTMENT
Page 95 of 276
4/
ONO
FFA
IRB
A
G P
AS
S.
VISIBILITY
MANUAL ADJUSTMENT
OF HALOGEN HEADLAMPS
AUTOMATIC ADJUSTMENT
OF XENON HEADLAMPS
To avoid dazzling other road users, the height of the halogen bulb
headlamps must be adjusted according to the load in the vehicle.
0.
1 or 2 people in the front seats.
-. 3 people.
1.
4 people.
-. Intermediate setting.
2.
4 people + maximum authorised loads.
-. Intermediate setting.
3.
Driver + maximum authorised loads. In order to avoid causing a nuisance to other road users, this system
corrects the height of the xenon headlamp beams automatically and
when stationary, in relation to the load in the vehicle.
If a malfunction occurs, this warning lamp is displayed on
the instrument panel, accompanied by an audible signal and
a message in the screen.
The system then places your headlamps in the lowest position.
Initial setting is position "0". Do not touch the xenon headlamp bulbs.
Contact a PEUGEOT dealer or a qualifi ed workshop.
