2011 Peugeot RCZ Owner's Manual - RHD (UK, Australia)

7/
ESSENCE SANS PLOMB
UNLEADED FUEL ONLY
NUR BLEIFREI BENZIN
GASOLINA SIN PLOMO
RON 95/98
CHECKS
FUEL TANK

Fuel tank capacity: approximately 55 litres.



LOW FUEL LEVEL

FILLING

When the fuel tank minimum level is reached this warning
lamp comes on on the instrument panel, accompanied by an
audible signal and an alert message. When it fi rst comes on
there remains approximately 5 litres
of fuel in the tank.
Until suffi cient fuel is added, this warning lamp appears every time
the ignition is switched on, accompanied by an audible signal and a
message. When driving, this audible signal and display of the alert
message are repeated with increasing frequency as the fuel level drops
towards "0"
.
Refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer also to the "Running out of fuel
(Diesel)" section.
A label affi xed to the inside of the fl ap reminds you of the type of fuel to
be used depending on your engine.
Additions of fuel must be of at least 5 litres, in order to be taken into
account by the fuel gauge. To fi ll the tank in complete safety:


)
the engine must be switched off,


)
press the rear part of the fl ap, then raise it to open it,

)
turn the cap to the left,

)
remove the cap and hook it onto the clip located on the inside of
the fl ap,

)
fi ll the tank, but do not continue after the 3rd cut-off of
the pump
; this could cause malfunctions. Opening the fi ller cap may create a noise a caused by an inrush
of air. This vacuum is entirely normal, resulting from the sealing of
the fuel system.

144









QUALITY OF THE FUEL USED FOR PETROL
ENGINES

The petrol engines are perfectly compatible with E10 type petrol
biofuels (containing 10 % ethanol), conforming to European standards
EN 228 and EN 15376.
E85 type fuels (containing up to 85 % ethanol) are reserved exclusively
for vehicles marketed for the use of this type of fuel (BioFlex vehicles).
The quality of the ethanol must comply with European standard
EN 15293.
For Brazil only, special vehicles are marketed to run on fuels containing
up to 100 % ethanol (E100 type).














QUALITY OF THE FUEL USED FOR DIESEL
ENGINES

The Diesel engines are perfectly compatible with biofuels which
conform to current and future European standards (Diesel fuel which
complies with standard EN 590 mixed with a biofuel which complies
with standard EN 14214) available at the pumps (containing up to 7 %
Fatty Acid Methyl Ester).
The B30 biofuel can be used in certain Diesel engines; however, this
use is subject to strict application of the special servicing conditions.
Contact a PEUGEOT dealer or a qualifi ed workshop.
The use of any other type of (bio)fuel (vegetable or animal oils, pure
or diluted, domestic fuel...) is strictly prohibited (risk of damage to
the engine and fuel system).
When you have fi lled the tank:


)
put the cap back in place,

)
turn it to the right,

)
close the fl ap.


Freezing conditions

In these conditions, the fi ller fl ap may be jammed.
Opening the boot gives access to the fl ap, allowing it to be
released by hand.

7/
CHECKS
BONNET

OPENING



)
Open the front left door.

)
Pull the interior release lever A
, located at the bottom of the door
aperture.

CLOSING



)
Lower the bonnet and release it at the end of its travel.

)
Pull on the bonnet to check that it is fully latched.

)
Push the exterior safety catch B
to the left and raise the bonnet.
The bonnet is held open by the two side struts.
The location of the interior release lever prevents opening of
the bonnet while the front left door is closed.
When the engine is hot, handle the safety catch with care
(risk of burns).

146
PETROL ENGINES
The various caps and covers allow access for checking the levels of the various fl uids and for replacing certain components.


1.
Power steering reservoir.

2.
Screenwash and headlamp wash reservoir.

3.
Coolant reservoir.

4.
Brake fl uid reservoir.

5.
Battery/Fuses.
6.
Fusebox.

7.
Air fi lter.

8.
Engine oil dipstick.

9.
Engine oil fi ller cap.

7/
CHECKS
DIESEL ENGINE
The various caps and covers allow access for checking the levels of the various fl uids, for replacing certain components and for priming the fuel system.


1.
Power steering reservoir.

2.
Screenwash and headlamp wash reservoir.

3.
Coolant reservoir.

4.
Brake fl uid reservoir.

5.
Battery/Fuses.

6.
Fusebox.
7.
Air fi lter.

8.
Engine oil dipstick.

9.
Engine oil fi ller cap.

10.
Priming pump.

11 .
Bleed screw.

148
2 LITRE HDI ENGINE


)
Fill the fuel tank with at least fi ve litres of Diesel.

)
Open the bonnet.

)
Unclip the style cover for access to the priming pump.

)
Slacken the bleed screw.

)
Squeeze and release the priming pump repeatedly until fuel
appears in the transparent pipe with the green connector.

)
Retighten the bleed screw.

)
Operate the starter until the engine starts.

)
Put the style cover back in position and clip it in place.

)
Close the bonnet.

RUNNING OUT OF FUEL (DIESEL)

If the engine does not start fi rst time, don't keep trying.
Operate the priming pump again, then the starter motor. On vehicle fi tted with HDi engines, the fuel system must be primed if
you run out of fuel; refer to the engine compartment view on the "Diesel
engine" page.

7/
CHECKS
CHECKING LEVELS
Check all of these levels regularly and top them up if necessary, unless
otherwise indicated.
If a level drops signifi cantly, have the corresponding system checked by
a PEUGEOT dealer or a qualifi ed workshop.


OIL LEVEL

The check is carried out either when the ignition is switched
on using the oil level indicator on the instrument panel, or
using the dipstick.
This manual check will only be correct if the vehicle is on level ground
and the engine has been off for more than 30 minutes.
After topping up the oil, the check when switching on the ignition
with the oil level indicator in the instrument panel will only be valid
30 minutes after topping up.

It is normal to top up the oil level between services. PEUGEOT
recommends that you check the oil level and top up if necessary
every 3 000 miles (5 000 kilometres).


Engine oil change

Refer to the Warranty and Maintenance Record for details of the interval
for this operation.
In order to maintain the reliability of the engine and emission control
system, the use of additives in the engine oil is prohibited.


BRAKE FLUID LEVEL

The brake fl uid level should be close to the "MAX" mark. If it is
not, check the brake pad wear.

Changing the fluid

Refer to the Warranty and Maintenance Record for details of the interval
for this operation.


Fluid specification

The brake fl uid must conform to the manufacturer's recommendations
and meet the DOT4 standard.



POWER STEERING FLUID LEVEL

The power steering fl uid level should be close to the "MAX"
mark. Unscrew the cap, with the engine cold, to check the level.
When working under the bonnet, take care, as certain areas of the
engine may be extremely hot (risk of burns).


Oil specification

The oil must be the correct grade for your engine and conform to the
manufacturer's recommendations.

F0
150

COOLANT LEVEL

The coolant level should be close to the "MAX" mark but
should never exceed it.
When the engine is warm, the temperature of the coolant is regulated
by the fan. This can operate with the ignition off.

On vehicles which are fi tted with a particle emission fi lter, the
fan may operate after the vehicle has been switched off, even if
the engine is cold.

In addition, as the cooling system is pressurised, wait at least one hour
after switching off the engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap by two turns to allow the
pressure to drop. When the pressure has dropped, remove the cap and
top up the level.

Changing the coolant

The coolant does not have to be changed.


Fluid specification

The coolant must conform to the manufacturer's recommendations.



SCREENWASH AND HEADLAMP WASH FLUID

In the case of vehicles fi tted with headlamp washers, the low
fl uid level is indicated by an audible signal and a message in
the instrument panel screen.
Top up the reservoir when you stop the vehicle.


Fluid specification

For optimum cleaning and to avoid freezing, this fl uid must not be
topped up with or replaced with plain water.











ADDITIVE LEVEL (DIESEL WITH PARTICLE
EMISSIONS FILTER)
The additive reservoir low level is indicated by fi xed illumination
of this warning lamp, accompanied by an audible signal and a
message that the particle emissions fi lter additive level is too low.


Topping up

The reservoir must be topped up without delay by a PEUGEOT dealer
or a qualifi ed workshop.











USED PRODUCTS

Avoid prolonged contact of used oil or fl uids with the skin.
Most of these fl uids are harmful to health or indeed very corrosive.
Do not discard used oil or fl uids into sewers or onto the ground.
Take used oil to a PEUGEOT dealer or a qualifi ed workshop
(France) or to an authorised waste disposal site.