2011 Peugeot 508 stop start

8
199
Practical information
System which manages the duration of use of
certain functions to conser ve a sufficient level
of charge in the battery.
After the engine has stopped, you can still use
functions such as the audio and telematics
system, windscreen wipers, dipped beam
headlamps, courtesy lamps, etc. for a
maximum combined duration of thir ty minutes.








Energy economy mode


Switching to economy
mode
A message then appears in the instrument
panel screen indicating that the vehicle has
switched to economy mode and the active
functions are put on standby.
If a telephone call is being made at this time, it
will be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.


Exiting economy mode

These functions are reactivated automatically
next time the vehicle is driven.


)
In order to resume the use of these
functions immediately, star t the engine and
let it run:


- for less than ten minutes, to use the
equipment for approximately five
minutes,

- for more than ten minutes, to use the
equipment for up to approximately thir ty
minutes.

Let the engine run for the duration specified to
ensure that the battery charge is sufficient.
Do not repeatedly and continuously restart the
engine in order to charge the battery.
A flat battery prevents the engine from star ting
(refer to the "Battery" section).

208
!
Checks
Opening the bonnet


Opening



)
From inside
: pull the release lever,
located on the left below the dashboard,
towards you.





Before doing anything under the bonnet,
switch off the Stop & Star t system to
avoid any risk of injury resulting from an
automatic change to START mode.


Closing



)
Lower the bonnet and release it at the end
of its travel.

)
Check that it is latched correctly.


)
From the outside
: lift the safety catch and
raise the bonnet.
A bonnet strut opens the bonnet and holds it
open.

311



08 TRIP COMPUTER


Each press of the button, located on the steering
wheel, displays the different trip computer information
in succession, depending on the screen.


- the "vehicle " tab with:


●
the range, the current fuel consumption or the
Stop & Start time counter,

- the "1" tab (trip 1) with:


●
the average speed, the average fuel
consumption and the distance travelled
calculated over trip " 1
",

- the "2" tab (trip 2) with the same information for a
second trip.

Zero reset
When the required trip is displayed, press the control
for more than two seconds.


Range:
displays the distance which can travelled with the remaining fuel
detected in the tank, based on the average fuel consumption over the last
few miles (kilometres).
This displayed value may vary signifi cantly following a change in the
vehicle speed or the relief of the route.
When the range falls below 20 miles (30 km), dashes are displayed.
After fi lling with at least 5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (100 km).
If, whilst driving, dashes are displayed continuously in place of the digits,
contact a PEUGEOT dealer.

A FEW DEFINITIONS



Current fuel consumption:
only calculated and displayed above 20 mph (30 km/h).



Average fuel consumption:
this is the average fuel consumption since
the last trip computer zero reset.


Distance travelled:
calculated since the last trip computer zero reset.


Average speed:
this is the average speed calculated since the last trip
computer zero reset (ignition on).








Stop & Start time counter
(minutes/seconds or hours/minutes)
If your vehicle is fi tted with Stop & Start, a time counter calculates the
time spent in STOP mode during a journey.
It resets to zero every time the ignition is switched on with the key.

317
FREQUENTLY ASKED QUESTIONS



QUESTION



ANSWER



SOLUTION


A telephone connects
automatically,
disconnecting another
telephone. Automatic connection overrides manual connection. Modify the telephone settings to remove automatic
connection.
An IPod is not recognised
when connecting to the
USB port. The IPod is of a generation that is not compatible with the USB. Connect the IPod to the AUX Jack socket using a
suitable cable (not supplied).
The hard disk or device
is not recognised when
connecting to the USB
port. Some hard disks and devices need a power supply greater than is
provided by the audio system. Connect the device to the 230 V socket, the 12 V
socket or an external power supply.

Caution
: ensure that the device does not transmit
a voltage greater than 5 V (risk of destruction of
the system).
When streaming, the
sound cuts momentarily. Some telephones prioritise connection of the "hands-free" profi le. Delete the "hands-free" connection profi le to
improve streaming.
In "Random all" play,
not all of the tracks are
played. In "Random all" play, the system can only take into account up to
999 tracks.
With the engine off, the
audio system switches
off after a few minutes
of use. When the engine is switched off, the audio system operating time
depends on the battery charge.
The switch-off is normal: the audio system switches to economy mode
and switches off to prevent discharging the vehicle's battery. Start the vehicle's engine to increase the battery
charge.
The message "the audio
system is overheated"
appears on the display. In order to protect the installation if the surrounding temperature is too
high, the audio system switches to an automatic thermal protection mode
leading to a reduction of the volume or stopping of the playing of the CD. Switch the audio system off for a few minutes to
allow the system to cool.